Searcharxiv⌕ Search

arXiv subjects

B. Geyer

Publications and source records attributed to B. Geyer.

At least 19 recordsLinked to original sources
arXiv2010

Possibility to measure thermal effects in the Casimir force

We analyze the possibility to measure small thermal effects in the Casimir force between metal test bodies in configurations of a sphere above a plate and two parallel plates. For sphere-plate geometry used in many experiments we investigate the applicability of the proximity force approximation (PFA) to calculate thermal effects in the Casimir force and its gradient. It is shown that for real metals the two formulations of the PFA used in the literature lead to relative differences in the obtained results being less than a small parameter equal to the ratio of separation distance to sphere radius. For ideal metals the PFA results for the thermal correction are obtained and compared with available exact results. It is emphasized that in the experimental region in the zeroth order of the small parameter mentioned above the thermal Casimir force and its gradient calculated using the PFA (and thermal corrections in their own right) coincide with respective exact results. For real metals available exact results are outside the application region of the PFA. However, the exact results are shown to converge to the PFA results when the small parameter goes down to the experimental values. We arrive at the conclusion that large thermal effects predicted by the Drude model approach, if existing at all, could be measured in both static and dynamic experiments in sphere-plate and plate-plate configurations. As to the small thermal effects predicted by the plasma model approach, the static experiment in the configuration of two parallel plates is found to be the best for its observation.

cond-mat.mtrl-sci↗
arXiv2010

Comparison of the experimental data for the Casimir pressure with the Lifshitz theory at zero temperature

We perform detailed comparison of the experimental data of the experiment on the determination of the Casimir pressure between two parallel Au plates with the theoretical values computed using the Lifshitz formula at zero temperature. Computations are done using the optical data for the complex index of refraction of Au extrapolated to low frequencies by means of the Drude model with both most often used and other suggested Drude parameters. It is shown that the experimental data exclude the Lifshitz formula at zero temperature at a 70% confidence level if the Drude model with most often used values of the parameters is employed. If other values of the Drude parameters are used, the Lifshitz formula at zero frequency is experimentally excluded at a 95% confidence level. The Lifshitz formula at zero temperature combined with the generalized plasma-like model with most often used value of the plasma frequency is shown to be experimentally consistent. We propose a decisive experiment which will shed additional light on the role of relaxation properties of conduction electrons in the Casimir effect.

quant-ph↗
arXiv2010

Magnetic materials and the problem of thermal Casimir force

We investigate the thermal Casimir interaction between two magnetodielectric plates made of real materials. On the basis of the Lifshitz theory, it is shown that for diamagnets and for paramagnets in the broad sense (with exception of ferromagnets) the magnetic properties do not influence the magnitude of the Casimir force. For ferromagnets, taking into account the realistic dependence of magnetic permeability on frequency, we conclude that the impact of magnetic properties on the Casimir interaction arises entirely from the contribution of the zero-frequency term in the Lifshitz formula. The computations of the Casimir free energy and pressure are performed for the configurations of two plates made of ferromagnetic metals (Co and Fe), for one plate made of ferromagnetic metal and the other of nonmagnetic metal (Au), for two ferromagnetic dielectric plates (on the basis of polystyrene), and for a ferromagnetic dielectric plate near a nonmagnetic metal plate. The dielectric permittivity of metals is described using both the Drude and the plasma model approaches. It is shown that the Casimir repulsion through the vacuum gap can be realized in the configuration of a ferromagnetic dielectric plate near a nonmagnetic metal plate described by the plasma model. In all cases considered, the respective analytical results in the asymptotic limit of large separations between the plates are obtained. The impact of the magnetic phase transition through the Curie temperature on the Casimir interaction is considered. In conclusion, we propose several experiments allowing to determine whether the magnetic properties really influence the Casimir interaction and to independently verify the Drude and plasma model approaches to the thermal Casimir force.

cond-mat.other↗
arXiv2009

Thermal Casimir Force between Magnetic Materials

We investigate the Casimir pressure between two parallel plates made of magnetic materials at nonzero temperature. It is shown that for real magnetodielectric materials only the magnetic properties of ferromagnets can influence the Casimir pressure. This influence is accomplished through the contribution of the zero-frequency term of the Lifshitz formula. The possibility of the Casimir repulsion through the vacuum gap is analyzed depending on the model used for the description of the dielectric properties of the metal plates.

quant-ph↗
arXiv2009

On the definition of dielectric permittivity for media with temporal dispersion in the presence of free charge carriers

We show that in the presence of free charge carriers the definition of the frequency-dependent dielectric permittivity requires additional regularization. As an example, the dielectric permittivity of the Drude model is considered and its time-dependent counterpart is derived and analyzed. The respective electric displacement cannot be represented in terms of the standard Fourier integral. The regularization procedure allowing to circumvent these difficulties is suggested. For purpose of comparison it is shown that the frequency-dependent dielectric permittivity of insulators satisfies all rigorous mathematical criteria. This permits us to conclude that in the presence of free charge carriers the concept of dielectric permittivity is not as well defined as for insulators and we make a link to widely discussed puzzles in the theory of thermal Casimir force which might be caused by the use of such kind permittivities.

quant-ph↗
arXiv2009

Why Screening Effects Do Not Influence the Casimir Force

The Lifshitz theory of dispersion forces leads to thermodynamic and experimental inconsistencies when the role of drifting charge carriers is included in the model of the dielectric response. Recently modified reflection coefficients were suggested that take into account screening effects and diffusion currents. We demonstrate that this theoretical approach leads to a violation of the third law of thermodynamics (Nernst's heat theorem) for a wide class of materials and is excluded by the data from two recent experiments. The physical reason for its failure is explained by the violation of thermal equilibrium, which is the fundamental applicability condition of the Lifshitz theory, in the presence of drift and diffusion currents.

quant-ph↗
arXiv2008

Target mass and finite $t$ corrections to diffractive deeply inelastic scattering

The quantum field theoretic treatment of inclusive deep--inelastic diffractive scattering given in a previous paper \cite{BGR2006} is discussed in detail using an equivalent formulation with the aim to derive a representation suitable for data analysis. We consider the off-cone twist--2 light-cone operators to derive the target mass and finite $t$ corrections to diffractive deep--inelastic scattering and deep--inelastic scattering. The corrections turn out to be at most proportional to $x |t|/Q^2, x M^2/Q^2, x = x_{\rm BJ} {\rm or} x_\PP$, which suggests an expansion in these parameters. Their contribution varies in size considering diffractive scattering or meson--exchange processes. Relations between different kinematic amplitudes which are determined by one and the same diffractive GPD or its moments are derived. In the limit $t, M^2 \to 0$ one obtains the results of \cite{Blumlein:2001xf} and \cite{Blumlein:2002fw}.

hep-ph↗
arXiv2008

Comment on "Anomalous temperature dependence of the Casimir force for thin metal films" [arXiv:0712.1395]

Recently V. A. Yampol'skii, S. Savel'ev, Z. A. Mayselis, S. S. Apostolov, and F. Nori [Phys. Rev. Lett., v.101, 096803 (2008),arXiv:0712.1395] claimed that the Casimir force between a thin metal film described by the Drude model and an ideal metal semispace can decrease with temperature whereas for bulk samples the Casimir force increases with temperature. On this basis the experimental observation of the decreasing temperature dependence of the Casimir force magnitude between a film and a bulk ideal metal was proposed. We demonstrate that, contrary to what is claimed by the authors, the magnitude of the Casimir force decreases with temperature in a wide temperature region for bulk samples described by the Drude model. This decrease is shown to be much larger than that for a thin film and it has already been experimentally excluded.

cond-mat.other↗
arXiv2008

Thermal Casimir effect in ideal metal rectangular boxes

The thermal Casimir effect in ideal metal rectangular boxes is considered using the method of zeta functional regularization. The renormalization procedure is suggested which provides the finite expression for the Casimir free energy in any restricted quantization volume. This expression satisfies the classical limit at high temperature and leads to zero thermal Casimir force for systems with infinite characteristic dimensions. In the case of two parallel ideal metal planes the results, as derived previously using thermal quantum field theory in Matsubara formulation and other methods, are reproduced starting from the obtained expression. It is shown that for rectangular boxes the temperature-dependent contribution to the electromagnetic Casimir force can be both positive and negative depending on side lengths. The numerical computations of the scalar and electromagnetic Casimir free energy and force are performed for cubes

quant-ph↗
arXiv2008

Comment on "Possible resolution of the Casimir force finite temperature correction "controversies""

The recently suggested modification of the transverse electric contribution to the Lifshitz formula (S. K. Lamoreaux, arXiv:0801.1283) is discussed. We show that this modification is inconsistent with the data of two precise experiments, and violates the Nernst heat theorem. The preprint's suggestion concerning the resolution of the "apparent violation of the Third Law of Thermodynamics" is shown to be incorrect.

quant-ph↗
arXiv2008

Problems in the theory of thermal Casimir force between dielectrics and semiconductors

The application of the Lifshitz theory to describe the thermal Casimir force between dielectrics and semiconductors is considered. It is shown that for all true dielectrics (i.e., for all materials having zero conductivity at zero temperature) the inclusion of a nonzero conductivity arising at nonzero temperature into the model of dielectric response leads to the violation of the Nernst heat theorem. This result refers equally to simple insulators, intrinsic semiconductors, Mott-Hubbard dielectrics and doped semiconductors with doping concentration below a critical value. We demonstrate that in the insulator-metal transition the Casimir free energy changes abruptly irrespective of whether the conductivity changes continuously or discontinuously. The application of the Lifshitz formula to polar dielectrics results in large thermal correction that is linear in temperature. A rule is formulated on how to apply the Lifshitz theory to real materials in agreement with thermodynamics and experiment.

quant-ph↗
arXiv2008

New approach to the thermal Casimir force between real metals

The new approach to the theoretical description of the thermal Casimir force between real metals is presented. It uses the plasma-like dielectric permittivity that takes into account the interband transitions of core electrons. This permittivity precisely satisfies the Kramers-Kronig relations. The respective Casimir entropy is positive and vanishes at zero temperature in accordance with the Nernst heat theorem. The physical reasons why the Drude dielectric function, when substituted in the Lifshitz formula, is inconsistent with electrodynamics are elucidated. The proposed approach is the single one consistent with all measurements of the Casimir force performed up to date. The application of this approach to metal-type semiconductors is considered.

quant-ph↗
arXiv2007

Comment on ``Precision measurement of the Casimir-Lifshitz force in a fluid''

Recently J.N. Munday and F. Capasso [Phys. Rev. A {\bf 75}, 060102(R) (2007); arXiv:0705.3793] claimed that they have performed a precision measurement of the Casimir force between a sphere and a plate coated with Au, both immersed in ethanol. The measurement results were claimed to be consistent with the Lifshitz theory. We demonstrate that the calculation of the Casimir force between the smooth bodies following the authors prescription has a discrepancy up to 25% with respect to authors result. We show also that the attractive electrostatic force only due to the surface potential differences was underestimated by a factor of 590 and the charge double layer interaction was not taken into account. All this leads to the conclusion that the results of this experiment are in fact uncertain.

physics.atom-ph↗
arXiv2007

Generalized plasma-like permittivity and thermal Casimir force between real metals

The physical reasons why the Drude dielectric function is not compatible with the Lifshitz formula, as opposed to the generalized plasma-like permittivity, are presented. Essentially, the problem is connected with the finite size of metal plates. It is shown that the Lifshitz theory combined with the generalized plasma-like permittivity is thermodynamically consistent.

quant-ph↗
arXiv2007

Heavy Meson Distribution Amplitudes of Definite Geometric Twist with Contribution of 3-Particle Distribution Amplitudes

Under the constraints of HQET the equations of motion of heavy meson distribution amplitudes of definite geometric twist, using the knowledge of their off-cone structure, are reformulated as a set of algebraic equations. Together with equations due to various Dirac structures various relations between the (sets of) independent two- and three particle distribution amplitudes of definite geometric twist are derived and presented using both the notion of (double) Mellin moments and re-summed non-local distribution amplitudes. Resolving these relations for the independent two-particle moments in terms of three-particle double moments we confirmed the representation of $Φ_{\pm|n}$ by Kawamura et al. (Phys. Lett. B \bf{523} (2001) 111).

hep-ph↗