SearcharxivSearch

arXiv · 2410.13033

Measurements of the Quantum Yield of Silicon using Geiger-mode Avalanching Photodetectors

Abstract

Accurate characterization of quantum yield is crucial to the reconstruction of energy depositions in silicon at the eV scale. This work presents a new method for experimentally calculating quantum yield using vacuum UV-sensitive silicon photomultipliers (SiPMs), which can be used to determine the probabilities that a UV photon absorbed in a silicon crystal will produce one, two, or three electron-hole pairs. Results are presented which fully constrain the distribution at photon energies up to 7.75eV. This method works by exploiting the saturation of photon detection efficiency which occurs when these devices are biased sufficiently high above their avalanche breakdown voltage. The measured quantum yield values are lower than those that have been previously reported by experimental data and modelling -- this is expected to impact the sensitivity of experiments searching for light dark matter through direct detection in semiconductors, and should also be taken into account when characterizing the performance of UV photodetectors with high quantum efficiency. Measurements have been taken using a Hamamatsu VUV4 and an FBK VUV-HD3 device, showing good agreements between devices, and at a range of temperatures from 163-233K. The validity of the method is assessed using supplementary measurements of absolute photon detection efficiency, and an additional novel method of measuring average quantum yield using DC current-voltage measurements of SiPMs is presented and used for corroboration.

Explore related subjects

Keep this discovery

BibTeXRIS

Harry Lewis, Mahsa Mahtab, Fabrice Retiere, Austin De St. Croix, Kurtis Raymond, Maia Henriksson-Ward, Nicholas Morrison, Aileen Zhang, Andrea Capra, Ryan Underwood. 2024-10-16. Measurements of the Quantum Yield of Silicon using Geiger-mode Avalanching Photodetectors. https://doi.org/10.1140/epjc/s10052-025-13883-x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det