arXiv subjects

Bernard Dussardier

Publications and source records attributed to Bernard Dussardier.

30 records · Page 2Linked to original sources

arXiv2010

Birefringence analysis of multilayer leaky cladding optical fibre

We analyse a multilayer leaky cladding (MLC) fibre using the finite element method and study the effect of the MLC on the bending loss and birefringence of two types of structures: (i) a circular core large-mode-area structure and (ii) an elliptical-small-core structure. In a large-mode-area structure, we verify that the multilayer leaky cladding strongly discriminates against higher order modes to achieve single-mode operation, the fibre shows negligible birefringence, and the bending loss of the fibre is low for bending radii larger than 10 cm. In the elliptical-small-core structure we show that the MLC reduces the birefringence of the fibre. This prevents the structure from becoming birefringent in case of any departures from circular geometry. The study should be useful in the designs of MLC fibres for various applications including high power amplifiers, gain flattening of fibre amplifiers and dispersion compensation.

physics.optics↗

arXiv2010

Energy transfer up-conversion in Tm3+-doped silica fiber

A study of the mechanisms responsible for the infra-red to near infra-red up-conversion in Tm3+-doped silica fibers is presented. Upconversion luminescence was observed from the 3H4 level of Tm3+ under 1586 nm pumping into the 3F4 level. The quadratic dependence of the up-conversion luminescence at 800 nm on the 1800 nm luminescence from the 3F4 level confirms that the 3H4 level is populated by a two photon process. Two possible processes are proposed as mechanisms responsible for the up-conversion: excited state absorption and energy transfer up-conversion. The decay characteristics of the luminescence from the 3H4 level were studied under direct and indirect pumping at 786 and 1586 nm, respectively. By comparing the decay waveforms to the solution of a simple set of rate equations, the energy transfer up-conversion process (3F4, 3F4 ! 3H4, 3H6) was established at Tm2O3 concentrations greater than 200 ppm.

physics.optics↗

arXiv2010

Improvement of the Tm3+:3H4 level lifetime in silica optical fibres by lowering the local phonon energy

The role of some glass network modifiers on the quantum efficiency of the near-infrared fluorescence from the 3H4 level of Tm3+ ion in silica-based doped fibres is studied. Modifications of the core composition affect the spectroscopic properties of Tm3+ ion. Adding 17.4 mol% of AlO3/2 to the core glass caused an increase of the 3H4 level lifetime up to 50 $μ$s, 3.6 times higher than in pure silica glass. The quantum efficiency was increased from 2% to approximately 8%. On the opposite, 8 mol% of PO5/2 in the core glass made the lifetime decrease downto 9 $μ$s. These changes of Tm3+ optical properties are assigned to the change of the local phonon energy to which they are submitted by modifiers located in the vicinity of the doping sites. Some qualitative predictions of the maximum achievable quantum efficiency are possible using a simple microscopic model to calculate the non-radiative de-excitation rates.

physics.optics↗

arXiv2010

Co-axial dual-core resonant leaky fibre for optical amplifiers

We present a co-axial dual-core resonant leaky optical fibre design, in which the outer core is made highly leaky. A suitable choice of parameters can enable us to resonantly couple power from the inner core to the outer core. In a large-core fibre, such a resonant coupling can considerably increase the differential leakage loss between the fundamental and the higher order modes and can result in effective single-mode operation. In a small-core single-mode fibre, such a coupling can lead to sharp increase in the wavelength dependent leakage loss near the resonant wavelength and can be utilized for the suppression of amplified spontaneous emission and thereby gain equalization of an optical amplifier. We study the propagation characteristics of the fibre using the transfer matrix method and present an example of each, the large-mode-area design for high power amplifiers and the wavelength tunable leakage loss design for inherent gain equalization of optical amplifiers.

physics.optics↗

arXiv2010

Passive Temperature-Compensating Technique for Microstructured Fiber Bragg Gratings

The thermal drift of the characteristic wavelength of fiber Bragg gratings (FBGs) photowritten in the core of microstructured fibers (MOFs) is significantly reduced by inserting a liquid of suitable refractive index into their holes. For instance, the spectral range of variations is divided by a factor of 4 over a temperature range larger than 20\degree C in a six-hole MOF, and the maximum sensitivity is reduced. Such passive FBG temperature compensation technique is of great interest for applications involving accurate sensing free of thermal effects.

physics.optics↗

arXiv2009

Long-period fiber grating as wavelength selective element in double-clad Yb-doped fiber-ring lasers

Selection of operating wavelength of the Yb-doped fiber-ring lasers using longperiod fiber gratings (LPFGs) is suggested. In the proposed method, customized LPFG that sustains high powers serves as a broad-band rejection filter. It modifies the net gain profile of the laser, enabling the peak gain to occur at a designed wavelength. Spectral range of oscillation between 1050-1110 nm was experimentally demonstrated. This range can be extended to both shorter and longer wavelengths with proper design of the LPFG and length of the Yb-doped fiber. The gratings were inscribed by CO2 laser and the grating period down to 175 ?m was achieved being, to our best knowledge, the shortest reported LPFG period using this technique.

physics.optics↗

arXiv2009

Design and fabrication of an intrinsically gain flattened Erbium doped fiber amplifier

We report design and subsequent fabrication of an intrinsically gain flattened Erbium doped fiber amplifier (EDFA) based on a highly asymmetrical and concentric dual-core fiber, inner core of which was only partially doped. Phase-resonant optical coupling between the two cores was so tailored through optimization of its refractive index profile parameters that the longer wavelengths within the C-band experience relatively higher amplification compared to the shorter wavelengths thereby reducing the difference in the well-known tilt in the gains between the shorter and longer wavelength regions. The fabricated EDFA exhibited a median gain ?28 dB (gain excursion below $\pm$2.2 dB within the C-band) when 16 simultaneous standard signal channels were launched by keeping the I/P level for each at ?20 dBm/ channel. Such EDFAs should be attractive for deployment in metro networks, where economics is a premium, because it would cut down the cost on gain flattening filter head.

physics.optics↗

arXiv2009

Luminescent Ions in Silica-Based Optical Fibers

We present some of our research activities dedicated to doped silica-based optical fibers, aiming at understanding the spectral properties of luminescent ions, such as rare-earth and transition metal elements. The influence of the local environment on dopants is extensively studied: energy transfer mechanisms between rare-earth ions, control of the valence state of chromium ions, effect of the local phonon energy on thulium ions emission efficiency, and broadening of erbium ions emission induced by oxide nanoparticles. Knowledge of these effects is essential for photonics applications.

physics.optics↗

arXiv2009

Er doped oxide nanoparticles in silica based optical fibres

Erbium doped materials are of great interest in optical telecommunications due to the Er3+ intra-4f emission at 1.54 ?m. Erbium doped fibre amplifiers (EDFA) were developed in silica glass because of the low losses at this wavelength and the reliability of this glass. Developments of new rare earth doped fibre amplifiers aim to control their spectroscopic properties including shape and width of the gain curve and optical quantum efficiency. Standard silica glass modifiers, such as aluminium, result in very good properties in current EDFA. However, for more drastic spectroscopic changes, more important modifications of the rare earth ions local environment are required. To address this aim, we present a fibre fabrication route creating rare earth doped calcia?silica or calcia?phosphosilica nanoparticles embedded in silica glass. By adding alkaline earth elements such as calcium, in low concentration, one can obtain a glass with an immisci- bility gap so that phase separation occurs with an appropriate heat treatment. We investigated the role of two elements: calcium and phosphorus (a standard silica modifier). Scanning electron microscopy shows that nanoparticles are only observed when calcium is incorporated. The size of the particles is determined to be around 50 nm in preform samples. The nature of these particles depends on phosphorus content: without P, electron diffraction shows that the particles are amorphous whilst they are partially crystalline when phosphorus is added. In addition through use of energy dispersive x-ray techniques, we have shown that erbium ions are located in the nanoparticles.

physics.optics↗

arXiv2009

Role of CaO addition in the local order around Erbium in SiO2 ?GeO2 ?P2O5 fiber preforms

The development of materials for optical signal processing represents a major issue in present technology. In this contribution we present a study on Er-doped fiber preforms where particular attention is devoted on how the addition of CaO in the glass modifies the local environment of the rare earth. The results from photoluminescence and Extended X-ray Absorption Fine Structure (EXAFS) are compared and a clear link between the width of the emission line at 1.5 $μ$m and the amorphous/crystalline local structure around the Er3+ ion is evidenced.

physics.optics↗

arXiv2008

Visible and near infra-red up-conversion in Tm3+/Yb3+ co-doped silica fibres under 980 nm excitation

The spectroscopic properties of Tm3+/Yb3+ co-doped silica fibers under excitation at 980 nm are reported. Three distinct up-conversion fluorescence bands were observed in the visible to near infra-red regions. The blue and red fluorescence bands at 475 and 650 nm, respectively, were found to originate from the 1G4 level of Tm3+. A three step up-conversion process was established as the populating mechanism for these fluorescence bands. The fluorescence band at 800 nm was found to originate from two possible transitions in Tm3+; one being the transition from the 3H4 to 3H6 manifold which was found to dominate at low pump powers; the other being the transition from the 1G4 to 3H6 level which dominates at higher pump powers. The fluorescence lifetime of the 3H4 and 3F4 levels of Tm3+ and 2F5/2 level of Yb3+ were studied as a function of Yb3+ concentration, with no significant energy back transfer from Tm3+ to Yb3+ observed.

physics.optics↗

arXiv2008

Thulium environment in a silica doped optical fibre

Thulium-doped optical fibre amplifiers (TDFA) are developed to extend the optical telecommunication wavelength division multiplexing (WDM) bandwidth in the so-called S-band (1460-1530 nm). The radiative transition at 1.47 lm (3H4 -> 3F4) competes with a non-radiative multi-phonon de-excitation (3H4 -> 3H5). The quantum efficiency of the transition of interest is then highly affected by the phonon energy (Ep) of the material. For reliability reasons, oxide glasses are preferred but suffer from high phonon energy. In the case of silica glass, Ep is around 1100 cm-1 and quantum efficiency is as low as 2%. To improve it, phonon energy in the thulium environment must be lowered. For that reason, aluminium is added and we explore three different core compositions: pure silica, and silica slightly modified with germanium or phosphorus. The role of aluminium is studied through fluorescence decay curves, fitted according to the continuous function decay analysis. From this analysis, modification of the thulium local environment due to aluminium is evidenced.

physics.optics↗