SearcharxivSearch

arXiv · 1909.06920

Hydrogenous content identification in heterogeneous cargoes via multiple monoenergetic neutron radiography

Abstract

The determination of hydrogenous content in commercial cargoes is an important challenge in cargo security. Prior work has shown the feasibility of hydrogenous cargo classification in radiographic applications. This result was achieved by using the significant material to material differences in the energy dependence of their neutron scattering cross-sections. The work presented here details the application of this technique to multiple-monoenergetic neutron transmission measurements of several heterogeneous cargo mock-ups with the goal of quantifying hydrogenous content. It demonstrates the ability to determine the hydrogenous content of a cargo container by performing analysis of pulse-height data of transmitted neutrons. The set-up used for these feasibility studies was able to detect and quantify areal densities of up to 30 g/cm$^2$ of high density polyethylene (HDPE), even when mixed with metallic materials. Accurate determination of the hydrogenous content of the cargo has two important uses: it can allow for better imaging and discrimination of conventional contraband during cargo screening; it may also allow the unfolding of the individual elemental contributions from an effective atomic number, $Z_{\mathrm{eff}}$, as determined from multiple monoenergetic gamma radiography (MMGR). This combination of capabilities could make multiple monoenergetic neutron radiography applications a significant contribution to cargo security.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Jill Rahon, Areg Danagoulian. 2019-09-16. Hydrogenous content identification in heterogeneous cargoes via multiple monoenergetic neutron radiography. https://doi.org/10.1016/j.nima.2019.162860

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det