SearcharxivSearch

arXiv subjects

A. Mavalankar

Publications and source records attributed to A. Mavalankar.

4 recordsLinked to original sources

Radio-frequency reflectometry of a quantum dot using an ultra-low-noise SQUID amplifier

Fault-tolerant spin-based quantum computers will require fast and accurate qubit readout. This can be achieved using radio-frequency reflectometry given sufficient sensitivity to the change in quantum capacitance associated with the qubit states. Here, we demonstrate a 23-fold improvement in capacitance sensitivity by supplementing a cryogenic semiconductor amplifier with a SQUID preamplifier. The SQUID amplifier operates at a frequency near 200 MHz and achieves a noise temperature below 600 mK when integrated into a reflectometry circuit, which is within a factor 120 of the quantum limit. It enables a record sensitivity to capacitance of 0.07 aF/\sqrt{Hz}. The setup is used to acquire charge stability diagrams of a gate-defined double quantum dot in a short time with a signal-to-noise ration of about 38 in 1 microsecond of integration time.

quant-ph

Hyperfine and spin-orbit coupling effects on decay of spin-valley states in a carbon nanotube

The decay of spin-valley states is studied in a suspended carbon nanotube double quantum dot via leakage current in Pauli blockade and via dephasing and decoherence of a qubit. From the magnetic field dependence of the leakage current, hyperfine and spin-orbit contributions to relaxation from blocked to unblocked states are identified and explained quantitatively by means of a simple model. The observed qubit dephasing rate is consistent with the hyperfine coupling strength extracted from this model and inconsistent with dephasing from charge noise. However, the qubit coherence time, although longer than previously achieved, is probably still limited by charge noise in the device.

cond-mat.mes-hall

Sensitive radio-frequency measurements of a quantum dot by tuning to perfect impedance matching

Electrical readout of spin qubits requires fast and sensitive measurements, but these are hindered by poor impedance matching to the device. We demonstrate perfect impedance matching in a radio-frequency readout circuit, realized by incorporating voltage-tunable varactors to cancel out parasitic capacitances. In the optimized setup, a capacitance sensitivity of $1.6~\mathrm{aF}/\sqrt{\mathrm{Hz}}$ is achieved at a maximum source-drain bias of $170~μ$V root-mean-square and with bandwidth above $15~$MHz. Coulomb blockade is measured via both conductance and capacitance in a quantum dot, and the two contributions are found to be proportional, as expected from a quasistatic tunneling model. We benchmark our results against the requirements for single-shot qubit readout using quantum capacitance, a goal that has so far been elusive.

cond-mat.mes-hall

A non-invasive electron thermometer based on charge sensing of a quantum dot

We present a thermometry scheme to extract the temperature of a 2DEG by monitoring the charge occupation of a weakly tunnel-coupled 'thermometer' quantum dot using a quantum point contact detector. Electronic temperatures between 97 mK and 307 mK are measured by this method with an accuracy of up to 3 mK, and agree with those obtained by measuring transport through a quantum dot. The thermometer does not pass a current through the 2DEG, and can be incorporated as an add-on to measure the temperature simultaneously with another operating device. Further, the tuning is independent of temperature.

cond-mat.mes-hall