arXiv subjects

C. Berger

Publications and source records attributed to C. Berger.

32 records · Page 2Linked to original sources

arXiv2009

Slowing hot carrier relaxation in graphene using a magnetic field

A degenerate pump--probe technique is used to investigate the non equilibrium carrier dynamics in multi--layer graphene. Two distinctly different dynamics of the carrier relaxation are observed. A fast relaxation ($\sim 50$ fs) of the carriers after the initial effect of phase space filling followed by a slower relaxation ($\sim 4$ ps) due to thermalization. Both relaxation processes are less efficient when a magnetic field is applied at low temperatures which is attributed to the suppression of the electron-electron Auger scattering due to the non equidistant Landau level spacing of the Dirac fermions in graphene.

cond-mat.mes-hall↗

arXiv2009

Tuning the electron-phonon coupling in multilayer graphene with magnetic fields

Magneto Raman scattering study of the E$_{2g}$ optical phonons in multi-layer epitaxial graphene grown on a carbon face of SiC are presented. At 4.2K in magnetic field up to 33 T, we observe a series of well pronounced avoided crossings each time the optically active inter Landau level transition is tuned in resonance with the E$_{2g}$ phonon excitation (at 196 meV). The width of the phonon Raman scattering response also shows pronounced variations and is enhanced in conditions of resonance. The experimental results are well reproduced by a model that gives directly the strength of the electron-phonon interaction.

cond-mat.mtrl-sci↗

arXiv2009

First direct observation of a nearly ideal graphene band structure

Angle-resolved photoemission and X-ray diffraction experiments show that multilayer epitaxial graphene grown on the SiC(000-1) surface is a new form of carbon that is composed of effectively isolated graphene sheets. The unique rotational stacking of these films cause adjacent graphene layers to electronically decouple leading to a set of nearly independent linearly dispersing bands (Dirac cones) at the graphene K-point. Each cone corresponds to an individual macro-scale graphene sheet in a multilayer stack where AB-stacked sheets can be considered as low density faults.

cond-mat.mtrl-sci↗

arXiv2008

Magneto-transmission of multi-layer epitaxial graphene and bulk graphite: A comparison

Magneto-transmission of a thin layer of bulk graphite is compared with spectra taken on multilayer epitaxial graphene prepared by thermal decomposition of a SiC crystal. We focus on the spectral features evolving as \sqrt{B}, which are evidence for the presence of Dirac fermions in both materials. Whereas the results on multi-layer epitaxial graphene can be interpreted within the model of 2D Dirac fermions, the data obtained on bulk graphite can only be explained taking into account the 3D nature of graphite, e.g. by using the standard Slonczewski-Weiss-McClure model.

cond-mat.mes-hall↗

arXiv2008

High-Energy Limit of Massless Dirac Fermions in Multilayer Graphene using Magneto-Optical Transmission Spectroscopy

We have investigated the absorption spectrum of multilayer graphene in high magnetic fields. The low energy part of the spectrum of electrons in graphene is well described by the relativistic Dirac equation with a linear dispersion relation. However, at higher energies (>500 meV) a deviation from the ideal behavior of Dirac particles is observed. At an energy of 1.25 eV, the deviation from linearity is 40 meV. This result is in good agreement with the theoretical model, which includes trigonal warping of the Fermi surface and higher-order band corrections. Polarization-resolved measurements show no observable electron-hole asymmetry.

cond-mat.mes-hall↗

arXiv2007

Few layer graphene on SiC, pyrolitic graphite and graphene: a Raman scattering study

The results of micro-Raman scattering measurements performed on three different ``graphitic'' materials: micro-structured disks of highly oriented pyrolytic graphite, graphene multi-layers thermally decomposed from carbon terminated surface of 4H-SiC and an exfoliated graphene monolayer are presented. Despite its multi-layer character, most parts of the surface of the graphitized SiC substrates shows a single-component, Lorentzian shape, double resonance Raman feature in striking similarity to the case of a single graphene monolayer. Our observation suggests a very weak electronic coupling between graphitic layers on the SiC surface, which therefore can be considered to be graphene multi-layers with a simple (Dirac-like) band structure.

cond-mat.mes-hall↗

arXiv2007

Rotational stacking and its electronic effects on graphene films grown on 4H-SiC$(000\bar{1})$

We examine the stacking order of multilayer graphene grown on the SiC$(000\bar{1})$ surface using low-energy electron diffraction and surface X-ray diffraction. We show that the films contain a high density of rotational stacking faults caused by three types of rotated graphene: sheets rotated $30^\circ$ and $\pm 2.20^\circ$ relative to the SiC substrate. These angles are unique because they correspond to commensurate phases of layered graphene, both with itself and with the SiC substrate. {\it Ab intio} calculations show that these rotational phases electronically decouple adjacent graphene layers. The band structure from graphene at fault boundaries displays linear energy dispersion at the $K$-point (Dirac cones), nearly identical to that of a single graphene sheet.

cond-mat.mtrl-sci↗

arXiv2007

Magnetospectroscopy of epitaxial few-layer graphene

The inter-Landau level transitions observed in far-infrared transmission experiments on few-layer graphene samples show a behaviour characteristic of the linear dispersion expected in graphene. This behaviour persists in relatively thick samples, and is qualitatively different from that of thin samples of bulk graphite.

cond-mat.mtrl-sci↗

arXiv2007

The structural properties of the multi-layer graphene/4H-SiC(000-1) system as determined by Surface X-ray Diffraction

We present a structural analysis of the multi-layer graphene-4HSiC(000-1}) system using Surface X-Ray Reflectivity. We show for the first time that graphene films grown on the C-terminated (000-1}) surface have a graphene-substrate bond length that is very short (0.162nm). The measured distance rules out a weak Van der Waals interaction to the substrate and instead indicates a strong bond between the first graphene layer and the bulk as predicted by ab-initio calculations. The measurements also indicate that multi-layer graphene grows in a near turbostratic mode on this surface. This result may explain the lack of a broken graphene symmetry inferred from conduction measurements on this system [C. Berger et al., Science 312, 1191 (2006)].

cond-mat.mtrl-sci↗

arXiv2006

Landau level spectroscopy of ultrathin graphite layers

Far infrared transmission experiments are performed on ultrathin epitaxial graphite samples in a magnetic field. The observed cyclotron resonance-like and electron-positron-like transitions are in excellent agreement with the expectations of a single-particle model of Dirac fermions in graphene, with an effective velocity of c* = 1.03 x 10^6 m/s.

cond-mat.mes-hall↗

arXiv2006

Highly-ordered graphene for two dimensional electronics

With expanding interest in graphene-based electronics, it is crucial that high quality graphene films be grown. Sublimation of Si from the 4H-SiC(0001) Si-terminated) surface in ultrahigh vacuum is a demonstrated method to produce epitaxial graphene sheets on a semiconductor. In this paper we show that graphene grown from the SiC$(000\bar{1})$ (C-terminated) surface are of higher quality than those previously grown on SiC(0001). Graphene grown on the C-face can have structural domain sizes more than three times larger than those grown on the Si-face while at the same time reducing SiC substrate disorder from sublimation by an order of magnitude.

cond-mat.mtrl-sci↗

arXiv2006

Controlled Irradiative Formation of Penitentes

Spike-shaped structures are produced by light-driven ablation in very different contexts. Penitentes 1-4 m high are common on Andean glaciers, where their formation changes glacier dynamics and hydrology. Laser ablation can produce cones 10-100 microns high with a variety of proposed applications in materials science. We report the first laboratory generation of centimeter-scale snow and ice penitentes. Systematically varying conditions allows identification of the essential parameters controlling the formation of ablation structures. We demonstrate that penitente initiation and coarsening requires cold temperatures, so that ablation leads to sublimation rather than melting. Once penitentes have formed, further growth of height can occur by melting. The penitentes intially appear as small structures (3 mm high) and grow by coarsening to 1-5 cm high. Our results are an important step towards understanding and controlling ablation morphologies.

physics.geo-ph↗

arXiv1994

Detection of nuclear recoils in prototype dark matter detectors, made from Al, Sn and Zn Superheated Superconducting Granules

This work is part of an ongoing project to develop a Superheated Superconducting Granule (SSG) detector for cold dark matter and neutrinos. The response of SSG devices to nuclear recoils has been explored irradiating SSG detectors with a 70MeV neutron beam. The aim of the experiment was to test the sensitivity of Sn, Al and Zn SSG detectors to nuclear recoil energies down to a few keV. The detector consisted of a hollow teflon cylinder (0.1cm$^3$ inner volume) filled with tiny superconducting metastable granules embedded in a dielectric medium. The nuclear recoil energies deposited in the SSG were determined measuring the neutron scattering angles with a neutron hodoscope. Coincidences in time between the SSG and the hodoscope signals have been clearly established. In this paper the results of the neutron irradiation experiments at different SSG intrinsic thresholds are discussed and compared to Monte Carlo simulations. The results show that SSG are sensitive to recoil energies down to $\sim$1keV. The limited angular resolution of the neutron hodoscope prevented us from measuring the SSG sensitivity to even lower recoil energies.

cond-mat↗

arXiv1993

Phase Transition Study of Superconducting Microstructures

The presented results are part of a feasibility study of superheated superconducting microstructure detectors. The microstructures (dots) were fabricated using thin film patterning techniques with diameters ranging from $50μ$m up to $500μ$m and thickness of $1μ$m. We used arrays and single dots to study the dynamics of the superheating and supercooling phase transitions in a magnetic field parallel to the dot surface. The phase transi- tions were produced by either varying the applied magnetic field strength at a constant temperature or changing the bath temperature at a constant field. Preliminary results on the dynamics of the phase transitions of arrays and single indium dots will be reported.

cond-mat↗