SearcharxivSearch

arXiv subjects

Andrew P. Rotunno

Publications and source records attributed to Andrew P. Rotunno.

13 recordsLinked to original sources

Primary quantum thermometry of mm-wave blackbody radiation via induced state transfer in Rydberg states of cold atoms

Rydberg states of alkali atoms are highly sensitive to electromagnetic radiation in the GHz-to-THz regime because their transitions have large electric dipole moments. Consequently, environmental blackbody radiation (BBR) can couple Rydberg states together at $μ$s timescales. Here, we track the BBR-induced transfer of a prepared Rydberg state to its neighbors and use the evolution of these state populations to characterize the BBR field at the relevant wavelengths, primarily at 130 GHz. We use selective field ionization readout of Rydberg states with principal quantum number $n\sim30$ in $^{85}$Rb and substantiate our ionization signal with a theoretical model. With this detection method, we measure the associated blackbody-radiation-induced time dynamics of these states, reproduce the results with a simple semi-classical population transfer model, and demonstrate that this measurement is temperature sensitive with a statistical sensitivity to the fractional temperature uncertainty of 0.09 Hz$^{-1/2}$, corresponding to 26 K$\cdot$Hz$^{-1/2}$ at room temperature. This represents a calibration-free SI-traceable temperature measurement, for which we calculate a systematic fractional temperature uncertainty of 0.006, corresponding to 2 K at room temperature when used as a primary temperature standard.

physics.atom-ph

Observation of Asymmetric Sideband Generation in Strongly-driven Rydberg Atoms

Improving the bandwidth of Rydberg atom-based receivers is an ongoing challenge owing to the long-lived Rydberg state lifetimes that limit the refresh rate of ground state atoms. In particular, the LO-based Rydberg mixer approach allows for bandwidths into the few-MHz range. Here, we use heterodyne detection of the Rydberg atom receiver probe laser to separate the negative and positive sidebands that originate from distinct six wave mixing processes, in order to investigate their individual bandwidths. We experimentally confirm the prediction that the negative sideband exhibits a higher bandwidth than the positive sideband. We further explore the effect of coupling and probe laser Rabi frequency on the bandwidth, which we find to be in good agreement with our model. We achieved a maximum experimental (and theoretical) bandwidth of about 11 (11) MHz and 3.5 (5) MHz for the negative and positive sidebands, respectively, from the -3dB roll-off point for optimized field parameters. This work provides insight into the bandwidth-limiting features of Rydberg atom receivers and points the way towards further optimization of their response.

physics.atom-ph

Independent Rydberg Atom Sensing using a Dual-Ladder Scheme

Rydberg atom-based electric field sensing can provide all-optical readout of radio frequency fields in a dielectric environment. However, because a single set of optical fields is typically used to prepare the Rydberg state and read out its response to RF fields, it is challenging to perform simultaneous and independent measurements of the RF field(s). Here we show that using two independent schemes to prepare and read out the same Rydberg state can be used to perform independent measurements in general, which we demonstrate specifically by resolving the the RF polarization. We expect this work will be useful for fiber-coupled sensor heads where spatial multiplexing is challenging, as well as for complex multi-level sensing schemes.

physics.atom-ph

Investigation of fluorescence versus transmission readout for three-photon Rydberg excitation used in electrometry

We present a three-photon based fluorescence readout method where the strength of the fluorescence scales with the strength of the radio-frequency (RF) field being applied. We compare this method to conventional three-photon electromagnetically-induced transparency (EIT) and electromagnetically-induced absorption (EIA). Our demonstrated EIA/EIT sensitivity in the collinear three-photon Cesium system is the best reported to date at roughly 30 uVm^{-1}Hz^{-1/2}. The fluorescence is nearly 4 fold better in sensitivity compared to EIA/EIT readout.

quant-ph

Zeeman-resolved Autler-Townes splitting in Rydberg atoms with tunable resonances and a single transition dipole moment

Applying a magnetic field as a method for tuning the frequency of Autler-Townes splitting for Rydberg electrometry has recently been demonstrated. In this paper we provide a theoretical understanding of EIT signals in the presence of a large magnetic field, as well as demonstrate some advantages of this technique over traditional Autler-Townes based electrometry. We show that a strong magnetic field provides a well-defined quantization axis regardless of the optical field polarizations, we demonstrate that by separating the $m_J$ levels of the Rydberg state we can perform an Autler-Townes splitting with a single participating dipole moment, and we demonstrate recovery of signal strength by populating a single $m_J$ level using circularly polarized light.

physics.atom-ph

Phase-Resolved Rydberg Atom Field Sensing using Quantum Interferometry

Although Rydberg atom-based electric field sensing provides key advantages over traditional antenna-based detection, it remains limited by the need for a local oscillator (LO) for low-field and phase resolved detection. In this work, we demonstrate that closed-loop quantum interferometric schemes can be used to generate a system-internal reference that can directly replace an external LO for Rydberg field sensing. We reveal that this quantum-interferometrically defined internal reference phase and frequency can be used analogously to a traditional LO for atom-based down-mixing to an intermediate frequency for lock-in phase detection. We demonstrate that this LO-equivalent functionality provides analogous benefits to an LO, including full 360$^\circ$ phase resolution as well as improved sensitivity. The general applicability of this approach is confirmed by demodulating a four phase-state signal broadcast on the atoms. Our approach opens up new sensing schemes and provides a clear path towards all-optical Rydberg atom sensing implementations.

physics.atom-ph

EIT spectra of Rydberg atoms dressed with dual-tone radio-frequency fields

We examine spectral signatures of Rydberg atoms driven with near-resonant dual-tone radio-frequency (RF) fields in the regime of strong driving. We experimentally demonstrate and theoretically model a variety of nonlinear and multiphoton phenomena in the atomic Rydberg response that manifest in the EIT spectra. Our results echo previous studies of two-level atoms driven with bichromatic optical fields. In comparison to the optical studies, the RF-driven Rydberg system utilizes a more complex excitation pathway, and electromagnetic fields from two different spectral regimes: a two-photon optical excitation continuously creates highly excited Rydberg atoms, while RF fields drive resonant coupling between the Rydberg levels and generate strong mixing. Yet, our spectra reflect nearly identical effects of the dual-tone RF fields on the atomic Rydberg observables, showing detuning-dependent splittings and Rabi frequency dependent peak numbers and relative strengths, and avoided crossings at subharmonic resonances. We thus validate previous two-state models in this more complex physical system. In the context of Rydberg electrometry, we use these investigations to explore a technique where we tune a known RF field to observe spectra which give frequency and power of an unknown RF field using the complex dual-tone spectra.

physics.atom-ph

Inverse Transform Sampling for Efficient Doppler-Averaged Spectroscopy Simulations

We present a thermal velocity sampling method for calculating Doppler-broadened atomic spectra, which more efficiently reaches a smooth limit than regular velocity weighted sampling. The method uses equal-population sampling of the 1-D thermal distribution, sampling the 'inverse transform' of the cumulative distribution function, and is broadly applicable to normal distributions. We also discuss efficiencies from eliminating velocity classes which don't significantly contribute to observed atomic lines, and comment on the application of this method in 2- and 3-dimensions.

physics.atom-ph

Detection of HF and VHF Fields through Floquet Sideband Gaps by `Rabi Matching' Dressed Rydberg Atoms

Radio frequencies in the HF and VHF (3 MHz to 300 MHz) bands are challenging for Rydberg atom-based detection schemes, as resonant detection requires exciting the atoms to extremely high energy states. We demonstrate a method for detecting and measuring radio frequency (RF) carriers in the HF and VHF bands via a controlled Autler-Townes line splitting. Using a resonant, high-frequency (GHz) RF field, the absorption signal from Townes-Merrit sidebands created by a low frequency, non-resonant RF field can be enhanced. Notably, this technique uses a measurement of the optical frequency separation of an avoided crossing to determine the amplitude of a non-resonant, low frequency RF field. This technique also provides frequency-selective measurements of low frequency RF electric fields. To show this, we demonstrate amplitude modulated signal transduction on a low frequency VHF carrier. We further demonstrate reception of multiple tones simultaneously, creating a Rydberg `spectrum analyzer' over the VHF range.

physics.atom-ph

Sensitivity Comparison of Two-photon vs Three-photon Rydberg Electrometry

We investigate the sensitivity of three-photon EIT in Rydberg atoms to radio frequency detection and compare it against conventional two-photon systems. Specifically, we model the 4-level and 5-level atomic system and compare how the transmission of the probe changes with different powers of the lasers used and strengths of the RF field. In this model, we also define a sensitivity metric to best relate to the operation of the current best experimental implementation based on shot noise limited detection. We find that the three-photon system boasts much narrower line widths compared to the conventional two-photon EIT. However, these narrow line features do not align with the regions of the best sensitivity. In addition to this, we calculate the expected sensitivity for the two-photon Rydberg sensor and find that the best achievable sensitivity is over an order of magnitude better than the current measured values of 5 uV/m/Hz. However, by accounting for the additional noise sources in the experiment and the quantum efficiency of the photo-detectors, the values are in good agreement.

physics.atom-ph

Rydberg state engineering: A comparison of tuning schemes for continuous frequency sensing

On-resonance Rydberg atom-based radio-frequency (RF) electric field sensing methods remain limited by the narrow frequency signal detection bands available by resonant transitions. The use of an additional RF tuner field to dress or shift a target Rydberg state can be used to return a detuned signal field to resonance and thus dramatically extend the frequency range available for resonant sensing. Here we investigate three distinct tuning level schemes based on adjacent Rydberg transitions, which are shown to have distinct characteristics and can be controlled with mechanisms based on the tuning field frequency or field strength. We further show that a two-photon Raman feature can be used as an effective tuning mechanism separate from conventional Autler-Townes splitting. We compare our tuning schemes to AC Stark effect-based broadband RF field sensing and show that although the sensitivity is diminished as we tune away from a resonant state, it nevertheless can be used in configurations where there is a low density of Rydberg states, which would result in a weak AC Stark effect.

physics.atom-ph

Modeling Line Broadening and Distortion Due to Spatially Non-Uniform Fields in Rydberg Electrometry

We present a model for calculating broadened Autler-Townes spectra when probing ac electric field magnitudes by use of Rydberg atom electromagnetically-induced transparency. This model approximates the atom vapor as a multi-layered media and uses Beer's law to combine probe beam absorption through many discrete thin segments, replicating the broadening seen in experimental measurements. The methodology can be easily applied to other non-uniform optical parameters when monitoring total spectral transmission or phase delay. Field non-uniformity is present in standing waves of unmatched waveguides and glass vapor cells, which are generally due to source characteristics and environmental reflections. We present broadening and distortion effects caused by various types of electric-field distributions, and compare this model to results obtained from measured atomic spectra.

physics.atom-ph