arXiv subjects

Andrey Shchepetov

Publications and source records attributed to Andrey Shchepetov.

7 recordsLinked to original sources

arXiv2024

Scalable on-chip multiplexing of silicon single and double quantum dots

Owing to the maturity of complementary metal oxide semiconductor (CMOS) microelectronics, qubits realized with spins in silicon quantum dots (QDs) are considered among the most promising technologies for building scalable quantum computers. For this goal, ultra-low-power on-chip cryogenic CMOS (cryo-CMOS) electronics for control, read-out, and interfacing of the qubits is an important milestone. We report on-chip interfacing of tunable electron and hole QDs by a 64-channel cryo-CMOS multiplexer with less-than-detectable static power dissipation. We analyze charge noise and measure state-of-the-art addition energies and gate lever arm parameters in the QDs. We correlate low noise in QDs and sharp turn-on characteristics in cryogenic transistors, both fabricated with the same gate stack. Finally, we demonstrate that our hybrid quantum-CMOS technology provides a route to scalable interfacing of a large number of QD devices, enabling, for example, variability analysis and QD qubit geometry optimization, which are prerequisites for building large-scale silicon-based quantum computers.

cond-mat.mes-hall↗

arXiv2020

Dispersive readout of reconfigurable ambipolar quantum dots in a silicon-on-insulator nanowire

We report on ambipolar gate-defined quantum dots in silicon on insulator (SOI) nanowires fabricated using a customised complementary metal-oxide-semiconductor (CMOS) process. The ambipolarity was achieved by extending a gate over an intrinsic silicon channel to both highly doped n-type and p-type terminals. We utilise the ability to supply ambipolar carrier reservoirs to the silicon channel to demonstrate an ability to reconfigurably define, with the same electrodes, double quantum dots with either holes or electrons. We use gate-based reflectometry to sense the inter-dot charge transition(IDT) of both electron and hole double quantum dots, achieving a minimum integration time of 160(100) $μ$s for electrons (holes). Our results present the opportunity to combine, in a single device, the long coherence times of electron spins with the electrically controllable holes spins in silicon.

cond-mat.mes-hall↗

arXiv2018

Efficient thermionic operation and phonon isolation by a semiconductor-superconductor junction

Control of heat flux at small length scales is crucial for numerous solid-state devices and systems. In addition to the thermal management of information and communication devices the mastering of heat transfer channels down to the nanoscale also enable, e.g., new memory concepts, high sensitivity detectors and sensors, energy harvesters and compact solid-state refrigerators. Electronic coolers and thermal detectors for electromagnetic radiation, especially, rely on the maximization of electro-thermal response and blockade of phonon transport. In this work, we propose and demonstrate that efficient electro-thermal operation and phonon transfer blocking can be achieved in a single solid-state thermionic junction. Our experimental demonstration relies on suspended semiconductor-superconductor junctions where the electro-thermal response arises from the superconducting energy gap, and the phonon blocking naturally results from the transmission bottleneck at the junction. We suspend different size degenerately doped silicon chips (up to macroscopic scale) directly from the junctions and cool these by biasing the junctions. The electronic cooling operation characteristics are accompanied by measurement and analysis of the thermal resistance components in the structures indicating the operation principle of phonon blocking in the junctions.

cond-mat.mes-hall↗

arXiv2017

Thermoelectric bolometers based on ultra-thin heavily doped single-crystal silicon membranes

We present ultra-thin silicon membrane thermocouple bolometers suitable for fast and sensitive detection of low levels of thermal power and infrared radiation at room temperature. The devices are based on 40 nm-thick strain tuned single crystalline silicon membranes shaped into heater/absorber area and narrow n- and p-doped beams, which operate as the thermocouple. The electro-thermal characterization of the devices reveal noise equivalent power of 13 pW/rtHz and thermal time constant of 2.5 ms. The high sensitivity of the devices is due to the high Seebeck coefficient of 0.39 mV/K and reduction of thermal conductivity of the Si beams from the bulk value. The bolometers operate in the Johnson-Nyquist noise limit of the thermocouple, and the performance improvement towards the operation close to the temperature fluctuation limit is discussed.

cond-mat.mes-hall↗

arXiv2014

Reconstructing phonon mean free path contributions to thermal conductivity using nanoscale membranes

Knowledge of the mean free path distribution of heat-carrying phonons is key to understanding phonon-mediated thermal transport. We demonstrate that thermal conductivity measurements of thin membranes spanning a wide thickness range can be used to characterize how bulk thermal conductivity is distributed over phonon mean free paths. A non-contact transient thermal grating technique was used to measure the thermal conductivity of suspended Si membranes ranging from 15 to 1500 nm in thickness. A decrease in the thermal conductivity from 74% to 13% of the bulk value is observed over this thickness range, which is attributed to diffuse phonon boundary scattering. Due to the well-defined relation between the membrane thickness and phonon mean free path suppression, combined with the range and accuracy of the measurements, we can reconstruct the bulk thermal conductivity accumulation vs. phonon mean free path, and compare with theoretical models.

cond-mat.mes-hall↗

arXiv2013

Ultra-Thin Free-Standing Single Crystalline Silicon Membranes With Strain Control

We report on fabrication and characterization of ultra-thin suspended single crystalline flat silicon membranes with thickness down to 6 nm. We have developed a method to control the strain in the membranes by adding a strain compensating frame on the silicon membrane perimeter to avoid buckling of the released membranes. We show that by changing the properties of the frame the strain of the membrane can be tuned in controlled manner. Consequently, both the mechanical properties and the band structure can be engineered and the resulting membranes provide a unique laboratory to study low-dimensional electronic, photonic and phononic phenomena.

cond-mat.mes-hall↗

arXiv2012

Phonons in Slow Motion: Dispersion Relations in Ultra-Thin Si Membranes

We report the changes in dispersion relations of hypersonic acoustic phonons in free-standing silicon membranes as thin as \sim 8 nm. We observe a reduction of the phase and group velocities of the fundamental flexural mode by more than one order of magnitude compared to bulk values. The modification of the dispersion relation in nanostructures has important consequences for noise control in nano and micro-electromechanical systems (MEMS/NEMS) as well as opto-mechanical devices.

cond-mat.mes-hall↗