arXiv subjects

Annalisa Allocca

Publications and source records attributed to Annalisa Allocca.

8 recordsLinked to original sources

arXiv2026

The impact of seasonality over the sensitivity of Einstein Telescope and the SNR of CBC signals at the Sardinia candidate site

This work presents the first investigation of the impact of seasonal variations in seismic noise on the low-frequency performance of the Einstein Telescope (ET) at the Sardinia candidate site, focusing on their effect on compact binary coalescence signals. Using seismic data collected between 2022 and 2025 from a deep borehole, we characterize the seasonal variability of the seismic noise and identify the months of July and December as representative best- and worst-case conditions. The measured seismic spectra are used to estimate the Newtonian noise contribution in the 2--10 Hz frequency range and to derive corresponding modifications to the ET design sensitivity. These sensitivity curves are then used in simulations of binary neutron star and intermediate-mass black hole signals in the triangular ET configuration to quantify the resulting changes in signal-to-noise ratio. We find that median seasonal conditions produce only minor changes in the expected SNR, with deviations from the design case typically below 2$\%$. Larger effects are found for the upper tail of the December noise distribution, where the average SNR loss reaches approximately 20--25$\%$. These results indicate that seasonal seismic variability at the Sardinia candidate site has a limited impact on the low-frequency performance of ET under typical conditions.

gr-qc↗

arXiv2026

Mechanical Long Baseline Differential Gradiometers as Low Frequency Gravitational Wave Detectors

We present a new differential mechanical gradiometer for the detection of low-frequency Gravitational Waves. The frequency range is 0.05 to 1 Hz, a frequency gap not covered either by future space-based detectors such as LISA or by ground-based observatories such as Einstein Telescope or Cosmic Explorer. The proposed detection principle is similar to antennas based on torsion pendulums but solves the problem of physical confinement of these antennas by operating vertically and by having a counterweight at one end of each bar and a mass suspended from a long wire at the other. With this configuration, we enlarge the gravitational force acting on the system \textit{without} changing the moment of inertia of the system, so that we move from a signal $Δθ$ of the order of $Δθ= h$, where h is the amplitude of the gravitational wave, to a signal of the order $Δθ= h\frac{L}{D}$, where D is the length of the arm and L is the length of the wire suspending the test mass. This configuration is a further evolution of the recent development of tiltmeters and balances with double suspended arms and interferometric read-out, where the main working principles are already tested. The expected sensitivity will be discussed with respect to the proposed parameters and the present technology.

gr-qc↗

arXiv2025

The impact of local noise recorded at the ET candidate sites on the signal to noise ratio of CBC gravitational wave signals for the ET triangle configuration

We present an evaluation of how site dependent noise can affect the signal to noise ratio (SNR) of compact binary coalescence (CBC) signals in the future 3rd generation gravitational wave (GW) detector Einstein Telescope (ET). The design of ET is currently pushing the scientific community to study its scientific potential with respect to known, and possibly unexpected, GW signals using its design sensitivity curves. However, local ambient noise may have an impact on the ET sensitivity at low frequency and therefore affect the SNR of CBC signals at low frequency. Therefore, we study the impact of ambient noise on the ET sensitivity curve at the two sites candidate to host ET - Sardinia, in Italy, and the Euregio Meuse-Rhine (EMR) at the Netherlands-Belgium border - and infer the impact on the ET sensitivity curve and how the SNR of CBC signals at low frequencies is affected. We find that Sardinia shows results which are on par, if not better, than the design case. On the other hand, ambient noise for the current EMR sensitivity curve in Terziet causes a higher degradation of the SNR performances.

gr-qc↗

arXiv2024

Adaptive algorithms for low-latency cancellation of seismic Newtonian-noise at the Virgo gravitational-wave detector

A system was recently implemented in the Virgo detector to cancel noise in its data produced by seismic waves directly coupling with the suspended test masses through gravitational interaction. The data from seismometers are being filtered to produce a coherent estimate of the associated gravitational noise also known as Newtonian noise. The first implementation of the system uses a time-invariant (static) Wiener filter, which is the optimal filter for Newtonian-noise cancellation assuming that the noise is stationary. However, time variations in the form of transients and slow changes in correlations between sensors are possible and while time-variant filters are expected to cope with these variations better than a static Wiener filter, the question is what the limitations are of time-variant noise cancellation. In this study, we present a framework to study the performance limitations of time-variant noise cancellation filters and carry out a proof-of-concept with adaptive filters on seismic data at the Virgo site. We demonstrate that the adaptive filters, at least those with superior architecture, indeed significantly outperform the static Wiener filter with the residual noise remaining above the statistical error bound.

gr-qc↗

arXiv2023

Design and implementation of a seismic Newtonian-noise cancellation system for the Virgo gravitational-wave detector

Terrestrial gravity perturbations caused by seismic fields produce the so-called Newtonian noise in gravitational-wave detectors, which is predicted to limit their sensitivity in the upcoming observing runs. In the past, this noise was seen as an infrastructural limitation, i.e., something that cannot be overcome without major investments to improve a detector's infrastructure. However, it is possible to have at least an indirect estimate of this noise by using the data from a large number of seismometers deployed around a detector's suspended test masses. The noise estimate can be subtracted from the gravitational-wave data; a process called Newtonian-noise cancellation (NNC). In this article, we present the design and implementation of the first NNC system at the Virgo detector as part of its AdV+ upgrade. It uses data from 110 vertical geophones deployed inside the Virgo buildings in optimized array configurations. We use a separate tiltmeter channel to test the pipeline in a proof-of-principle. The system has been running with good performance over months.

gr-qc↗

arXiv2022

Quantum zero point electromagnetic energy difference between the superconducting and the normal phase in a HTc superconducting metal bulk sample

We provide a novel methodological approach to the estimate of the change of the Quantum Vacuum electromagnetic energy density in a High critical Temperature superconducting metal bulk sample, when it undergoes the transition in temperature, from the superconducting to the normal phase. The various contributions to the Casimir energy in the two phases are highlighted and compared. While the TM polarization of the vacuum mode allows for a macroscopic description of the superconducting transition, the changes in the TE vacuum mode induced by the superconductive correlations are introduced within a microscopic model, which does not explicitly take into account the anisotropic structure of the material.

cond-mat.supr-con↗

arXiv2021

Towards optomechanical parametric instabilities prediction in ground-based gravitational wave detectors

Increasing the laser power is essential to improve the sensitivity of interferometric gravitational wave detectors. However, optomechanical parametric instabilities can set a limit to that power. It is of major importance to understand and characterize the many parameters and effects that influence these instabilities. Here, we model with a high degree of precision the optical and mechanical modes that are involved in these parametric instabilities, such that our model can become predictive. As an example, we perform simulations for the Advanced Virgo interferometer (O3 configuration). In particular we compute mechanical modes losses by combining both on-site measurements and finite element analysis with unprecedented level of detail and accuracy. We also study the influence on optical modes and parametric gains of mirror finite size effects, and mirror deformations due to thermal absorption. We show that these effects play an important role if transverse optical modes of order higher than four are involved in the instability process.

astro-ph.IM↗

arXiv2012

Measuring the influence of Casimir energy on superconducting phase transitions: a cross-correlation data analysis

The ALADIN experiment aims at observing how the critical magnetic field of a superconducting Aluminum film is modified, when it constitutes one of the reflecting surfaces of a Casimir cavity. If successful, such an observation would reveal the influence of vacuum energy on the superconducting phase transition. In this paper a rigorous analysis of experimental data is reported, the results are discussed and compared with theoretical predictions based on Lifshitz theory of dispersion forces, and the BCS formula for the optical conductivity of superconductors. The main novelty with respect to a previous data analysis by some of the authors, is the use of a cross-correlation method which is more rigorous and leads to better estimates.

hep-th↗