SearcharxivSearch

arXiv · 2007.04985

Point-to-Point Stabilised Optical Frequency Transfer with Active Optics

Abstract

Timescale comparison between optical atomic clocks over ground-to-space and terrestrial free-space laser links will have enormous benefits for fundamental and applied science, from measurements of fundamental constants and searches for dark matter, to geophysics and environmental monitoring. However, turbulence in the atmosphere creates phase noise on the laser signal, greatly degrading the precision of the measurements, and also induces scintillation and beam wander which cause periodic deep fades and loss of signal. We demonstrate phase stabilized optical frequency transfer over a 265 m horizontal point-to-point free-space link between optical terminals with active tip-tilt mirrors to suppress beam wander, in a compact, human-portable set-up. A phase stabilized 715 m underground optical fiber link between the two terminals is used to measure the performance of the free-space link. The active optics terminals enabled continuous, coherent transmission over periods of up to an hour. We achieve an 80 dB suppression of atmospheric phase noise to $3\times10^{-6}$ rad$^{2}$Hz$^{-1}$ at 1 Hz, and an ultimate fractional frequency stability of $1.6\times10^{-19}$ after 40 s of integration. At high frequency this performance is limited by the residual atmospheric noise after compensation and the frequency noise of the laser seen through the unequal delays of the free space and fiber links. Our long term stability is limited by the thermal shielding of the phase stabilization system. We achieve residual instabilities below those of the best optical atomic clocks, ensuring clock-limited frequency comparison over turbulent free-space links.

Explore related subjects

Keep this discovery

BibTeXRIS

Benjamin P. Dix-Matthews, Sascha W. Schediwy, David R. Gozzard, Etienne Savalle, François-Xavier Esnault, Thomas Lévèque, Charles Gravestock, Darlene D'Mello, Skevos Karpathakis, Michael Tobar, Peter Wolf. 2020-07-09. Point-to-Point Stabilised Optical Frequency Transfer with Active Optics. https://doi.org/10.1038/s41467-020-20591-5

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det