arXiv subjects

Ananth Saran Yalamarthy

Publications and source records attributed to Ananth Saran Yalamarthy.

8 recordsLinked to original sources

arXiv2019

Significant Phonon Drag Enables High Power Factor in the AlGaN/GaN Two-Dimensional Electron Gas

In typical thermoelectric energy harvesters and sensors, the Seebeck effect is caused by diffusion of electrons or holes in a temperature gradient. However, the Seebeck effect can also have a phonon drag component, due to momentum exchange between charge carriers and lattice phonons, which is more difficult to quantify. Here, we present the first study of phonon drag in the AlGaN/GaN two-dimensional electron gas (2DEG). We find that phonon drag does not contribute significantly to the thermoelectric behavior of devices with ~100 nm GaN thickness, which suppress the phonon mean free path. However, when the thickness is increased to ~1.2 $μ$m, up to 32% (88%) of the Seebeck coefficient at 300 K (50 K) can be attributed to the drag component. In turn, the phonon drag enables state-of-the-art thermoelectric power factor in the thicker GaN film, up to ~40 mW m$^{-1}$ K$^{-2}$ at 50 K. By measuring the thermal conductivity of these AlGaN/GaN films, we show that the magnitude of the phonon drag can increase even when the thermal conductivity decreases. Decoupling of thermal conductivity and Seebeck coefficient could enable important advancements in thermoelectric power conversion with devices based on 2DEGs.

cond-mat.mtrl-sci↗

arXiv2019

Stable Operation of AlGaN/GaN HEMTs at 400$^\circ$C in air for 25 hours

In this letter, we report the operation of AlGaN/GaN HEMTs with Pd gates in air over a wide temperature range from 22$^\circ$C to 500$^\circ$C. The variation in the threshold voltage ($V_{th}$) is less than 1$\%$ over the entire temperature range. Moreover, a safe biasing region where the transconductance peak ($g_m$) occurs over the entire temperature range was observed, enabling high-temperature analog circuit design. Furthermore, the operation of the devices over 25 hours was experimentally studied, demonstrating the stability of the DC characteristics and $V_{th}$ at 400$^\circ$C. Finally, the degradation mechanisms of HEMTs at 500$^\circ$C over 25 hours of operation are discussed, and are shown to be associated with the 2DEG sheet density and mobility decrease.

physics.app-ph↗

arXiv2019

Gallium Nitride Photodetector Measurements of UV Emission from a Gaseous CH4/O2 Hybrid Rocket Igniter Plume

Owing to its wide (3.4 eV) and direct-tunable band gap, gallium nitride (GaN) is an excellent material platform for UV photodetectors. GaN is also stable in radiation-rich and high-temperature environments, which makes photodetectors fabricated using this material useful for in-situ flame detection and combustion monitoring. In this paper, we use a GaN photodetector to measure ultraviolet (UV) emissions from a hybrid rocket motor igniter plume. The normalized photocurrent-to-dark current ratio (NPDR) is a performance metric which simultaneously captures the two desired characteristics of high responsivity and low dark current. The NPDR of our device is record-high with a value of 6 x 10$^{14}$ W$^{-1}$ and the UV-to-visible rejection ratio is 4 x 10$^6$. The photodetector shows operation at high temperatures (up to 250°C), with the NPDR still remaining above 10$^9$ W$^{-1}$ and the peak wavelength shifting from 362 nm to 375 nm. The photodetector was placed at three radial distances (3", 5.5", and 7") from the base of the igniter plume and the oxidizer-to-fuel ratio (O2/CH4) was varied. The data demonstrates a clear trend of increasing current (and thus intensity of plume emission) with increasing fuel concentration and decreasing separation between the photodetector and the plume. By treating the plume as a black body, and calculating a radiative configuration factor corresponding to the geometry of the plume and the detector, we calculated average plume temperatures at each of the three oxidizer-to-fuel ratios. The estimated plume temperatures were between 850 and 950 K for all three combustion conditions. The temperature is roughly invariant for a fixed fuel concentration for the three tested distances. These data demonstrate the functionality of GaN as a material platform for use in harsh environment flame monitoring.

physics.ins-det↗

arXiv2018

Micro-Tesla Offset in Thermally Stable AlGaN/GaN 2DEG Hall-effect Plates using Current Spinning

This letter describes the characterization of a low-offset Hall-effect plate using the AlGaN/GaN two-dimensional electron gas(2DEG). Four-phase current spinning was used to reduce sensor offset voltage to values in the range of 20 nV, which corresponds to a low residual offset of 2.6 micro-Tesla when supplied with low voltages (0.04 to 0.5V). These offsets are 50x smaller than the values previously reported for GaN Hall-effect plates, and it is on par with state-of-the-art silicon Hall-effect plates. In addition, the offset does not exceed 10 micro-Tesla even at higher supply voltage of 2.34V. The sensor also shows stable current-scaled sensitivity over a wide temperature range of -100C to 200C, with temperature drift of -125 ppm/C. This value is 3x better than state-of-the-art Silicon Hall-effect plates. Additionally, the sensor's voltage sensitivity (57 mV/V/T) is also similar. Because of their low offset values, AlGaN/GaN Hall-effect plates are viable candidates for low-field and high temperature magnetic sensing in monolithic GaN systems used in extreme temperature environments such as power inverter, down-well, combustion, and space applications.

physics.app-ph↗

arXiv2018

Effect of Geometry on Sensitivity and Offset of AlGaN/GaN and InAlN/GaN Hall-effect Sensors

The current- and voltage-scaled sensitivities and signal-to-noise ratios (SNR) (with respect to thermal noise) of various octagonal AlGaN/GaN and InAlN/GaN Hall-effect sensors were examined in this work. The effect of metal contact lengths on sensitivity and sensor offset was evaluated. Calculations that take into account the shape of the device show that devices with point-like contacts have the highest current-scaled sensitivity (68.9 V/A/T), while devices with contacts of equal length to their non-contact sides have the highest voltage-scaled sensitivity (86.9 mV/V/T). The sensitivities of the two other devices follow the predicted trends closely. All the devices have offsets less than 20 $μ$T at low supply current operation (< 300 $μ$A) and most remain below 35 $μ$T at higher supply current (up to 1.2 mA). The consistent low offsets across the devices imply that the choice of Hall-effect sensor geometry should mainly depend on whether the device is current-biased or voltage-biased and the frequency at which it will operate. This work demonstrates that GaN Hall-effect sensor performance can be improved by adjusting the geometry of the Hall-effect plate specific to its function (e.g., power electronics, navigation, automotive applications).

physics.ins-det↗

arXiv2018

High responsivity, low dark current ultraviolet photodetector based on AlGaN/GaN interdigitated transducer

An ultraviolet (UV) photodetector employing the two-dimensional electron gas (2DEG) formed at the AlGaN/GaN interface as an interdigitated transducer (IDT) is characterized under optical stimulus. The 2DEG-IDT photodetector exhibits a record high normalized photocurrent-to-dark current ratio (NPDR, $6\times10^{14}$). In addition, we observe a high responsivity ($7,800$ A/W) and ultraviolet-visible rejection-ratio ($10^{6}$), among the highest reported values for any GaN photodetector architecture. We propose a gain mechanism to explain the high responsivity of this device architecture, which corresponds to an internal gain of $26,000$. We argue that the valence band offset in the AlGaN/GaN heterostructure is essential in achieving this high responsivity, allowing for large gains without necessitating the presence of trap states, in contrast to common metal-semiconductor-metal (MSM) photodetector architectures. Our proposed gain mechanism is consistent with measurements of the scaling of gain with device channel width and incident power. In addition to high performance, this photodetector architecture has a simple two-step fabrication flow that is monolithically compatible with AlGaN/GaN high electron mobility transistor (HEMT) processing. This unique combination of low dark current, high responsivity and compatibility with HEMT processing is attractive for a variety of UV sensing applications.

physics.app-ph↗

arXiv2018

Tuning Electrical and Thermal Transport in AlGaN/GaN Heterostructures via Buffer Layer Engineering

Over the last decade, progress in wide bandgap, III-V materials systems based on gallium nitride (GaN) has been a major driver in the realization of high power and high frequency electronic devices. Since the highly conductive, two-dimensional electron gas (2DEG) at the AlGaN/GaN interface is based on built-in polarization fields (not doping) and is confined to very small thicknesses, its charge carriers exhibit much higher mobilities in comparison to their doped counterparts. In this study, we show that this heterostructured material also offers the unique ability to manipulate electrical transport separately from thermal transport through the examination of fully-suspended AlGaN/GaN diaphragms of varied GaN buffer layer thicknesses. Notably, we show that ~$100$ nm thin GaN layers can considerably impede heat flow without electrical transport degradation, and that a significant improvement (~$4$x) in the thermoelectric figure of merit ($\it zT$) over externally doped GaN is observed in 2DEG based heterostructures. We also observe state-of-the art thermoelectric power factors ($4-7\times$ $10^{-3}$$\,Wm^{-1}K^{-2}$) at room temperature) in the 2DEG of this material system. This remarkable tuning behavior and thermoelectric enhancement, elucidated here for the first time in a polarization-based heterostructure, is achieved since the electrons are at the heterostructured interface, while the phonons are within the material system. These results highlight the potential for using the 2DEG in III-V materials for on-chip thermal sensing and energy harvesting.

cond-mat.mtrl-sci↗

arXiv2014

A Nano-satellite Mission to Study Charged Particle Precipitation from the Van Allen Radiation Belts caused due to Seismo-Electromagnetic Emissions

In the past decade, several attempts have been made to study the effects of seismo-electromagnetic emissions - an earthquake precursor, on the ionosphere and the radiation belts. The IIT Madras nano-satellite (IITMSAT) mission is designed to make sensitive measurements of charged particle fluxes in a Low Earth Orbit to study the nature of charged particle precipitation from the Van Allen radiation belts caused due to such emissions. With the Space-based Proton Electron Energy Detector on-board a single nano-satellite, the mission will attempt to gather statistically significant data to verify possible correlations with seismo-electromagnetic emissions before major earthquakes.

astro-ph.IM↗