arXiv subjects

Chris Healey

Publications and source records attributed to Chris Healey.

8 recordsLinked to original sources

arXiv2019

Air mode silicon nitride photonic crystals and their application to nonlinear quantum optomechanical sensing

Nanoscale photonic crystal cavity optomechanical devices enable detection of nanomechanical phenomena with a sensitivity sufficient to observe quantum effects. Here we present the design of a one-dimensional air-mode photonic crystal cavity patterned in a silicon nitride nanobeam, and show that it forms the basis for cavity optomechanical split-beam and paddle nanocavity devices useful for force detection and nonlinear quantum sensing. The air-mode of this device is advantageous for optomechanical coupling, while also having ultrahigh optical quality factor $Q_o\sim 10^6$ despite its proximity to the light-line and the relatively low refractive index of silicon nitride. Paddle nanocavities realized from this device have a quadratic coupling coefficient $g^{(2)}/2\pi$~=~10~MHz/nm$^{2}$, and their performance within the context of quantum optomechanics experiments is analyzed.

physics.optics↗

arXiv2018

Hexagonal boron nitride cavity optomechanics

Hexagonal boron nitride (hBN) is an emerging layered material that plays a key role in a variety of two-dimensional devices, and has potential applications in nanophotonics and nanomechanics. Here, we demonstrate the first cavity optomechanical system incorporating hBN. Nanomechanical resonators consisting of hBN beams with predicted thickness between 8 nm and 51 nm were fabricated using electron beam induced etching and positioned in the optical nearfield of silicon microdisk cavities. A 160 fm/$\sqrt{\text{Hz}}$ sensitivity to the hBN nanobeam motion is demonstrated, allowing observation of thermally driven mechanical resonances with frequencies between 1 and 23 MHz, and mechanical quality factors reaching 1100 at room temperature in high vacuum. In addition, the role of air damping is studied via pressure dependent measurements. Our results constitute an important step towards realizing integrated optomechanical circuits employing hBN.

physics.optics↗

arXiv2015

Design and experimental demonstration of optomechanical paddle nanocavities

We present the design, fabrication and initial characterization of a paddle nanocavity consisting of a suspended sub-picogram nanomechanical resonator optomechanically coupled to a photonic crystal nanocavity. The optical and mechanical properties of the paddle nanocavity can be systematically designed and optimized, and key characteristics including mechanical frequency easily tailored. Measurements under ambient conditions of a silicon paddle nanocavity demonstrate an optical mode with quality factor $Q_o$ ~ 6000 near 1550 nm, and optomechanical coupling to several mechanical resonances with frequencies $\omega_m/2\pi$ ~ 12-64 MHz, effective masses $m_\text{eff}$ ~ 350-650 fg, and mechanical quality factors $Q_m$ ~ 44-327. Paddle nanocavities are promising for optomechanical sensing and nonlinear optomechanics experiments.

physics.optics↗

arXiv2014

Nonlinear optomechanical paddle nanocavities

Nonlinear optomechanical coupling is the basis for many potential future experiments in quantum optomechanics (e.g., quantum non-demolition measurements, preparation of non-classical states), which to date have been difficult to realize due to small non-linearity in typical optomechanical devices. Here we introduce an optomechanical system combining strong nonlinear optomechanical coupling, low mass and large optical mode spacing. This nanoscale "paddle nanocavity" supports mechanical resonances with hundreds of fg mass which couple nonlinearly to optical modes with a quadratic optomechanical coupling coefficient $g^{(2)} > 2\pi\times400$ MHz/nm$^2$, and a two phonon to single photon optomechanical coupling rate $\Delta \omega_0 > 2\pi\times 16$ Hz. This coupling relies on strong phonon-photon interactions in a structure whose optical mode spectrum is highly non--degenerate. Nonlinear optomechanical readout of thermally driven motion in these devices should be observable for T $> 50 $ mK, and measurement of phonon shot noise is achievable. This shows that strong nonlinear effects can be realized without relying on coupling between nearly degenerate optical modes, thus avoiding parasitic linear coupling present in two mode systems.

quant-ph↗

arXiv2014

Dissipative and Dispersive Optomechanics in a Nanocavity Torque Sensor

Dissipative and dispersive optomechanical couplings are experimentally observed in a photonic crystal split-beam nanocavity optimized for detecting nanoscale sources of torque. Dissipative coupling of up to approximately $500$ MHz/nm and dispersive coupling of $2$ GHz/nm enable measurements of sub-pg torsional and cantilever-like mechanical resonances with a thermally-limited torque detection sensitivity of 1.2$\times 10^{-20} \text{N} \, \text{m}/\sqrt{\text{Hz}}$ in ambient conditions and 1.3$\times 10^{-21} \text{N} \, \text{m}/\sqrt{\text{Hz}}$ in low vacuum. Interference between optomechanical coupling mechanisms is observed to enhance detection sensitivity and generate a mechanical-mode-dependent optomechanical wavelength response.

cond-mat.mes-hall↗

arXiv2013

Raman quantum memory based on an ensemble of nitrogen-vacancy centers coupled to a microcavity

We propose a scheme to realize optical quantum memories in an ensemble of nitrogen-vacancy centers in diamond that are coupled to a micro-cavity. The scheme is based on off-resonant Raman coupling, which allows one to circumvent optical inhomogeneous broadening and store optical photons in the electronic spin coherence. This approach promises a storage time of order one second and a time-bandwidth product of order 10$^7$. We include all possible optical transitions in a 9-level configuration, numerically evaluate the efficiencies and discuss the requirements for achieving high efficiency and fidelity.

quant-ph↗

arXiv2011

Characterization of an InGaAs/InP single-photon detector at 200 MHz gate rate

We characterize a near-infrared single-photon detector based on an InGaAs/InP avalanche photodiode and the self-differencing post-processing technique. It operates at gate rates of 200 MHz and higher. The compact, integrated design employs printed circuit boards and features a semiconductor-based self-differencing subtraction implemented with a fully differential amplifier. At a single-photon detection efficiency of 6.4%, the detector has a dark count probability of 9x10^-7 per gate, an afterpulse probability of 6.3% per detection event, a detection time jitter of 150 ps, and a dead time of 5 ns (equivalent to one gate period). Furthermore, it can be operated as a standard photodiode, which benefits applications that require detecting single photons as well as strong light signals.

quant-ph↗

arXiv2011

Time-cost analysis of a quantum key distribution system clocked at 100 MHz

We describe the realization of a quantum key distribution (QKD) system clocked at 100 MHz. The system includes classical postprocessing implemented via software, and is operated over a 12 km standard telecommunication dark fiber in a real-world environment. A time-cost analysis of the sifted, error-corrected, and secret key rates relative to the raw key rate is presented, and the scalability of our implementation with respect to higher secret key rates is discussed.

quant-ph↗