arXiv subjects

Christian Seassal

Publications and source records attributed to Christian Seassal.

22 records · Page 2Linked to original sources

arXiv2013

Absorption control in pseudodisordered photonic-crystal thin film

The positive effects of various perturbations introduced in a bidimensional photonic-crystal patterned membrane on its integrated absorption are investigated numerically and theoretically. Two phenomena responsible for the enhanced absorption observed are identified: an increase of the spectral density of modes, obtained thanks to folding mechanisms in the reciprocal lattice, and a better coupling of the modes with the incident light. By introducing a proper pseudodisordered pattern, we show that those two effects can be exploited so as to overcome the integrated absorption obtained for an optimized and single pattern unit cell photonic crystal.

physics.optics↗

arXiv2013

Modal approach for tailoring the absorption in a photonic crystal membrane

In this paper, we propose a method for tailoring the absorption in a photonic crystal membrane. For that purpose, we first applied Time Domain Coupled Mode Theory to such a subwavelength membrane and demonstrated that 100% resonant absorption can be reached even for a symmetric membrane, if degenerate modes are involved. Design rules were then derived from this model in order to tune the absorption. Subsequently, Finite Difference Time Domain simulations were used as a proof of concept and carried out on a low absorbing material (extinction coefficient=10-2) with a high refractive index corresponding to the optical indices of amorphous silicon at around 720 nm. In doing so, 85% resonant absorption was obtained, which is significantly higher than the commonly reported 50% maximum value. Those results were finally analyzed and confronted to theory so as to extend our method to other materials, configurations and applications.

physics.optics↗

arXiv2012

Optically optimal wavelength-scale patterned ITO/ZnO composite coatings for thin film solar cells

A methodology is proposed for finding structures that are, optically speaking, locally optimal : a physical analysis of much simpler structures is used to constrain the optimization process. The obtained designs are based on a flat amorphous silicon layer (to minimize recombination) with a patterned anti-reflective coating made of ITO or ZnO, or a composite ITO/ZnO coating. These latter structures are realistic and present good performances despite very thin active layers.

physics.optics↗

arXiv2009

Absorption enhancement in amorphous silicon photonic crystals for thin film photovoltaic solar cells

We report on very high enhancement of thin layer's absorption through band-engineering of a photonic crystal structure. We realized amorphous silicon (aSi) photonic crystals, where slow light modes improve absorption efficiency. We show through simulation that an increase of the absorption by a factor of 1.5 is expected for a film of aSi. The proposal is then validated by an experimental demonstration, showing an important increase of the absorption of a layer of aSi over a spectral range of 0.32-0.76 microns.

cond-mat.mtrl-sci↗