arXiv subjects

D. Kullgren

Publications and source records attributed to D. Kullgren.

3 recordsLinked to original sources

arXiv2026

The beamformed trigger of RNO-G: its design and in-field performance

The Radio Neutrino Observatory in Greenland (RNO-G) is a neutrino detector under construction at Summit Station, with 8 out of a planned 35 stations currently deployed. We have designed and deployed a new phased array (PA) trigger based on delay-and-sum beamforming and power integration. This trigger improves detector performance by suppressing thermal noise and better targeting neutrino-induced Askaryan signals. The new PA trigger has been deployed since the 2025 season. The trigger performance has been characterized using test pulses and calibration pulsers both in the lab and in-situ, and we find across these tests a 25% average reduction in the signal-to-noise ratio (SNR) needed to trigger on signals. Simulations are shown to be representative of the detector, and simulated trigger efficiencies are within 10% of measured data. Following the in-situ trigger validation, we use data-driven trigger performance to inform simulations of the detector effective volumes. The PA trigger increases our effective volume significantly, by over a factor of 2 below 0.1 EeV and at least a factor of 1.3 at the highest energies of 100 EeV.

astro-ph.IM↗

arXiv2026

Trigger system for the Payload for Ultrahigh Energy Observations (PUEO) balloon-borne neutrino detector

The Payload for Ultrahigh Energy Observations (PUEO) is a NASA balloon-borne instrument for the detection of ultra-high energy (UHE) neutrinos with energies above $10^{17.5}~\textrm{eV}$ via either the Askaryan effect or geomagnetic emissions from an upward-going air shower. The main instrument trigger system for PUEO is a fully digital supersample rate beamformer based on 24 Xilinx Radio Frequency System-on-a-Chip (RFSoC) digitizers sampling 192 channels operating at $3~\textrm{GSa/s}$ and a system clock frequency of $375~\textrm{MHz}$. The trigger implements frequency band conditioning, dynamic radio-frequency interference (RFI) rejection, and matched filtering, with significant emphasis on optimization to reduce both the power and resource usage while maintaining sensitivity. The system implements 48 total synthetic antenna beams with up to 8 antennas each, covering a $\sim25^\circ$ range in zenith and $\sim60^\circ$ range in azimuth. Preflight testing demonstrated a trigger performance of a minimum signal-to-noise ratio (SNR) of $\sim1.5$ using simulated signals while consuming between $5-7~\textrm{W}$ in the trigger logic.

astro-ph.IM↗

arXiv2025

Validating the performance of the Radio Neutrino Observatory in Greenland using cosmic-ray air showers

The Radio Neutrino Observatory in Greenland (RNO-G) is currently under construction with the aim to detect neutrinos with energies beyond $\sim 10\,\mathrm{PeV}$. A critical part of early detector commissioning is the study of detector characteristics and potential backgrounds, for which cosmic rays play a crucial role. In this article, we report that the number of cosmic rays detected with RNO-G's shallow antennas is consistent with expectations. We further verified the agreement in the observed cosmic-ray signal shape with expectations from simulations after careful treatment of the detector systematics. Finally, we find that the reconstructed arrival direction, energy, and polarization of the cosmic-ray candidates agrees with expectations. Throughout this study, we identified detector shortcomings that are mitigated going forward. Overall, the analysis presented here is an essential first step towards validating the detector and high-fidelity neutrino detection with RNO-G in the future.

astro-ph.HE↗