arXiv subjects

Casey T. DeRoo

Publications and source records attributed to Casey T. DeRoo.

6 recordsLinked to original sources

arXiv2026

X-ray grating spectroscopy as a mission enhancement

We propose to add instruments to any potential future X-ray mission with focussing optics that is considered in NASA's ASTRA framework. Such an instrument is a necessity to study AGN wind outflows and feedback, find the missing baryons, study the intergalactic medium, and analyze abundances and chemical bonds in dust grains throughout the Milky Way. We conclude that those science goals can be achieved with a spectral resolving power > 3000 in the soft X-ray band (about 10-40 Ang) and an effective area a few times larger than current instruments. We describe a possible mission implementation for a soft X-ray grating spectrometer that can be folded in and out or be mounted permanently in the beam. Such an instrument can reach the requirements for a wide variety of host mission properties. A small UV imager and a UV spectrograph can be mounted on the same platform with independent optics. These added instruments vastly enhance the science capabilities of the host mission for a modest cost (100-200 million $) and with weight and power needs that can be easily accommodated in any major mission.

astro-ph.IM↗

arXiv2024

Concept of a Double Tilted Rowland Spectrograph for X-rays

High-resolution spectroscopy in soft X-rays ($<2$ keV) requires diffractive elements to resolve any astrophysically relevant diagnostics, such as closely spaced lines, weak absorption lines, or line profiles. The Rowland torus geometry describes how gratings and detectors need to be positioned to optimize the spectral resolving power. We describe how an on-axis Rowland geometry can be tilted to accommodate blazed gratings. In this geometry, two channels with separate optical axes can share the same detectors (double tilted Rowland spectrograph, DTRS). Small offsets between the channels can mitigate the effect of chip gaps and reduce the alignment requirements during the construction of the instrument. The DTRS concept is especially useful for sub-apertured mirrors, because it allows an effective use of space in the entrance aperture of a spacecraft. One mission that applies this concept is the Arcus Probe.

astro-ph.IM↗

arXiv2022

Searching for outliers in the Chandra Source Catalog

Astronomers are increasingly faced with a deluge of information, and finding worthwhile targets of study in the sea of data can be difficult. Outlier identification studies are a method that can be used to focus investigations by presenting a smaller set of sources that could prove interesting because they do not follow the trends of the underlying population. We apply a principal component analysis (PCA) and an unsupervised random forest algorithm (uRF) to sources from the Chandra Source Catalog v.2 (CSC2). We present 119 high-significance sources that appear in all repeated applications of our outlier identification algorithm (OIA). We analyse the characteristics of our outlier sources and cross-match them with the SIMBAD data base. Our outliers contain several sources that were previously identified as having unusual or interesting features by studies. This OIA leads to the identification of interesting targets that could motivate more detailed study.

astro-ph.HE↗

arXiv2020

Performance Testing of a Large-Format Reflection Grating Prototype for a Suborbital Rocket Payload

The soft X-ray grating spectrometer on board the Off-plane Grating Rocket Experiment (OGRE) hopes to achieve the highest resolution soft X-ray spectrum of an astrophysical object when it is launched via suborbital rocket. Paramount to the success of the spectrometer are the performance of the $>250$ reflection gratings populating its reflection grating assembly. To test current grating fabrication capabilities, a grating prototype for the payload was fabricated via electron-beam lithography at The Pennsylvania State University's Materials Research Institute and was subsequently tested for performance at Max Planck Institute for Extraterrestrial Physics' PANTER X-ray Test Facility. Bayesian modeling of the resulting data via Markov chain Monte Carlo (MCMC) sampling indicated that the grating achieved the OGRE single-grating resolution requirement of $R_{g}(λ/Δλ)>4500$ at the 94% confidence level. The resulting $R_g$ posterior probability distribution suggests that this confidence level is likely a conservative estimate though, since only a finite $R_g$ parameter space was sampled and the model could not constrain the upper bound of $R_g$ to less than infinity. Raytrace simulations of the system found that the observed data can be reproduced with a grating performing at $R_g=\infty$. It is therefore postulated that the behavior of the obtained $R_g$ posterior probability distribution can be explained by a finite measurement limit of the system and not a finite limit on $R_g$. Implications of these results and improvements to the test setup are discussed.

astro-ph.IM↗

arXiv2020

Limiting Spectral Resolution of a Reflection Grating Made via Electron-Beam Lithography

Gratings enable dispersive spectroscopy from the X-ray to the optical, and feature prominently in proposed flagships and SmallSats alike. The exacting performance requirements of these future missions necessitate assessing whether the present state-of-the-art in grating manufacture will limit spectrometer performance. In this work, we manufacture a 1.5 mm thick, 1000 nm period at grating using electron-beam lithography (EBL), a promising lithographic technique for patterning gratings for future astronomical observatories. We assess the limiting spectral resolution of this grating by interferometrically measuring the diffracted wavefronts produced in +/-1st order. Our measurements show this grating has a performance of at least R ~ 14,600, and that our assessment is bounded by the error of our interferometric measurement. The impact of EBL stitching error on grating performance is quantifed, and a path to measuring the period error of customized, curved gratings is presented.

astro-ph.IM↗

arXiv2016

Line Spread Functions of Blazed Off-Plane Gratings Operated in the Littrow Mounting

Future soft X-ray (10 - 50 Angstrom) spectroscopy missions require higher effective areas and resolutions to perform critical science that cannot be done by instruments on current missions. An X-ray grating spectrometer employing off-plane reflection gratings would be capable of meeting these performance criteria. Off-plane gratings with blazed groove facets operated in the Littrow mounting can be used to achieve excellent throughput into orders achieving high resolutions. We have fabricated two off-plane gratings with blazed groove profiles via a technique which uses commonly available microfabrication processes, is easily scaled for mass production, and yields gratings customized for a given mission architecture. Both fabricated gratings were tested in the Littrow mounting at the Max-Planck-Institute for extraterrestrial Physics PANTER X-ray test facility to assess their performance. The line spread functions of diffracted orders were measured, and a maximum resolution of 800 $\pm$ 20 is reported. In addition, we also observe evidence of a `blaze' effect from measurements of relative efficiencies of the diffracted orders.

astro-ph.IM↗