arXiv subjects

D. Gunnarsson

Publications and source records attributed to D. Gunnarsson.

13 recordsLinked to original sources

arXiv2023

Thermal transport in nanoelectronic devices cooled by on-chip magnetic refrigeration

On-chip demagnetization refrigeration has recently emerged as a powerful tool for reaching microkelvin electron temperatures in nanoscale structures. The relative importance of cooling on-chip and off-chip components and the thermal subsystem dynamics are yet to be analyzed. We study a Coulomb blockade thermometer with on-chip copper refrigerant both experimentally and numerically, showing that dynamics in this device are captured by a first-principles model. Our work shows how to simulate thermal dynamics in devices down to microkelvin temperatures, and outlines a recipe for a low-investment platform for quantum technologies and fundamental nanoscience in this novel temperature range.

cond-mat.mes-hall↗

arXiv2017

On-chip magnetic cooling of a nanoelectronic device

We demonstrate significant cooling of electrons in a nanostructure below 10 mK by demagnetisation of thin-film copper on a silicon chip. Our approach overcomes the typical bottleneck of weak electron-phonon scattering by coupling the electrons directly to a bath of refrigerated nuclei, rather than cooling via phonons in the host lattice. Consequently, weak electron-phonon scattering becomes an advantage. It allows the electrons to be cooled for an experimentally useful period of time to temperatures colder than the dilution refrigerator platform, the incoming electrical connections, and the host lattice. There are efforts worldwide to reach sub-millikelvin electron temperatures in nanostructures to study coherent electronic phenomena and improve the operation of nanoelectronic devices. On-chip magnetic cooling is a promising approach to meet this challenge. The method can be used to reach low, local electron temperatures in other nanostructures, obviating the need to adapt traditional, large demagnetisation stages. We demonstrate the technique by applying it to a nanoelectronic primary thermometer that measures its internal electron temperature. Using an optimised demagnetisation process, we demonstrate cooling of the on-chip electrons from 9 mK to below 5 mK for over 1000 seconds.

cond-mat.mes-hall↗

arXiv2015

Nanoelectronic thermometers optimised for sub-10 millikelvin operation

We report the cooling of electrons in nanoelectronic Coulomb blockade thermometers below 4 mK. Above 7 mK the devices are in good thermal contact with the environment, well isolated from electrical noise, and not susceptible to self-heating. This is attributed to an optimised design that incorporates cooling fins with a high electron-phonon coupling and on-chip electronic filters, combined with a low-noise electronic measurement setup. Below 7 mK the electron temperature is seen to diverge from the ambient temperature. By immersing a Coulomb Blockade Thermometer in the 3He/4He refrigerant of a dilution refrigerator, we measure a lowest electron temperature of 3.7 mK.

cond-mat.mes-hall↗

arXiv2013

Primary thermometry in the intermediate Coulomb blockade regime

We investigate Coulomb blockade thermometers (CBT) in an intermediate temperature regime, where measurements with enhanced accuracy are possible due to the increased magnitude of the differential conductance dip. Previous theoretical results show that corrections to the half width and to the depth of the measured conductance dip of a sensor are needed, when leaving the regime of weak Coulomb blockade towards lower temperatures. In the present work, we demonstrate experimentally that the temperature range of a CBT sensor can be extended by employing these corrections without compromising the primary nature or the accuracy of the thermometer.

cond-mat.mes-hall↗

arXiv2011

Strain enhanced electron cooling in a degenerately doped semiconductor

Enhanced electron cooling is demonstrated in a strained-silicon/superconductor tunnel junction refrigerator of volume 40 um^3. The electron temperature is reduced from 300 mK to 174 mK, with the enhancement over an unstrained silicon control (300 mK to 258 mK) being attributed to the smaller electron-phonon coupling in the strained case. Modeling and the resulting predictions of silicon-based cooler performance are presented. Further reductions in the minimum temperature are expected if the junction sub-gap leakage and tunnel resistance can be reduced. However, if only tunnel resistance is reduced, Joule heating is predicted to dominate.

cond-mat.mes-hall↗

arXiv2011

Strain control of electron-phonon energy loss rate in many-valley semiconductors

We demonstrate significant modification of the electron-phonon energy loss rate in a many-valley semiconductor system due to lattice mismatch induced strain. We show that the thermal conductance from the electron system to the phonon bath in strained n + Si, at phonon temperatures between 200 mK and 450 mK, is more than an order of magnitude lower than that for a similar unstrained sample.

cond-mat.mes-hall↗

arXiv2010

Ex-situ Tunnel Junction Process Technique Characterized by Coulomb Blockade Thermometry

We investigate a wafer scale tunnel junction fabrication method, where a plasma etched via through a dielectric layer covering bottom Al electrode defines the tunnel junction area. The ex-situ tunnel barrier is formed by oxidation of the bottom electrode in the junction area. Room temperature resistance mapping over a 150 mm wafer give local deviation values of the tunnel junction resistance that fall below 7.5 % with an average of 1.3 %. The deviation is further investigated by sub-1 K measurements of a device, which has one tunnel junction connected to four arrays consisting of N junctions (N = 41, junction diameter 700 nm). The differential conductance is measured in single-junction and array Coulomb blockade thermometer operation modes. By fitting the experimental data to the theoretical models we found an upper limit for the local tunnel junction resistance deviation of ~5 % for the array of 2N+1 junctions. This value is of the same order as the minimum detectable deviation defined by the accuracy of our experimental setup.

cond-mat.mtrl-sci↗

arXiv2008

Highly sensitive and broadband carbon nanotube radio-frequency single-electron transistor

We have investigated radio-frequency single-electron transistor (RF-SET) operation of single-walled carbon nanotube quantum dots in the strong tunneling regime. At 4.2 K and carrier frequency 754.2 MHz, we reach a charge sensitivity of 2.3e-6 e/Hz^(1/2) over a bandwidth of 85 MHz. Our results indicate a gain-bandwidth product of 3.7e13 Hz^(3/2)/e, which is by one order of magnitude better than for typical RF-SETs.

cond-mat.other↗

arXiv2006

Shot noise of a multiwalled carbon nanotube field effect transistor

We have investigated shot noise in a 6-nm-diameter, semiconducting multiwalled carbon nanotube FET at 4.2 K over the frequency range 600 - 950 MHz. We find a transconductance of 3 - 3.5 $μ$S for optimal positive and negative source-drain voltages V. For the gate referred input voltage noise, we obtain 0.2 and 0.3 $μ{V}/ \sqrt{Hz}$ for V>0 and V<0, respectively. As effective charge noise this corresponds to $2-3 \cdot 10^{-5}$ e/$\sqrt{Hz}$.

cond-mat.mes-hall↗

arXiv2005

Observation of quantum capacitance in the Cooper-pair transistor

We have fabricated a Cooper-pair transistor (CPT) with parameters such that for appropriate voltage biases, the sub-gap charge transport takes place via slow tunneling of quasiparticles that link two Josephson-coupled charge manifolds. In between the quasiparticle tunneling events, the CPT behaves essentially like a single Cooper-pair box (SCB). The effective capacitance of a SCB can be defined as the derivative of the induced charge with respect to gate voltage. This capacitance has two parts, the geometric capacitance, C_geom, and the quantum capacitance C_Q. The latter is due to the level anti-crossing caused by the Josephson coupling. It depends parametrically on the gate voltage and is dual to the Josephson inductance. Furthermore, it's magnitude may be substantially larger than C_geom. We have been able to detect C_Q in our CPT, by measuring the in-phase and quadrature rf-signal reflected from a resonant circuit in which the CPT is embedded. C_Q can be used as the basis of a charge qubit readout by placing a Cooper-pair box in such a resonant circuit.

cond-mat.supr-con↗

arXiv2005

SET Backaction on the Single Electron Box

We report an experimental observation of the backaction of a Single Electron Transistor (SET) measuring the Coulomb staircase of a single electron box. As current flows through the SET, the charge state of the SET island fluctuates. These fluctuations capacitively couple to the box and cause changes in the position, width, and asymmetry of the Coulomb staircase. A sequential tunnelling model accurately recreates these effects, confirming this mechanism of the backaction of an SET. This is a first step towards understanding the effects of quantum measurement on solid state qubits.

cond-mat.mes-hall↗

arXiv2004

Coherent dynamics of a Josephson charge qubit

We have fabricated a Josephson charge qubit by capacitively coupling a single-Cooper-pair box (SCB) to an electrometer based upon a single-electron transistor configured for radio-frequency readout (RF-SET). Charge quantization of 2e is observed and microwave spectroscopy is used to extract the Josephson and charging energies of the box. We perform coherent manipulation of the SCB by using very fast DC pulses and observe quantum oscillations in time of the charge that persist to ~=10ns. The observed contrast of the oscillations is high and agrees with that expected from the finite E_J/E_C ratio and finite rise-time of the DC pulses. In addition, we are able to demonstrate nearly 100% initial charge state polarization. We also present a method to determine the relaxation time T_1 when it is shorter than the measurement time T_{meas}.

cond-mat.supr-con↗

arXiv2002

Noise in the Single Electron Transistor and its back action during measurement

Single electron transistors (SETs) are very sensitive electrometers and they can be used in a range of applications. In this paper we give an introduction to the SET and present a full quantum mechanical calculation of how noise is generated in the SET over the full frequency range, including a new formula for the quantum current noise. The calculation agrees well with the shot noise result in the low frequency limit, and with the Nyquist noise in the high frequency limit. We discuss how the SET and in particular the radio-frequency SET can be used to read out charge based qubits such as the single Cooper pair box. We also discuss the backaction which the SET will have on the qubit. The back action is determined by the spectral power of voltage fluctuations on the SET island. We will mainly treat the normal state SET but many of the results are also valid for superconducting SETs.

cond-mat.mes-hall↗