Low-Temperature Synthesis of Weakly Confined Carbyne inside Single-Walled Carbon Nanotubes

Bo-Wen Zhang; Xi-Yang Qiu; Yicheng Ma; Qingmei Hu; Aina Fitó-Parera; Ikuma Kohata; Ya Feng; Yongjia Zheng; Chiyu Zhang; Yutaka Matsuo; YuHuang Wang; Shohei Chiashi; Keigo Otsuka; Rong Xiang; Dmitry I. Levshov; Sofie Cambré; Wim Wenseleers; Slava V. Rotkin; Shigeo Maruyama

arXiv · 2411.18899

Low-Temperature Synthesis of Weakly Confined Carbyne inside Single-Walled Carbon Nanotubes

Bo-Wen Zhang·Xi-Yang Qiu·Yicheng Ma·Qingmei Hu·Aina Fitó-Parera·Ikuma Kohata·Ya Feng·Yongjia Zheng·Chiyu Zhang·Yutaka Matsuo·YuHuang Wang·Shohei Chiashi·Keigo Otsuka·Rong Xiang·Dmitry I. Levshov·Sofie Cambré·Wim Wenseleers·Slava V. Rotkin·Shigeo Maruyama

View original source ↗Read source document ↗Export metadata ↓

Abstract

Carbyne, a one-dimensional (1D) carbon allotrope with alternating triple and single bonds, has the highest known mechanical strength but is unstable to bending, limiting synthesis to short linear chains. Encapsulation within carbon nanotubes (CNTs) stabilizes carbyne, forming confined carbyne (CC), thus enabling further research concerning attractive 1D physics and materials properties of carbyne. While CC has been synthesized in multi-walled CNTs (MWCNTs) using the arc-discharge method and in double-walled CNTs (DWCNTs) via high-temperature high-vacuum (HTHV) method, synthesis in single-walled CNTs (SWCNTs) has been challenging due to their fragility under such conditions. In this work, we report a low-temperature method to synthesize CC inside SWCNTs (CC@SWCNT). By annealing SWCNTs containing ammonium deoxycholate (ADC) at 400{\deg}C, ADC is converted into CC without damaging the SWCNTs. Raman spectroscopy revealed a strong CC phonon (CC-mode) peak at 1860-1870 cm^-1, much stronger than the SWCNT G-band peak, confirming a high fraction of CC in the resulting material. The Raman mapping result showed the uniformity of the CC-mode signal across the entire film sample, proving the high efficiency of this method in synthesizing CC in every SWCNT of appropriate size. Notably, the CC-mode peaks of CC@SWCNT (above 1860 cm^-1) are higher than those reported in previous CC@CNT samples (mostly less than 1856 cm^-1). This is attributed to larger SWCNT diameters (over 0.95 nm) used in this study, compared to the typical 0.6-0.8 nm range. Larger diameters result in reduced confinement, allowing carbyne to closely resemble free-standing carbyne while remaining stabilized. This low-temperature synthesis of long-chain, nearly free-standing carbyne within large-diameter SWCNTs offers new opportunities for exploring 1D physics and the unique properties of carbyne for potential applications.

Explore related subjects

physics.chem-ph

Keep this discovery

BibTeX RIS

Bo-Wen Zhang, Xi-Yang Qiu, Yicheng Ma, Qingmei Hu, Aina Fitó-Parera, Ikuma Kohata, Ya Feng, Yongjia Zheng, Chiyu Zhang, Yutaka Matsuo, YuHuang Wang, Shohei Chiashi, Keigo Otsuka, Rong Xiang, Dmitry I. Levshov, Sofie Cambré, Wim Wenseleers, Slava V. Rotkin, Shigeo Maruyama. 2024-11-28. Low-Temperature Synthesis of Weakly Confined Carbyne inside Single-Walled Carbon Nanotubes. https://arxiv.org/abs/2411.18899

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

Breaking Water at Graphene Defects

Water dissociation at solid surfaces underpins processes ranging from corrosion and catalysis to electrochemistry and photovoltaics. Defects often serve as reactive sites for dissociation, yet how solvation influences water dissociation at such sites remains poorly understood. Here, we use state-of-the-art machine-learned interatomic potentials to explore water dissociation at defective graphene-water interfaces. We show that solvation qualitatively changes the reaction mechanism at a graphene single vacancy (SV), opening pathways that are absent for an isolated water molecule. Whereas the gas-phase process proceeds via a single concerted channel, the solvated SV splits water through two competing pathways: a basic route forming SV-H and OH-(aq), and an acidic route forming SV-OH and H3O+(aq). These lower-barrier pathways produce distinct chemisorbed intermediates that enhance graphene-water adsorption. Accordingly, even a simple carbon vacancy gives rise to unexpectedly rich interfacial chemistry, coupling surface chemistry to interfacial charge and wettability, with implications for carbon functionalization and nanofluidic transport.

physics.chem-ph↗

arXiv2026

Comprehensive Study of L-Menthol and Octanoic Acid as a Hydrophobic Eutectic Solvent

Hydrophobic eutectic solvents (HES) based on natural compounds represent promising green alternatives to conventional solvents. In this work, we investigate the physicochemical, structural, and dynamical properties of an ES formed by L-menthol and octanoic acid using a combined experimental and molecular dynamics simulation approach. Five compositions with molar ratios from 1:3 to 3:1 were studied with molecular dynamics simulation in the temperature range 15 degrees C to 35 degrees C. Experimental measurements of density and viscosity in the temperature range from 5 degrees C to 35 degrees C were complemented with results obtained from MD simulations employing the OPLS force field. Structural analyses based on radial distribution functions and Kirkwood-Buff integrals reveal that the dominant interactions in the mixture are hydrogen bonds between L-menthol and octanoic acid molecules. Dynamic properties, including self-diffusion coefficients and hydrogen-bond lifetimes, indicate that intermolecular hydrogen bonds between the two components are stronger and longer-lived than bonds between identical species. These findings provide molecular-level insight into the structure and transport properties of menthol-based ESs relevant for green solvent applications.

physics.chem-ph↗

arXiv2026

More is not always better: Dissociative photoionization limits the EUV absorbing photacid generator pentafluorophenyl triflate in photolithography

Pentafluorophenyl triflate has been explored as a highly absorbing neutral photoacid generator (PAG) candidate for next generation chemically amplified resists used in extreme ultraviolet (EUV) lithography. Although increased fluorination enhances EUV absorption, this study demonstrates that such an approach does not necessarily improve photoacid generation efficiency. Using photoelectron-photoion coincidence (PEPICO) spectroscopy at the 92 eV photon energy of the EUV scanners in combination with quantum chemical calculations, the dissociative photoionization of pentafluorophenyl triflate was systematically investigated. The photoionization mass spectrum reveals extensive fragmentation, with the parent ion contributing only 3.1 % of the total signal and CF$_3^+$ representing the dominant product ion. Computed appearance energies align well with experimental trends and support a sequential fragmentation pathway involving loss of SO$_2$, CF$_3$, and CO. Crucially, none of the major dissociation channels yield precursors capable of forming triflic acid, the strong photoacid required for efficient deprotection reactions in chemically amplified resists. Combined with previous dissociative electron attachment studies indicating similarly unfavorable fragmentation, the results demonstrate that despite its high EUV absorption cross section, pentafluorophenyl triflate is unsuitable as a PAG for EUV lithography. The findings highlight the importance of understanding fundamental photoionization and electron interaction mechanisms to guide the rational design of next generation high performance EUV photoresists.

physics.chem-ph↗