Searcharxiv⌕ Search

arXiv subjects

Andrew N. Jordan

Publications and source records attributed to Andrew N. Jordan.

At least 145 records · Page 8Linked to original sources
arXiv2013

Powerful energy harvester based on resonant-tunneling quantum wells

We analyze a heat engine based on a hot cavity connected via quantum wells to electronic reservoirs. We discuss the output power as well as the efficiency both in the linear and nonlinear regime. We find that the device delivers a large power of about 0.18 W/cm^2 for a temperature difference of 1 K nearly doubling the power than can be extracted from a similar heat engine based on quantum dots. At the same time, the heat engine also has a good efficiency although reduced from the quantum dot case. Due to the large level spacings that can be achieved in quantum wells, our proposal opens the route towards room-temperature applications of nanoscale heat engines.

cond-mat.mes-hall↗
arXiv2013

Technical advantages for weak value amplification: When less is more

The technical merits of weak value amplification techniques are analyzed. We consider models of several different types of technical noise in an optical context and show that weak value amplification techniques (which only use a small fraction of the photons) compare favorably with standard techniques (which uses all of them). Using the Fisher information metric, we demonstrate that weak value techniques can put all of the Fisher information about the detected parameter into a small portion of the events and show how this fact alone gives technical advantages. We go on to consider a time correlated noise model, and find that a Fisher information analysis indicates that while the standard method can have much larger information about the detected parameter than the postselected technique. However, the estimator needed to gather the information is technically difficult to implement, showing that the inefficient (but practical) signal-to-noise estimation of the parameter is usually superior. We also describe other technical advantages unique to imaginary weak value amplification techniques, focusing on beam deflection measurements. In this case, we discuss combined noise types (such as detector transverse jitter, angular beam jitter before the interferometer and turbulence) for which the interferometric weak value technique gives higher Fisher information over conventional methods. We go on to calculate the Fisher information of the recently proposed photon recycling scheme for beam deflection measurements, and show it further boosts the Fisher information by the inverse postselection probability relative to the standard measurement case.

physics.optics↗
arXiv2013

Strengthening weak value amplification with recycled photons

We consider the use of cyclic weak measurements to improve the sensitivity of weak-value amplification precision measurement schemes. Previous weak-value experiments have used only a small fraction of events, while discarding the rest through the process of "post-selection". We extend this idea by considering recycling of events which are typically unused in a weak measurement. Here we treat a sequence of polarized laser pulses effectively trapped inside an interferometer using a Pockels cell and polarization optics. In principle, all photons can be post-selected, which will improve the measurement sensitivity. We first provide a qualitative argument for the expected improvements from recycling photons, followed by the exact result for the recycling of collimated beam pulses, and numerical calculations for diverging beams. We show that beam degradation effects can be mitigated via profile flipping or Zeno reshaping. The main advantage of such a recycling scheme is an effective power increase, while maintaining an amplified deflection.

physics.optics↗
arXiv2013

Quantum instruments as a foundation for both states and observables

We demonstrate that quantum instruments can provide a unified operational foundation for quantum theory. Since these instruments directly correspond to laboratory devices, this foundation provides an alternate, more experimentally grounded, perspective from which to understand the elements of the traditional approach. We first show that in principle all measurable probabilities and correlations can be expressed entirely in terms of quantum instruments without the need for conventional quantum states or observables. We then show how these states and observables reappear as derived quantities by conditioning joint detection probabilities on the first or last measurement in a sequence as a preparation or a post-selection. Both predictive and retrodictive versions of states and observables appear in this manner, as well as more exotic bidirectional and interdictive states and observables that cannot be easily expressed using the traditional approach. We also revisit the conceptual meaning of the Heisenberg and Schrödinger pictures of time evolution as applied to the various derived quantities, illustrate how detector loss can be included naturally, and discuss how the instrumental approach fully generalizes the time-symmetric two-vector approach of Aharonov \emph{et al.} to any realistic laboratory situation.

quant-ph↗
arXiv2013

Powerful and efficient energy harvester with resonant-tunneling quantum dots

We propose a nanoscale heat engine that utilizes the physics of resonant tunneling in quantum dots in order to transfer electrons only at specific energies. The nanoengine converts heat into electrical current in a multiterminal geometry which permits one to separate current and heat flows. By putting two quantum dots in series with a hot cavity, electrons that enter one lead are forced to gain a prescribed energy in order to exit the opposite lead, transporting a single electron charge. This condition yields an ideally efficient heat engine. The energy gain is a property of the composite system rather than of the individual dots. It is therefore tunable to optimize the power while keeping a much larger level spacing for the individual quantum dots. Despite the simplicity of the physical model, the optimized rectified current and power is larger than any other candidate nano-engine. The ability to scale the power by putting many such engines into a two-dimensional layered structure gives a paradigmatic system for harvesting thermal energy at the nanoscale. We demonstrate that the high power and efficiency of the layered structure persists even if the quantum dots exhibit some randomness.

cond-mat.mes-hall↗
arXiv2012

Rectification of thermal fluctuations in a chaotic cavity heat engine

We investigate the rectification of thermal fluctuations in a mesoscopic on-chip heat engine. The engine consists of a hot chaotic cavity capacitively coupled to a cold cavity which rectifies the excess noise and generates a directed current. The fluctuation-induced directed current depends on the energy asymmetry of the transmissions of the contacts of the cold cavity to the leads and is proportional to the temperature difference. We discuss the maximal power output of the heat engine and its efficiency.

cond-mat.mes-hall↗
arXiv2011

Effective thermodynamics of strongly coupled qubits

Interactions between a quantum system and its environment at low temperatures can lead to violations of thermal laws for the system. The source of these violations is the entanglement between system and environment, which prevents the system from entering into a thermal state. On the other hand, for two-state systems, we show that one can define an effective temperature, placing the system into a `pseudo-thermal' state where effective thermal laws are upheld. We then numerically explore these assertions for an n-state system inspired by the spin-boson environment.

cond-mat.other↗
arXiv2011

Precision frequency measurements with interferometric weak values

We demonstrate an experiment which utilizes a Sagnac interferometer to measure a change in optical frequency of 129 kHz per root Hz with only 2 mW of continuous wave, single mode input power. We describe the measurement of a weak value and show how even higher frequency sensitivities may be obtained over a bandwidth of several nanometers. This technique has many possible applications, such as precision relative frequency measurements and laser locking without the use of atomic lines.

quant-ph↗
arXiv2009

Continuous phase amplification with a Sagnac interferometer

We describe a weak value inspired phase amplification technique in a Sagnac interferometer. We monitor the relative phase between two paths of a slightly misaligned interferometer by measuring the average position of a split-Gaussian mode in the dark port. Although we monitor only the dark port, we show that the signal varies linearly with phase and that we can obtain similar sensitivity to balanced homodyne detection. We derive the source of the amplification both with classical wave optics and as an inverse weak value.

quant-ph↗
arXiv2009

Optimizing the Signal to Noise Ratio of a Beam Deflection Measurement with Interferometric Weak Values

The amplification obtained using weak values is quantified through a detailed investigation of the signal to noise ratio for an optical beam deflection measurement. We show that for a given deflection, input power and beam radius, the use of interferometric weak values allows one to obtain the optimum signal to noise ratio using a coherent beam. This method has the advantage of reduced technical noise and allows for the use of detectors with a low saturation intensity. We report on an experiment which improves the signal to noise ratio for a beam deflection measurement by a factor of 54 when compared to a measurement using the same beam size and a quantum limited detector.

quant-ph↗
arXiv2009

Ultrasensitive Beam Deflection Measurement via Interferometric Weak Value Amplification

We report on the use of an interferometric weak value technique to amplify very small transverse deflections of an optical beam. By entangling the beam's transverse degrees of freedom with the which-path states of a Sagnac interferometer, it is possible to realize an optical amplifier for polarization independent deflections. The theory for the interferometric weak value amplification method is presented along with the experimental results, which are in good agreement. Of particular interest, we measured the angular deflection of a mirror down to 560 femtoradians and the linear travel of a piezo actuator down to 20 femtometers.

quant-ph↗
arXiv2009

Uncollapsing the wavefunction by undoing quantum measurements

We review and expand on recent advances in theory and experiments concerning the problem of wavefunction uncollapse: Given an unknown state that has been disturbed by a generalized measurement, restore the state to its initial configuration. We describe how this is probabilistically possible with a subsequent measurement that involves erasing the information extracted about the state in the first measurement. The general theory of abstract measurements is discussed, focusing on quantum information aspects of the problem, in addition to investigating a variety of specific physical situations and explicit measurement strategies. Several systems are considered in detail: the quantum double dot charge qubit measured by a quantum point contact (with and without Hamiltonian dynamics), the superconducting phase qubit monitored by a SQUID detector, and an arbitrary number of entangled charge qubits. Furthermore, uncollapse strategies for the quantum dot electron spin qubit, and the optical polarization qubit are also reviewed. For each of these systems the physics of the continuous measurement process, the strategy required to ideally uncollapse the wavefunction, as well as the statistical features associated with the measurement is discussed. We also summarize the recent experimental realization of two of these systems, the phase qubit and the polarization qubit.

quant-ph↗
arXiv2009

Achieving the threshold regime with an over-screened Josephson junction

We demonstrate that by utilizing an over-screened Josephson junction as a noise detector it is possible to achieve the threshold regime, whereby the tails of the fluctuating current distribution are measured. This situation is realized by placing the Josephson junction and mesoscopic conductor in an external circuit with very low impedance. In the underdamped limit, over-screening the junction inhibits the energy diffusion in the junction, effectively creating a tunable activation barrier to the dissipative state. As a result, the activation rate is qualitatively different from the Arrhenius form.

cond-mat.mes-hall↗
arXiv2008

Entanglement genesis under continuous parity measurement

We examine the stochastic dynamics of entanglement for an uncoupled two-qubit system, undergoing continuous parity measurement. Starting with a fully mixed state, the entanglement is zero for a finite amount of time, when it is suddenly created, which we refer to as entanglement genesis. There can be further entanglement sudden death/birth events culminating in the formation of a fully entangled state. We present numerical investigations of this effect together with statistics of the entanglement genesis time in the weak measurement limit as well as the quantum Zeno limit. An analytic treatment of the physics is presented, aided by the derivation of a simple concurrence equation for Bell basis X-states. The probability of entanglement border crossing and mean first passage times are calculated for the case of measurement dynamics alone. We find that states with almost the same probability of entanglement border crossing can have very different average crossing times. Our results provide insights on the optimization of entanglement generation by measurement.

quant-ph↗
arXiv2008

Decay of a metastable state activated by non-Gaussian noise: A critical review of the generalized Kramers problem

We review the problem of the noise activated escape from a metastable state in the presence of non-Gaussian noise, and present connections between various theoretical approaches. We also respond to criticism of our work by Tomáš Novotný [arXiv:0807.0387] concerning the weak damping limit. The discrepancy between our results is linked to uncontrolled approximations made by Novotný.

cond-mat.mes-hall↗
arXiv2007

Energy Measurements and Preparation of Canonical Phase States of a Nano-Mechanical Resonator

We show that a continuous quantum non-demolition measurement of the energy of a nanomechanical resonator can be achieved by monitoring the resonator with a quantum point contact via a Cooper-pair box. This technique can further be used to prepare highly non-classical states of two resonators, such as canonical phase-reference states, and so-called "noon" states.

quant-ph↗
arXiv2007

Gap theory of rectification in ballistic three-terminal conductors

We introduce a model for rectification in three-terminal ballistic conductors, where the central connecting node is modeled as a chaotic cavity. For bias voltages comparable to the Fermi energy, a strong nonlinearity is created by the opening of a gap in the transport window. Both noninteracting cavity electrons at arbitrary temperature as well as the hot electron regime are considered. Charging effects are treated within the transmission formalism using a self-consistent analysis. The conductance of the third lead in a voltage probe configuration is varied to also model inelastic effects. We find that the basic transport features are insensitive to all of these changes, indicating that the nonlinearity is robust and well suited to applications such as current rectification in ballistic systems. Our findings are in broad agreement with several recent experiments.

cond-mat.mes-hall↗