arXiv subjects

B. Fernandez

Publications and source records attributed to B. Fernandez.

14 recordsLinked to original sources

arXiv2026

Improved $^{94}$Mo neutron resonance parameters from neutron capture and transmission measurements at n_TOF and GELINA

We report high-resolution measurements of the $^{94}\mathrm{Mo}(\mathrm{n},\gamma)^{95}\mathrm{Mo}$ cross section in the neutron energy range from a few eV up to about 250 keV, performed at the n_TOF facility (CERN), and of the $^{94}\mathrm{Mo}(\mathrm{n},\mathrm{tot})$ cross section up to 32 keV, measured at GELINA (JRC Geel). A combined R-matrix analysis of capture and transmission data yields significantly improved neutron-resonance parameters for $^{94}$Mo. A total of 186 resonances were observed in this analysis of which 127 reported here for the first time. The resulting Maxwellian-averaged cross section at stellar temperatures relevant to the slow neutron-capture process (s-process) is approximately 25% lower than previous evaluations and literature values. To assess the astrophysical impact of the revised cross section, we performed s-process nucleosynthesis calculations for low-mass asymptotic giant branch stars. Despite the substantial reduction in the $^{94}\mathrm{Mo}(\mathrm{n},\gamma)^{95}\mathrm{Mo}$ rate, the final yields vary by only 3-4%. This demonstrates that the isotopic budget of $^{94}$Mo in AGB stars is primarily governed by the branching flow at $^{94}\mathrm{Nb}$ rather than by the neutron-capture destruction on $^{94}$Mo itself. The new cross section thus helps disentangle nuclear cross-section uncertainties from branching-flow effects in the s-process production of $^{94}$Mo.

nucl-ex↗

arXiv2026

Low-Temperature Sputtering and Polarity Determination of Vertically Aligned ZnO Nanocolumns

We report the low temperature growth of vertically aligned ZnO nanocolumns on Si substrates by using reactive radio frequency magnetron sputtering.High sputtering pressure combined with low substrate temperatures induce a pronounced self shadowing effect,leading to the formation of isolated nanocolumns. In contrast, lower sputtering pressure promotes void filling in deposited films, favouring the growth of dense, low roughness columnar films. Modification of native SiOx on Si surfaces via substrate preheating prior to deposition, alters the initial nucleation stage, thereby determining dominant polarity and morphology of ZnO nanostructures. O polar columnar films and nanocolumns exhibit higher effective piezoelectric coefficient, corresponding to their higher differential resistance and reduced dielectric loss, suggesting suppressed carrier induced screening of piezoelectric charges. This low thermal budget, scalable sputtering approach provides an alternative route for integrating ZnO nanostructures onto thermal constrained substrates, including those used in flexible and wearable electronics.

cond-mat.mtrl-sci↗

arXiv2024

AlN Nanowire Based Vertically Integrated Piezoelectric Nanogenerators

In this study, detailed analysis of the direct piezo-response of AlN nanowire-based vertically integrated nanogenerators (VINGs) is undertaken as a function of mechanical excitation frequency. We show that the piezo-charge, piezo-voltage, and impedance measured at the same position of the devices can be directly correlated through an equivalent circuit model, in the whole frequency range of investigation. Our presented results are utilized to determine the performance figures of merit (FoM) of nanowire-based VINGs, namely the piezoelectric voltage constant (g) for sensing, and the product d g for energy harvesting, where d is the piezoelectric charge constant. By comparison of these metrics with those of freestanding single crystal GaN and quartz substrates, as well as sputtered AlN thin films, we suggest that the nanowires can outperform their rigid counterparts in terms of mechanical sensing and energy generation. This work provides experimental guidelines for understanding the direct piezo-characteristics of VINGs and facilitates a quantitative comparison between nanostructured piezoelectric devices fabricated using different materials or architectures.

physics.app-ph↗

arXiv2023

Mapper of the IGM spin temperature: instrument overview

The observation of the global 21 cm signal produced by neutral hydrogen gas in the intergalactic medium (IGM) during the Dark Ages, Cosmic Dawn, and Epoch of Reionization requires measurements with extremely well-calibrated wideband radiometers. We describe the design and characterization of the Mapper of the IGM Spin Temperature (MIST), which is a new ground-based, single-antenna, global 21 cm experiment. The design of MIST was guided by the objectives of avoiding systematics from an antenna ground plane and cables around the antenna, as well as maximizing the instrument's on-sky efficiency and portability for operations at remote sites. We have built two MIST instruments, which observe in the range 25-105 MHz. For the 21 cm signal, this frequency range approximately corresponds to redshifts 55.5 > z > 12.5, encompassing the Dark Ages and Cosmic Dawn. The MIST antenna is a horizontal blade dipole of 2.42 m in length, 60 cm in width, and 52 cm in height above the ground. This antenna operates without a metal ground plane. The instruments run on 12 V batteries and have a maximum power consumption of 17 W. The batteries and electronics are contained in a single receiver box located under the antenna. We present the characterization of the instruments using electromagnetic simulations and lab measurements. We also show sample sky measurements from recent observations at remote sites in California, Nevada, and the Canadian High Arctic. These measurements indicate that the instruments perform as expected. Detailed analyses of the sky measurements are left for future work.

astro-ph.IM↗

arXiv2022

The CERN n TOF NEAR station for astrophysics- and application-related neutron activation measurements

A new experimental area, the NEAR station, has recently been built at the CERN n TOF facility, at a short distance from the spallation target (1.5 m). The new area, characterized by a neutron beam of very high flux, has been designed with the purpose of performing activation measurements of interest for astrophysics and various applications. The beam is transported from the spallation target to the NEAR station through a hole in the shielding wall of the target, inside which a collimator is inserted. The new area is complemented with a {\gamma}-ray spectroscopy laboratory, the GEAR station, equipped with a high efficiency HPGe detector, for the measurement of the activity resulting from irradiation of a sample in the NEAR station. The use of a moderator/filter assembly is envisaged, in order to produce a neutron beam of Maxwellian shape at different thermal energies, necessary for the measurement of Maxwellian Averaged Cross Sections of astrophysical interest. A new fast-cycling activation technique is also being investigated, for measurements of reactions leading to isotopes of very short half life.

physics.ins-det↗

arXiv2016

Ultra-smooth single crystal diamond surfaces resulting from implantation and lift-off processes

A method for obtaining a smooth, single crystal diamond surface is presented, whereby a sacrificial defective layer is created by implantation and graphitized by annealing before being selectively etched. We have used O+ at 240 keV, the main process variables being the ion fluence (ranging from 3x10^15 cm^-2 to 3x10^17 cm^-2) and the final etching process (wet etch, H2 plasma and annealing in air). The substrates were characterized by atomic force microscopy, optical profilometry and white beam X-ray topography. The influence of the various process parameters on the resulting lift-off efficiency and final surface roughness is discussed. An O+ fluence of 2x10^17 cm^-2 was found to result in sub-nanometre roughness over tens of um^2.

cond-mat.mtrl-sci↗

arXiv2010

Production of new neutron-rich isotopes of heavy elements in fragmentation reactions of $^{238}$U projectiles at 1 A GeV

The production of heavy neutron-rich nuclei has been investigated using cold fragmentation reactions of $^{238}$U projectiles at relativistic energies. The experiment performed at the high-resolving-power magnetic spectrometer FRS at GSI allowed to identify 45 new heavy neutron-rich nuclei: $^{205}$Pt, $^{207-210}$Au, $^{211-216}$Hg, $^{213-217}$Tl, $^{215-220}$Pb, $^{219-224}$Bi, $^{221-227}$Po, $^{224-229}$At, $^{229-231}$Rn and $^{233}$Fr. The production cross sections of these nuclei were also determined and used to benchmark reaction codes that predict the production of nuclei far from stability.

nucl-ex↗

arXiv2007

Measurement of the complete nuclide production and kinetic energies of the system 136Xe + hydrogen at 1 GeV per nucleon

We present an extensive overview of production cross sections and kinetic energies for the complete set of nuclides formed in the spallation of 136Xe by protons at the incident energy of 1 GeV per nucleon. The measurement was performed in inverse kinematics at the FRagment Separator (GSI, Darmstadt). Slightly below the Businaro-Gallone point, 136Xe is the stable nuclide with the largest neutron excess. The kinematic data and cross sections collected in this work for the full nuclide production are a general benchmark for modelling the spallation process in a neutron-rich nuclear system, where fission is characterised by predominantly mass-asymmetric splits.

nucl-ex↗

arXiv2007

Characterization of 7H Nuclear System

The 7H resonance was produced via one-proton transfer reaction with a 8He beam at 15.4A MeV and a 12C gas target. The experimental setup was based on the active-target MAYA which allowed a complete reconstruction of the reaction kinematics. The characterization of the identified 7H events resulted in a resonance energy of 0.57(+0.42-0.21) MeV above the 3H+4n threshold and a resonance width of 0.09(+0.94-0.06) MeV.

nucl-ex↗

arXiv2006

Spallation Residues in the Reaction 56Fe + p at 0.3, 0.5, 0.75, 1.0 and 1.5 A GeV

The spallation residues produced in the bombardment of 56}Fe at 1.5, 1.0, 0.75, 0.5 and 0.3 A GeV on a liquid-hydrogen target have been measured using the reverse kinematics technique and the Fragment Separator at GSI (Darmstadt). This technique has permitted the full identification in charge and mass of all isotopes produced with cross-sections larger than 10^{-2} mb down to Z=8. Their individual production cross-sections and recoil velocities at the five energies are presented. Production cross-sections are compared to previously existing data and to empirical parametric formulas, often used in cosmic-ray astrophysics. The experimental data are also extensively compared to different combinations of intra-nuclear cascade and de-excitation models. It is shown that the yields of the lightest isotopes cannot be accounted for by standard evaporation models. The GEMINI model, which includes an asymmetric fission decay mode, gives an overall good agreement with the data. These experimental data can be directly used for the estimation of composition modifications and damages in materials containing iron in spallation sources. They are also useful for improving high precision cosmic-ray measurements.

nucl-ex↗

arXiv1998

Fronts and interfaces in bistable extended mappings

We study the interfaces' time evolution in one-dimensional bistable extended dynamical systems with discrete time. The dynamics is governed by the competition between a local piece-wise affine bistable mapping and any couplings given by the convolution with a function of bounded variation. We prove the existence of travelling wave interfaces, namely fronts, and the uniqueness of the corresponding selected velocity and shape. This selected velocity is shown to be the propagating velocity for any interface, to depend continuously on the couplings and to increase with the symmetry parameter of the local nonlinearity. We apply the results to several examples including discrete and continuous couplings, and the planar fronts' dynamics in multi-dimensional Coupled Map Lattices. We eventually emphasize on the extension to other kinds of fronts and to a more general class of bistable extended mappings for which the couplings are allowed to be nonlinear and the local map to be smooth.

patt-sol↗

arXiv1996

Extended Symbolic Dynamics in Bistable CML: Existence and Stability of Fronts

We consider a diffusive Coupled Map Lattice (CML) for which the local map is piece-wise affine and has two stable fixed points. By introducing a spatio-temporal coding, we prove the one-to-one correspondence between the set of global orbits and the set of admissible codes. This relationship is applied to the study of the (uniform) fronts' dynamics. It is shown that, for any given velocity in $[-1,1]$, there is a parameter set for which the fronts with that velocity exist and their shape is unique. The dependence of the velocity of the fronts on the local map's discontinuity is proved to be a Devil's staircase. Moreover, the linear stability of the global orbits which do not reach the discontinuity follows directly from our simple map. For the fronts, this statement is improved and as a consequence, the velocity of all the propagating interfaces is computed for any parameter. The fronts are shown to be also nonlinearly stable under some restrictions on the parameters. Actually, these restrictions follow from the co-existence of uniform fronts and non-uniformly travelling fronts for strong coupling. Finally, these results are extended to some $C^{\infty}$ local maps.

patt-sol↗

arXiv1995

Existence and Stability of Steady Fronts in Bistable CML

We prove the existence and we study the stability of the kink-like fixed points in a simple Coupled Map Lattice for which the local dynamics has two stable fixed points. The condition for the existence allows us to define a critical value of the coupling parameter where a (multi) generalized saddle-node bifurcation occurs and destroys these solutions. An extension of the results to other CML's in the same class is also displayed. Finally, we emphasize the property of spatial chaos for small coupling.

patt-sol↗

arXiv1994

Kinks Dynamics in One-Dimensional Coupled Map Lattices

We examine the problem of the dynamics of interfaces in a one-dimensional space-time discrete dynamical system. Two different regimes are studied : the non-propagating and the propagating one. In the first case, after proving the existence of such solutions, we show how they can be described using Taylor expansions. The second situation deals with the assumption of a travelling wave to follow the kink propagation. Then a comparison with the corresponding continuous model is proposed. We find that these methods are useful in simple dynamical situations but their application to complex dynamical behaviour is not yet understood.

chao-dyn↗