arXiv subjects

Abdel Rebii

Publications and source records attributed to Abdel Rebii.

5 recordsLinked to original sources

arXiv2025

The High Voltage Splitter board for the JUNO SPMT system

The Jiangmen Underground Neutrino Observatory (JUNO) in southern China is designed to study neutrinos from nuclear reactors and natural sources to address fundamental questions in neutrino physics. Achieving its goals requires continuous operation over a 20-year period. The small photomultiplier tube (small PMT or SPMT) system is a subsystem within the experiment composed of 25600 3-inch PMTs and their associated readout electronics. The High Voltage Splitter (HVS) is the first board on the readout chain of the SPMT system and services the PMTs by providing high voltage for biasing and by decoupling the generated physics signal from the high-voltage bias for readout, which is then fed to the front-end board. The necessity to handle high voltage, manage a large channel count, and operate stably for 20 years imposes significant constraints on the physical design of the HVS. This paper serves as a comprehensive documentation of the HVS board: its role in the SPMT readout system, the challenges in its design, performance and reliability metrics, and the methods employed for production and quality control.

physics.ins-det↗

arXiv2024

Experimental validation of the Gaseous Proton Recoil Telescope for quasi-absolute neutron flux measurements

The accuracy of neutronics simulations of actual or future reactor cores is nowadays driven by the precision of the nuclear data used as input. Among the most important neutron-induced fission cross sections to understand well are the actinides. It is, indeed, of primary importance to know accurately these cross sections around 1 MeV for the safety of Generation IV reactors. High accuracy measurements of neutron flux are essential for accurate cross section measurements; measurements of this flux with respect to the 1 H(n,n)p cross section can be made with the proton recoil technique. For an accurate measurement below 1 MeV, the Gaseous Proton Recoil Telescope (GPRT) is developed and characterized, with the aim to provide quasi-absolute neutron flux measurements with an accuracy better than 2%. This detector is composed of a double ionization chamber with a Micromegas segmented detection plane. The pressure of the gas can be adjusted to protons stopping range -and therefore to neutrons energy. An accurate neutron flux measurement requires that the GPRT has an intrinsic efficiency of 100%, and thus an important effort has been made to verify this. An alpha source and proton micro-beam have been used and the intrinsic efficiency is confirmed to be 100%. Additionally, the dead-time of the detector has been investigated on a test bench, and is found to be 7.3 ms.

physics.ins-det↗

arXiv2022

Calibration Strategy of the JUNO-TAO Experiment

The Taishan Antineutrino Observatory (JUNO-TAO, or TAO) is a satellite detector for the Jiangmen Underground Neutrino Observatory (JUNO). Located near the Taishan reactor, TAO independently measures the reactor's antineutrino energy spectrum with unprecedented energy resolution. To achieve this goal, energy response must be well calibrated. Using the Automated Calibration Unit (ACU) and the Cable Loop System (CLS) of TAO, multiple radioactive sources are deployed to various positions in the detector to perform a precise calibration of energy response. The non-linear energy response can be controlled within 0.6% with different energy points of these radioactive sources. It can be further improved by using $^{12}\rm B$ decay signals produced by cosmic muons. Through the energy non-uniformity calibration, residual non-uniformity is less than 0.2%. The energy resolution degradation and energy bias caused by the residual non-uniformity can be controlled within 0.05% and 0.3%, respectively. In addition, the stability of other detector parameters, such as the gain of each silicon photo-multiplier, can be monitored with a special ultraviolet LED calibration system.

physics.ins-det↗

arXiv2021

CATIROC: an integrated chip for neutrino experiments using photomultiplier tubes

An ASIC named CATIROC (Charge And Time Integrated Read Out Chip) has been developed for the next-generation neutrino experiments using a large number of photomultiplier tubes (PMTs). Each CATIROC provides the time and the charge measurements for 16 configurable input channels operating in trigger-less mode. Originally designed for the light emission in water Cherenkov detectors, we show in this paper that its use can be extended to liquid-scintillator based experiments. The $\sim$26000 3-inch PMTs of the JUNO experiment, under construction in China, is a case in point. This paper describes the features of CATIROC with a special attention to the most critical points for its application to the time profile of the light emission in liquid scintillators. The achieved performances in both charge and time measurements can be inputs for future high-precision experiments making use of PMTs or other photo-sensitive detectors.

physics.ins-det↗

arXiv2021

Mass production and characterization of 3-inch PMTs for the JUNO experiment

26,000 3-inch photomultiplier tubes (PMTs) have been produced for Jiangmen Underground Neutrino Observatory (JUNO) by the Hainan Zhanchuang Photonics Technology Co., Ltd (HZC) company in China and passed all acceptance tests with only 15 tubes rejected. The mass production began in 2018 and elapsed for about 2 years at a rate of $\sim$1,000~PMTs per month. The characterization of the PMTs was performed in the factory concurrently with production as a joint effort between HZC and JUNO. Fifteen performance parameters were tracked at different sampling rates, and novel working strategies were implemented to improve quality assurance. This constitutes the largest sample of 3-inch PMTs ever produced and studied in detail to date.

physics.ins-det↗