Searcharxiv⌕ Search

arXiv subjects

Christian Ruder

Publications and source records attributed to Christian Ruder.

7 recordsLinked to original sources

Soft X-Ray Detection Down to the Nitrogen K-Edge Using a Pixelated iLGAD Sensor

Hybrid pixel detectors represent the state-of-the-art technology for hard X-ray experiments at synchrotron light sources and free-electron lasers, owing to their high frame rates, extended dynamic range, and scalable detection areas. However, their application in the soft X-ray regime remains bottlenecked by the challenge of developing a sensor that can achieve high quantum efficiency and an sufficient signal-to-noise ratio at low photon energies. Here, we present inverse low-gain avalanche diode (iLGAD) sensors integrated with a thin entrance window, demonstrating single-photon resolution down to 390 eV (below the Nitrogen K-edge) with a signal-to-noise ratio of 5. Two gain layer designs, standard gain layer and shallow gain layer, were systematically investigated to evaluate their spectral response as a function of photon energy and operating temperature. A double-peak feature is observed in the energy spectrum, arising from the dependence of charge multiplication on photon absorption depth. Furthermore, a phenomenological spectral fitting model was established, enabling the quantitative extraction of the effective $\mathrm{n}^+$ layer thickness and gain layer depth. Beyond providing a fundamental understanding of iLGAD charge multiplication mechanisms and characterization results in the soft X-ray regime, these findings lay the foundation for developing large-area, high-frame-rate hybrid pixel detectors for soft X-ray. This advancement directly benefits soft X-ray photon science applications, including high-resolution ptychography, spectroscopy, and resonant scattering at synchrotron and FEL beamlines.

physics.ins-det↗

Enhanced micrometre spatial resolution and usable photon flux for hybrid pixel detectors via deep-learning-based X-ray localization

Micrometre spatial resolution is achieved for X-rays with the MÖNCH detector, a charge-integrating hybrid pixel detector with a 25 μm pixel pitch, by exploiting charge sharing between neighbouring pixels. The conventional analytical interpolation method, however, relies on a global mapping derived from the charge-sharing statistics and is applicable only to isolated single-photon clusters, which limits both the achievable resolution and the usable photon flux. To overcome these limitations, we trained deep learning models to localize single-photon and pile-up events based on high-fidelity simulation data. For knife-edge measurements at 12 keV and a low occupancy of 0.74% (photons per pixel and frame), where single-photon events dominate, the proposed method reaches a of the edge spread function of 1.36 μm, compared with 1.54 μm for the conventional eta interpolation. We demonstrate experimentally that resolving up to three photons per cluster raises the reconstruction efficiency from 59% to 93% at a 2.4{\times} higher occupancy of 1.81%, while preserving a of 1.39 μm.

physics.ins-det↗

Characterization of iLGADs using soft X-rays

Experiments at synchrotron radiation sources and X-ray Free-Electron Lasers in the soft X-ray energy range ($250$eV--$2$keV) stand to benefit from the adaptation of the hybrid silicon detector technology for low energy photons. Inverse Low Gain Avalanche Diode (iLGAD) sensors provide an internal gain, enhancing the signal-to-noise ratio and allowing single photon detection below $1$keV using hybrid detectors. In addition, an optimization of the entrance window of these sensors enhances their quantum efficiency (QE). In this work, the QE and the gain of a batch of different iLGAD diodes with optimized entrance windows were characterized using soft X-rays at the Surface/Interface:Microscopy beamline of the Swiss Light Source synchrotron. Above $250$eV, the QE is larger than $55\%$ for all sensor variations, while the charge collection efficiency is close to $100\%$. The average gain depends on the gain layer design of the iLGADs and increases with photon energy. A fitting procedure is introduced to extract the multiplication factor as a function of the absorption depth of X-ray photons inside the sensors. In particular, the multiplication factors for electron- and hole-triggered avalanches are estimated, corresponding to photon absorption beyond or before the gain layer, respectively.

physics.ins-det↗

Development of LGAD sensors with a thin entrance window for soft X-ray detection

We show the developments carried out to improve the silicon sensor technology for the detection of soft X-rays with hybrid X-ray detectors. An optimization of the entrance window technology is required to improve the quantum efficiency. The LGAD technology can be used to amplify the signal generated by the X-rays and to increase the signal-to-noise ratio, making single photon resolution in the soft X-ray energy range possible. In this paper, we report first results obtained from an LGAD sensor production with an optimized thin entrance window. Single photon detection of soft X-rays down to 452~eV has been demonstrated from measurements, with a signal-to-noise ratio better than 20.

physics.ins-det↗

Design and first tests of the Gotthard-II readout ASIC for the European X-ray Free-Electron Laser

Gotthard-II is a charge-integrating microstrip detector developed for experiments and diagnostics at free-electron lasers using hard X-rays of 5 keV - 20 keV. Thanks to its excellent single photon sensitivity, large dynamic range as well as high frame rate of 4.5 MHz in burst mode, its potential scientific applications include X-ray absorption/emission spectroscopy, hard X-ray high resolution single-shot spectrometry (HiREX), beam diagnostics, as well as veto signal generation for pixel detectors. The Gotthard-II ASIC has been designed and fabricated using UMC-110 nm technology. The final ASIC design and performance in terms of noise, linearity, dynamic range, coupling between channels and speed will be discussed in the paper. In addition, a first measurement of an X-ray absorption spectrum of a standard copper sample has been done. The performance of the Gotthard-II in an experiment using energy dispersive X-rays has been demonstrated.

physics.ins-det↗

Performance Evaluation of the Analogue Front-End and ADC Prototypes for the Gotthard-II Development

Gotthard-II is a silicon microstrip detector developed for the European X-ray Free-Electron Laser (XFEL.EU). Its potential scientific applications include X-ray absorption/emission spectroscopy, hard X-ray high resolution single-shot spectrometry (HiREX), energy dispersive experiments at 4.5 MHz frame rate, beam diagnostics, as well as veto signal generation for pixel detectors. Gotthard-II uses a silicon microstrip sensor with a pitch of 50 $μ$m or 25 $μ$m and with 1280 or 2560 channels wire-bonded to readout chips (ROCs). In the ROC, an adaptive gain switching pre-amplifier (PRE), a fully differential Correlated-Double-Sampling (CDS) stage, an Analog-to-Digital Converter (ADC) as well as a Static Random-Access Memory (SRAM) capable of storing all the 2700 images in an XFEL.EU bunch train will be implemented. Several prototypes with different designs of the analogue front-end (PRE and CDS) and ADC test structures have been fabricated in UMC-110 nm CMOS technology and their performance has been evaluated. In this paper, the performance of the analogue front-end and ADC will be summarized.

physics.ins-det↗

Towards Gotthard-II: Development of A Silicon Microstrip Detector for the European X-ray Free-Electron Laser

Gotthard-II is a 1-D microstrip detector specifically developed for the European X-ray Free-Electron Laser. It will not only be used in energy dispersive experiments but also as a beam diagnostic tool with additional logic to generate veto signals for the other 2-D detectors. Gotthard-II makes use of a silicon microstrip sensor with a pitch of either 50 μm or 25 μm and with 1280 or 2560 channels wire-bonded to adaptive gain switching readout chips. Built-in analog-to-digital converters and digital memories will be implemented in the readout chip for a continuous conversion and storage of frames for all bunches in the bunch train. The performance of analogue front-end prototypes of Gotthard has been investigated in this work. The results in terms of noise, conversionngain, dynamic range, obtained by means of infrared laser and X-rays, will be shown. In particular, the effects of the strip-to-strip coupling are studied in detail and it is found that the reduction of the coupling effects is one of the key factors for the development of the analogue front-end of Gotthard-II.

physics.ins-det↗