arXiv subjects

C. P. Dempsey

Publications and source records attributed to C. P. Dempsey.

7 recordsLinked to original sources

arXiv2025

Non-magnetic Fractional Conductance in High Mobility InAs Quantum Point Contacts

In this letter, we report the magneto-electronic properties of high mobility InAs quantum point contacts grown on InP substrates. The 1D conductance reaches a maximum value of 17 plateaus, quantized in units of 2e^2/h, where e is the fundamental unit of charge and h is Planck's constant. The in-plane effective g-factor was estimated to be -10.9 +/- 1.5 for subband N = 1 and -10.8 +/- 1.6 for subband N = 2. Furthermore, a study of the non-magnetic fractional conductance states at 0.2 (e^2/h) and 0.1(e2/h is provided. While their origin remains under discussion, evidence suggests that they arise from strong electron-electron interactions and momentum-conserving backscattering between electrons in two distinct channels within the 1D region. This phenomenon may also be interpreted as an entanglement between the two channel directions facilitated by momentum-conserving backscattering.

cond-mat.mes-hall↗

arXiv2024

Effects of Strain Compensation on Electron Mobilities in InAs Quantum Wells Grown on InP(001)

InAs quantum wells (QWs) grown on InP substrates are interesting for their applications in devices with high spin-orbit coupling (SOC) and their potential role in creating topologically nontrivial hybrid heterostructures. These QWs rely on InGaAs cladding layers and InAlAs barrier layers to confine electrons within a thin InAs well. The highest mobility QWs are limited by interfacial roughness scattering and alloy disorder scattering in the cladding and buffer layers. Increasing QW thickness has been shown to reduce the effect of both of these scattering mechanisms. However, for current state-of-the-art devices with As-based cladding and barrier layers, the critical thickness is limited to $\leq7$ nm. In this report, we demonstrate the use of strain compensation techniques in the In$_x$Ga$_{1-x}$As cladding layers, grown on In$_{0.81}$Al$_{0.19}$As barrier layers, to extend the critical thickness well beyond this limit. We induce tensile strain in the InGaAs cladding layers by reducing the In concentration from In$_{0.81}$Ga$_{0.19}$As to In$_{0.70}$Ga$_{0.30}$As and we observe changes in both the critical thickness of the well and the maximum achievable mobility. The peak electron mobility at 2 K is $1.16\times10^6$ cm$^2/$Vs, with a carrier density of $4.2\times10^{11}$ /cm$^2$. Additionally, we study the quantum lifetime and Rashba spin splitting in the highest mobility device as these parameters are critical to determine if these structures can be used in topologically nontrivial devices.

cond-mat.mes-hall↗

arXiv2023

Large Second-Order Josephson Effect in Planar Superconductor-Semiconductor Junctions

We investigate the current-phase relations of Al/InAs-quantum well planar Josephson junctions fabricated using nanowire shadowing technique. Based on several experiments, we conclude that the junctions exhibit an unusually large second-order Josephson harmonic, the $\sin(2φ)$ term. First, superconducting quantum interference devices (dc-SQUIDs) show half-periodic oscillations, tunable by gate voltages as well as magnetic flux. Second, Josephson junction devices exhibit kinks near half-flux quantum in supercurrent diffraction patterns. Third, half-integer Shapiro steps are present in the junctions. Similar phenomena are observed in Sn/InAs quantum well devices. We perform data fitting to a numerical model with a two-component current phase relation. Analysis including a loop inductance suggests that the sign of the second harmonic term is negative. The microscopic origins of the observed effect remain to be understood. We consider alternative explanations which can account for some but not all of the evidence.

cond-mat.mes-hall↗

arXiv2023

Role of a capping layer on the crystalline structure of Sn thin films grown at cryogenic temperatures on InSb substrates

Metal deposition with cryogenic cooling is widely utilized in the condensed matter community for producing ultra-thin epitaxial superconducting layers on semiconductors. However, a drawback arises when these films return to room temperature, as they tend to undergo dewetting. This issue is mitigated by capping the films with an amorphous layer. In this study, we examined the impact of different in-situ fabricated caps on the structural characteristics of Sn thin films deposited at 80 K on InSb substrates. Regardless of the type of capping, we observed that the films remained smooth upon returning to room temperature and were epitaxial on InSb in the cubic Sn ($α$-Sn) phase. However, we noted a correlation between alumina capping with an electron beam evaporator and an increased presence of tetragonal Sn ($β$-Sn) grains. This suggests that heating from the alumina source may contribute to a partial phase transition in the Sn layer. The existence of the $β$-Sn phase induced superconducting behavior of the films by percolation effect. This study highlights the potential for modifying the structural properties of cryogenic Sn thin films through in-situ capping, paving the way for precise control in the production of superconducting Sn films for integration into quantum computing platforms.

cond-mat.mtrl-sci↗

arXiv2022

Missing odd-order Shapiro steps do not uniquely indicate fractional Josephson effect

Topological superconductivity is expected to spur Majorana zero modes -- exotic states that are also considered a quantum technology asset. Fractional Josephson effect is their manifestation in electronic transport measurements, often under microwave irradiation. A fraction of induced resonances, known as Shapiro steps, should vanish, in a pattern that signifies the presence of Majorana modes. Here we report patterns of Shapiro steps expected in topological Josephson junctions, such as the missing first Shapiro step, or several missing odd-order steps. But our junctions, which are InAs quantum wells with Al contacts, are studied near zero magnetic field, meaning that they are not in the topological regime. We also observe other patterns such as missing even steps and several missing steps in a row, not relevant to topological superconductivity. Potentially responsible for our observations is rounding of not fully developed steps superimposed on non-monotonic resistance versus voltage curves, but several origins may be at play. Our results demonstrate that any single pattern, even striking, cannot uniquely identify topological superconductivity, and a multifactor approach is necessary to unambiguously establish this important phenomenon.

cond-mat.mes-hall↗

arXiv2022

Planar Josephson Junctions Templated by Nanowire Shadowing

More and more materials, with a growing variety of properties, are built into electronic devices. This is motivated both by increased device performance and by the studies of materials themselves. An important type of device is a Josephson junction based on the proximity effect between a quantum material and a superconductor, useful for fundamental research as well as for quantum and other technologies. When both junction contacts are placed on the same surface, such as a two-dimensional material, the junction is called ``planar". One outstanding challenge is that not all materials are amenable to the standard planar junction fabrication. The device quality, rather than the intrinsic characteristics, may be defining the results. Here, we introduce a technique in which nanowires are placed on the surface and act as a shadow mask for the superconductor. The advantages are that the smallest dimension is determined by the nanowire diameter and does not require lithography, and that the junction is not exposed to chemicals such as etchants. We demonstrate this method with an InAs quantum well, using two superconductors - Al and Sn, and two semiconductor nanowires - InAs and InSb. The junctions exhibit critical current levels consistent with transparent interfaces and uniform width. We show that the template nanowire can be operated as a self-aligned electrostatic gate. Beyond single junctions, we create SQUIDs with two gate-tunable junctions. We suggest that our method can be used for a large variety of quantum materials including van der Waals layers, topological insulators, Weyl semimetals and future materials for which proximity effect devices is a promising research avenue.

cond-mat.mes-hall↗

arXiv2019

Parity-preserving and magnetic field resilient superconductivity in indium antimonide nanowires with tin shells

We study bottom-up grown semiconductor indium antimonide nanowires that are coated with shells of tin. The shells are uniform in thickness. The interface between Sn and InSb is abrupt and without interdiffusion. Devices for transport are prepared by in-situ shadowing of nanowires using nearby nanowires as well as flakes, resulting in etch-free junctions. Tin is found to induce a hard superconducting gap in the range 600-700 micro-eV. Superconductivity persists up to 4 T in magnetic field. A tin island exhibits the coveted two-electron charging effect, a hallmark of charge parity stability. The findings open avenues for superconducting and topological quantum circuits based on new superconductor-semiconductor combinations.

cond-mat.mes-hall↗