SearcharxivSearch

arXiv · 1904.12650

Measured reduction in Alfv\'en wave energy propagating through longitudinal gradients scaled to match solar coronal holes

Abstract

We have explored the effectiveness of a longitudinal gradient in Alfv\'en speed in reducing the energy of propagating Alfv\'en waves under conditions scaled to match solar coronal holes. The experiments were conducted in the Large Plasma Device at the University of California, Los Angeles. Our results show that the energy of the transmitted Alfv\'en wave decreases as the inhomogeneity parameter, $\lambda/L_{\rm A}$, increases. Here, $\lambda$ is the wavelength of the Alfv\'en wave and $L_{\rm A}$ is the scale length of Alfv\'en speed gradient. For gradients similar to those in coronal holes, the waves are observed to lose a factor of $\approx 5$ more energy than they do when propagating through a uniform plasma without a gradient. We have carried out further experiments and analyses to constrain the cause of wave energy reduction in the gradient. The loss of Alfv\'en wave energy from mode coupling is unlikely, as we have not detected any other modes. Contrary to theoretical expectations, the reduction in the energy of the transmitted wave is not accompanied by a detectable reflected wave. Nonlinear effects are ruled out as the amplitude of the initial wave is too small and the wave frequency well below the ion cyclotron frequency. Since the total energy must be conserved, it is possible that the lost wave energy is being deposited in the plasma. Further studies are needed to explore where the energy is going.

Explore related subjects

Keep this discovery

BibTeXRIS

Sayak Bose, Troy Carter, Michael Hahn, Shreekrishna Tripathi, Stephen Vincena, Daniel Wolf Savin. 2019-04-26. Measured reduction in Alfv\'en wave energy propagating through longitudinal gradients scaled to match solar coronal holes. https://doi.org/10.3847/1538-4357/ab2fe0

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Particle-resolved pathways to energetic-ion formation in a fluctuating low-current hollow-cathode plume

Energetic-ion formation in a low-current hollow-cathode plume is investigated using experiments, self-consistent electrostatic particle-in-cell (PIC) simulation, and particle-resolved analysis. Retarding potential analyzer measurements show a substantial energetic-ion population over discharge currents of 0.8-3.5 A, while probe measurements reveal broadband plume fluctuations. Two-point phase-derived frequency-wavenumber measurements do not resolve a continuous ion-acoustic dispersion branch within the principal apparent-wavenumber interval. Because the inferred wavenumber is obtained from a cross-spectral phase defined modulo 2pi, the fluctuation diagnostics do not provide an unambiguous modal attribution for the energetic-ion population. A representative PIC plume, used as a qualitative kinetic reference, likewise develops broadband time-dependent electrostatic fluctuations together with a nonthermal energetic-ion population. Particle-resolved analysis shows that the energetic outflow is dominated by ions generated through ionization inside the plume, while source localization biases access to distinct trajectory and escape families. Matched field controls further show that time-averaged and frozen fields strongly suppress access to high-energy trajectories relative to the full time-dependent field over the analyzed interval. At the single-particle level, ion kinetic-energy gain is determined by electrostatic-field work accumulated along the actual trajectory, with different escape families exhibiting distinct radial and axial work contributions. These results establish a source-trajectory-field-work pathway for energetic-ion formation that can be identified without first assigning the fluctuating plume to a unique resolved plasma mode.

physics.plasm-ph

kobra: a new Vlasov code intended for plasma-wall modeling

In a fusion device plasma-wall interactions \edit{on the sheath scale} can be modeled as a collisionless problem. When modeling these regions particle-in-cell codes suffer from statistical error originating from undersampling the velocity space. On the other hand, Vlasov codes do not have this issue as they evolve the full distribution function. Here, we present a new finite-volume Vlasov code, kobra, equipped with adaptive-mesh refinement to reduce computational effort. Currently, the code solves the Vlasov-Poisson equations. We validate our code in 1d1v and 1d2v using established benchmarks, i.e. the two-stream instability, Landau damping, the Dory-Guest-Harris instability, and also a classical electrostatic plasma sheath. We find that the code reproduces the theoretical properties of these problems well. More importantly, the adaptive grid provides a computational gain that is likely to scale to higher dimensional, plasma-wall simulations.

physics.plasm-ph

Physics-Informed Neural Networks to Infer the Perpendicular Energy Conductivity in the Scrape-Off Layer of Stellarator Devices

In this work, we develop an inverse Physics-Informed Neural Network (PINN) framework to infer the dependence of the scrape-off layer (SOL) perpendicular heat conductivity on plasma density and temperature, $\kappa_\perp(n,T)$. The method combines radial profile measurements of electron density and temperature with the residual of a reduced one-dimensional SOL transport equation, so that the inferred conductivity is constrained by both the measurements and the underlying transport model. Three neural networks are trained simultaneously: two reconstruct the temperature and density profiles as functions of the radial coordinate and transported power, while a third represents the effective conductivity as a function of the local density and temperature. The framework is first validated using synthetic data generated from a prescribed conductivity function, allowing the inferred $\kappa_\perp(n,T)$ to be compared directly with the ground truth. The model recovers the imposed functional dependence with errors below $10~\%$ in the data-constrained region. Bootstrap resampling is shown to provide a practical indicator of prediction reliability and consistency. A scan in the number of plasma profiles used for training and the number of radial measurement positions per profile identifies a practical trade-off between reconstruction accuracy and data availability. Finally, the method is applied to an experimental dataset from the TJ-II stellarator obtained with the helium-beam diagnostic. This exploratory application provides an initial estimate of the effective SOL conductivity and illustrates the potential of inverse PINNs for extracting transport information from plasma edge measurements.

physics.plasm-ph