arXiv subjects

Christian Ulysse

Publications and source records attributed to Christian Ulysse.

11 recordsLinked to original sources

arXiv2026

Characterization of Aluminum Microwave SQUID Multiplexers for CE$\nu$NS Detection

We present the design, fabrication, and characterization of an aluminum-based six-channel microwave SQUID multiplexer ($\mu$MUX) prototype for transition-edge sensor (TES) readout in the RICOCHET experiment. The device consists of aluminum coplanar-waveguide resonators and RF SQUIDs with Dolan-style Al/AlO$_x$/Al Josephson junctions. By measuring the resonator scattering parameters at a range of probe tone frequencies, powers, and flux bias points, we demonstrate agreement between the device response and existing multiplexer models. We also characterize the noise performance in both open-loop and flux-ramping modes. With a high electron mobility transistor (HEMT) amplifier, open-loop measurements yield a flux sensitivity of 1-1.5 $\mu\Phi_0/\sqrt{Hz}$. With flux-ramp modulation, low-frequency 1/f noise is suppressed, and the flux sensitivity is around 3-4 $\mu\Phi_0/\sqrt{Hz}$, corresponding to a current sensitivity of 24-33 $pA/\sqrt{Hz}$ at the input coil. We further demonstrate a reduction in readout noise by incorporating a Josephson traveling-wave parametric amplifier (JTWPA) between the $\mu$MUX and the HEMT. This achieves an open-loop flux sensitivity of 0.3-0.6 $\mu\Phi_0/\sqrt{Hz}$ and an effective system noise temperature below 1 K. These results establish aluminum $\mu$MUX devices as a viable and extensible readout technology for low-noise cryogenic detector arrays.

physics.ins-det↗

arXiv2025

Characterization of mini-CryoCube detectors from the Ricochet experiment commissioning at the Institut Laue-Langevin

The Ricochet experiment aims to measure the coherent elastic neutrino-nucleus scattering process from antineutrinos emitted by a research nuclear reactor operated by the Institut Laue-Langevin (Grenoble, France). This article presents a description of the Ricochet experimental installation and the detector performance achieved during its commissioning with a mini-CryoCube module consisting of three 42-gram germanium cryogenic calorimeters. The baseline resolutions and background levels are reported both during reactor-on and reactor-off periods, and as noise mitigation techniques were improved. A baseline resolution of 40 eV electron equivalent was achieved for the ionization channel after setup improvements, and the phonon channel resolutions ranged from 50 to 80 eV of total phonon energy. In the energy region from 2 to 7 keV, a nuclear recoil rate of 15(2) events/(kg day keV) is measured during the reactor-off period selecting events in coincidence with muon veto signals. This rate is in agreement with the cosmogenic neutron rate calculated from GEANT4 simulations. After the rejection of events in coincidence with signals in the muon veto detectors, a combined 90% C.L. limit on the nuclear recoil background of < 9 events/(kg day keV) is obtained in that energy region during the reactor-on period, which is compatible with our GEANT4 model calculation corresponding to a total rate of 5 events/(kg day keV). The sensitivity of this analysis was however found to be limited by a surface event contamination which is currently being addressed by the Ricochet Collaboration with upgraded detectors.

hep-ex↗

arXiv2020

Dynamic properties of high-Tc superconducting nano-junctions made with a focused helium ion beam

The Josephson junction (JJ) is the corner stone of superconducting electronics and quantum information processing. While the technology for fabricating low $T_{c}$ JJ is mature and delivers quantum circuits able to reach the "quantum supremacy", the fabrication of reproducible and low-noise high-$T_{c}$ JJ is still a challenge to be taken up. Here we report on noise properties at RF frequencies of recently introduced high-$T_{c}$ Josephson nano-junctions fabricated by mean of a Helium ion beam focused at sub-nanometer scale on a $\mathrm{YBa}_2\mathrm{Cu}_3\mathrm{O}_7$ thin film. We show that their current-voltage characteristics follow the standard Resistively-Shunted-Junction (RSJ) circuit model, and that their characteristic frequency $f_{c}=(2e/h)I_{c}R_{n}$ reaches $\sim 300$ GHz at low temperature. Using the "detector response" method, we evidence that the Josephson oscillation linewidth is only limited by the thermal noise in the RSJ model for temperature ranging from $T\sim 20$ K to $75$ K. At lower temperature and for the highest He irradiation dose, the shot noise contribution must also be taken into account when approaching the tunneling regime. We conclude that these Josephson nano-junctions present the lowest noise level possible, which makes them very promising for future applications in the microwave and terahertz regimes.

cond-mat.supr-con↗

arXiv2019

High-Tc superconducting detector for highly-sensitive microwave magnetometry

We have fabricated arrays of High-T$_c$ Superconducting Quantum Interference Devices (SQUIDs) with randomly distributed loop sizes as sensitive antennas for Radio-Frequency (RF) waves. These sub-wavelength size devices known as Superconducting Quantum Interference Filters (SQIFs) detect the magnetic component of the electromagnetic field. We use a scalable ion irradiation technique to pattern the circuits and engineer the Josephson junctions needed to make SQUIDs. Here we report on a 300 SQUIDs series array with loops area ranging from $6$ to $60\ μm^{2}$, folded in a meander line covering a $3.5\ mm\times 8\ mm$ substrate area, made out of a $150$-nm-thick $\mathrm{YBa}_2\mathrm{Cu}_3\mathrm{O}_7$ film. Operating at a temperature $T=66\ K$ in a un-shielded magnetic environment, under low DC bias current ($I=60\ μA$) and DC magnetic field ($B=3\ μT$), this SQIF can detect a magnetic field of a few $pT$ at a frequency of $1.125\ GHz$, which corresponds to a sensitivity of a few hundreds of $fT/\sqrt{Hz}$, and shows linear response over 7 decades in RF power. This work is a promising approach for the realization of low dissipative sub-wavelength GHz magnetometers.

cond-mat.supr-con↗

arXiv2018

Static and Radio-frequency magnetic response of high Tc Superconducting Quantum Interference Filters made by ion irradiation

Superconducting Quantum Interference Filters (SQIF) are promising devices for Radio- Frequency (RF) detection combining low noise, high sensitivity, large dynamic range and wide-band capabilities. Impressive progress have been made recently in the field, with SQIF based antennas and amplifiers showing interesting properties in the GHz range using the well-established Nb/AlOx technology. The possibility to extend these results to High Temperature Superconductors (HTS) is still open, and different techniques to fabricate HTS SQIFs are competing to make RF devices. We report on the DC and RF response of a High Temperature SQIF fabricated by the ion irradiation technique. It is made of 1000 Superconducting QUantum Interference Devices (SQUIDs) in series, with loop areas randomly distributed between 6 micron2 and 60 micron2. The DC transfer factor is around 450 V/T at optimal bias and temperature, and the maximum voltage swing around 2:5 mV . We show that such a SQIF detects RF signals up to 150 MHz. It presents linear characteristics for RF power spanning more than five decades, and non-linearities develop beyond PRF = -35 dBm in our set-up configuration. Second-harmonic generation has been shown to be minimum at the functioning point in the whole range of frequencies. A model has been developed which captures the essential features of the SQIF RF response.

physics.app-ph↗

arXiv2017

Resonance fluorescence revival in a voltage-controlled semiconductor quantum dot

We demonstrate systematic resonance fluorescence recovery with near-unity emission efficiency in single quantum dots embedded in a charge-tunable device in a wave-guiding geometry. The quantum dot charge state is controlled by a gate voltage, through carrier tunneling from a close-lying Fermi sea, stabilizing the resonantly photocreated electron-hole pair. The electric field cancels out the charging/discharging mechanisms from nearby traps toward the quantum dots, responsible for the usually observed inhibition of the resonant fluorescence. Fourier transform spectroscopy as a function of the applied voltage shows a strong increase of the coherence time though not reaching the radiative limit. These charge controlled quantum dots act as quasi-perfect deterministic single-photon emitters, with one laser pulse converted into one emitted single photon.

cond-mat.mes-hall↗

arXiv2017

Transport in a Single Self-Doped Nanocrystal

Addressing the optical properties of a single nanoparticle in the infrared is particularly challenging, thus alternative methods for characterizing the conductance spectrum of nanoparticles in this spectral range need to be developed. Here we describe an efficient method of fabricating single nanoparticle tunnel junctions on a chip circuit. We apply this method to narrow band gap nanoparticles of HgSe, which band structure combine the inverted character of the bulk semimetal with quantum confinement and self-doping. Upon tuning the gate bias, measurement reveals the presence of two energy gaps in the spectrum. The wider gap results from the interband gap, while the narrower gap results from intraband transitions. The observation of the latter near zero gate voltage confirms the doped character of the nanoparticle at the single particle level, which is in full agreement with the ensemble optical and transport measurements. Finally we probe the phototransport within a single quantum dot and demonstrate a large photogain mechanism resulting from photogating.

cond-mat.mes-hall↗

arXiv2014

Josephson mixers for terahertz detection

We report on an experimental and theoretical study of the high-frequency mixing properties of ion-irradiated YBa2Cu3O7 Josephson junctions embedded in THz antennas. We investigated the influence of the local oscillator power and frequency on the device performances. The experimental data are compared with theoretical predictions of the general three-port model for mixers, in which the junction is described by the resistively shunted junction model. A good agreement is obtained for the conversion efficiency in different frequency ranges, spanning above and below the characteristic frequencies fc of the junctions.

cond-mat.supr-con↗

arXiv2013

Three-dimensional emission from organic Fabry-Perot microlasers

We measured the far-field emission patterns in three dimensions of flat organic dye microlasers using a solid angle scanner. Polymer-based microcavities of ribbon shape (i.e., Fabry-Perot type) were investigated. Out of plane emission from the cavities was observed, with significant differences for the two cases of resonators either fully supported by the substrate or sustained by a pedestal. In both cases, the emission diagrams are accounted for by a model combining diffraction at the cavity edges and reflections from the substrate.

physics.optics↗

arXiv2011

Identification and selection rules of the spin-wave eigen-modes in a normally magnetized nano-pillar

We report on a spectroscopic study of the spin-wave eigen-modes inside an individual normally magnetized two layers circular nano-pillar (Permalloy$|$Copper$|$Permalloy) by means of a Magnetic Resonance Force Microscope (MRFM). We demonstrate that the observed spin-wave spectrum critically depends on the method of excitation. While the spatially uniform radio-frequency (RF) magnetic field excites only the axially symmetric modes having azimuthal index $\ell=0$, the RF current flowing through the nano-pillar, creating a circular RF Oersted field, excites only the modes having azimuthal index $\ell=+1$. Breaking the axial symmetry of the nano-pillar, either by tilting the bias magnetic field or by making the pillar shape elliptical, mixes different $\ell$-index symmetries, which can be excited simultaneously by the RF current. Experimental spectra are compared to theoretical prediction using both analytical and numerical calculations. An analysis of the influence of the static and dynamic dipolar coupling between the nano-pillar magnetic layers on the mode spectrum is performed.

cond-mat.mtrl-sci↗

arXiv2009

High domain wall velocity at zero magnetic field induced by low current densities in spin-valve nanostripes

Current-induced magnetic domain wall motion at zero magnetic field is observed in the permalloy layer of a spin-valve-based nanostripe using photoemission electron microscopy. The domain wall movement is hampered by pinning sites, but in between them high domain wall velocities (exceeding 150 m/s) are obtained for current densities well below $10^{12} \unit{A/m^2}$, suggesting that these trilayer systems are promising for applications in domain wall devices in case of well controlled pinning positions. Vertical spin currents in these structures provide a potential explanation for the increase in domain wall velocity at low current densities.

cond-mat.mtrl-sci↗