arXiv subjects

Chong Kim

Publications and source records attributed to Chong Kim.

3 recordsLinked to original sources

arXiv2026

Test-Beam Performance of the AstroPix Silicon Sensor for Imaging Calorimetry

AstroPix is a high-voltage CMOS HVCMOS monolithic active pixel sensor MAPS developed for future space-based gamma-ray missions. It is also a candidate technology for the imaging layer of the Barrel Imaging Calorimeter BIC in the ePIC experiment at the future Electron-Ion Collider EIC. We report the first AstroPix test-beam results obtained at the KEK Photon Factory Advanced Ring PF-AR and the CERN Proton Synchrotron PS T10 beam line in 2025, using the third prototype AstroPix-v3. AstroPix-v3 sensors were operated as both standalone tracking layers and imaging layers interleaved with prototype lead/scintillating-fiber Pb/SciFi calorimeter modules, using electron and hadron beams in the few-GeV/c momentum range. Event synchronization between the continuous readout of AstroPix-v3 and the trigger-based readout of the Pb/SciFi calorimeter was achieved using a common timestamp. The AstroPix-v3 sensors exhibit stable performance, reaching a maximum hit efficiency of 68 percent at a bias voltage of -400 V under pion-dominated beam conditions. When combined with the Pb/SciFi calorimeter, the AstroPix layers successfully capture the development of electromagnetic showers. Using Cherenkov-based particle identification, electron-induced events exhibit significantly higher hit multiplicities and broader spatial distributions than pion-induced events, thereby providing clear discrimination between electromagnetic and hadronic showers. These results demonstrate that AstroPix-v3 provides effective, high-granularity imaging of shower development and is well suited as an imaging layer in future calorimeter systems for both collider and space-based experiments.

physics.ins-det↗

arXiv2026

Beam test of a Pb/SciFi prototype for the Barrel Imaging Calorimeter at the Electron-Ion Collider

A Lead-Scintillating Fiber (Pb/SciFi) prototype for the Barrel Imaging Calorimeter (BIC) at the Electron--Ion Collider (EIC) was tested with electron beams at the CERN PS T10 beam line in August 2024. The prototype consisted of unit modules with a sampling structure of lead sheets and scintillating fibers, corresponding to a total depth of approximately $10.9\,X_{0}$. Beam tests were performed with electron momenta between 0.5 and 3~GeV/$c$ to evaluate the energy and timing performance of the prototype. This study characterizes the performance of a Pb/SciFi prototype and provides input for future beam tests, calibration and readout optimization, and the development of larger-scale prototypes.

physics.ins-det↗

arXiv2025

Proposal of the KOTO II experiment

The KOTO II experiment is proposed to measure the branching ratio of the decay $K_L\to\pi^0\nu\bar{\nu}$ at J-PARC. With a beamline to extract long-lived neutral kaons at 5 degrees from a production target, the single event sensitivity of the decay is $8.5\times 10^{-13}$, which is much smaller than the Standard Model prediction $3\times 10^{-11}$. This allows searches for new physics beyond the Standard Model and the first discovery of the decay with a significance exceeding $5\sigma$. As the only experiment proposed in the world dedicated to rare kaon decays, KOTO II will be indispensable in the quest for a complete understanding of flavor dynamics in the quark sector. Moreover, by combining efforts from the kaon community worldwide, we plan to develop the KOTO II detector further and expand the physics reach of the experiment to include measurements of the branching ratio of the $K_L\to\pi^0\ell^+\ell^-$ decays, studies of other $K_L$ decays, and searches for dark photons, axions, and axion-like particles. KOTO II will therefore obtain a comprehensive understanding of $K_L$ decays, providing further constraints on new physics scenarios with existing $K^+$ results.

hep-ex↗