arXiv subjects

E. Firu

Publications and source records attributed to E. Firu.

14 recordsLinked to original sources

arXiv2024

Study of the Involvement of $^8$Be and $^9$B Nuclei in the Dissociation of Relativistic $^{10}$C, $^{10}$B, and $^{12}$C Nuclei

The results obtained by estimating the contribution of $^8$Be and $^9$B nuclei to the coherent dissociation of $^{10}$C, $^{10}$B, and $^{12}$C relativistic nuclei in nuclear track emulsions (``white'' stars) are presented. The selection of ``white'' stars accompanied by $^9$B leads to a distinct peak appearing in the distribution of the excitation energy of 2$\alpha$2$p$ ensembles and having a maximum at 4.1 $\pm$ 0.3 MeV. A $^8$Be nucleus manifests itself in the coherent-dissociation reaction $^{10}$B $\to$ 2He + H with a probability of (25 $\pm$ 5)\%, (14 $\pm$ 3)\% of it being due to $^9$B decays. The ratio of the branching fractions of the $^9$B + $n$ and $^9$Be + $p$ mirror channels is estimated at 6 $\pm$ 1. An analysis of the relativistic dissociation of $^{12}$C nuclei in a nuclear track emulsion revealed nine 3$\alpha$ events corresponding to the Hoyle state.

nucl-ex↗

arXiv2024

Dissociation of Relativistic $^{10}$B Nuclei in Nuclear Track Emulsion

The structural features of $^{10}$B are studied by analyzing the dissociation of nuclei of this isotope at an energy of 1 A GeV in nuclear track emulsion. The fraction of the $^{10}$B $\to$ 2He + H channel in the charge state distribution of fragments is 78\%. It was determined based on the measurements of fragment emission angles that unstable $^{8}$Be$_{g.s.}$ nuclei appear with a probability of (26 $\pm$ 4)\%, and (14 $\pm$ 3)\% of them are produced in decays of an unstable $^9$B$_{g.s.}$ nucleus. The Be + H channel was suppressed to approximately 1\%.

nucl-ex↗

arXiv2020

Radiation hardness of GaAs: Cr and Si sensors irradiated by electron beam

The interest in using the radiation detectors based on high resistive chromium-compensated GaAs (GaAs:Cr) in high energy physics and others applied fields has been growing steadily due to its numerous advantages over others classical materials. High radiation hardness at room temperature stands out and needs to be systematically investigated. In this paper an experimental study of the effect of 20.9 MeV electrons generated by the LINAC-200 accelerator on some properties of GaAs:Cr based sensors is presented. In parallel, Si sensors were irradiated at the same conditions, measured and analyzed in order to perform a comparative study. The target sensors were irradiated with the dose up to 1.5 MGy. The current-voltage characteristics, resistivity, charge collection efficiency and their dependences on the bias voltage and temperature were measured at different absorbed doses. An analysis of the possible microscopic mechanisms leading to the observed effects in GaAs:Cr sensors is presented in the article.

physics.ins-det↗

arXiv2020

Unstable states in dissociation of relativistic nuclei. Recent findings and prospects of researches

The invariant mass method is used to identify the $^8$Be and $^9$B nuclei and Hoyle state formed in dissociation of relativistic nuclei in a nuclear track emulsion. It is shown that to identify these extremely short-lived states in the case of the isotopes $^9$Be, $^{10}$B, $^{10}$C, $^{11}$C, $^{12}$C, and $^{16}$O, it is sufficient to determine the invariant mass as a function of the angles in pairs and triples of He and H fragments in the approximation of the conservation of momentum per nucleon of the parent nucleus. According to the criteria established in this way, the contribution of these three unstable states was evaluated in the relativistic fragmentation of the $^{28}$Si and $^{197}$Au nuclei.

nucl-ex↗

arXiv2019

Detector Technologies for CLIC

The Compact Linear Collider (CLIC) is a high-energy high-luminosity linear electron-positron collider under development. It is foreseen to be built and operated in three stages, at centre-of-mass energies of 380 GeV, 1.5 TeV and 3 TeV, respectively. It offers a rich physics program including direct searches as well as the probing of new physics through a broad set of precision measurements of Standard Model processes, particularly in the Higgs-boson and top-quark sectors. The precision required for such measurements and the specific conditions imposed by the beam dimensions and time structure put strict requirements on the detector design and technology. This includes low-mass vertexing and tracking systems with small cells, highly granular imaging calorimeters, as well as a precise hit-time resolution and power-pulsed operation for all subsystems. A conceptual design for the CLIC detector system was published in 2012. Since then, ambitious R&D programmes for silicon vertex and tracking detectors, as well as for calorimeters have been pursued within the CLICdp, CALICE and FCAL collaborations, addressing the challenging detector requirements with innovative technologies. This report introduces the experimental environment and detector requirements at CLIC and reviews the current status and future plans for detector technology R&D.

physics.ins-det↗

arXiv2019

Toward ternary fission accompanied by the ${}^{8}$Be nucleus

Experiments in preparation for search for uranium ternary fission by means of nuclear track emulsion are summarized. The study will be focused on the possible involvement of the unstable nucleus ${}^{8}$Be in the suggested scenario of the collinear tri-partition in the fission.

nucl-ex↗

arXiv2018

Performance and Moli`ere radius measurements using a compact prototype of LumiCal in an electron test beam

A new design of a detector plane of sub-millimetre thickness for an electromagnetic sampling calorimeter is presented. It is intended to be used in the luminometers LumiCal and BeamCal in future linear $e^+e^-$ collider experiments. The detector planes were produced utilising novel connectivity scheme technologies. They were installed in a compact prototype of the calorimeter and tested at DESY with an electron beam of energy 1-5 GeV. The performance of a prototype of a compact LumiCal comprising eight detector planes was studied. The effective Moli`ere radius at 5 GeV was determined to be (8.1 +/- 0.1 (stat) +/- 0.3 (syst)) mm, a value well reproduced by the Monte Carlo (MC) simulation (8.4 +/- 0.1) mm. The dependence of the effective Moli`ere radius on the electron energy in the range 1-5 GeV was also studied. Good agreement was obtained between data and MC simulation.

physics.ins-det↗

arXiv2018

Nuclear track emulsion in search for the Hoyle-state in dissociation of relativistic ${}^{12}$C nuclei

Production of ensembles of $\alpha$-particle triples associated with the Hoyle state (the second excited state of the ${}^{12}$C nucleus) in peripheral dissociation of relativistic ${}^{12}$C nuclei is studied. Stacks of nuclear track emulsion pellicles exposed to ${}^{12}$C with an energy from hundreds MeV to a few GeV per nucleon serve as the material for studies. The Hoyle state decays are reconstructed via measurement of emission angles of $\alpha$ particles with the precision sufficient for identification of the unstable ${}^{8}$Be nucleus. The estimate of the contribution of Hoyle's state to the ${}^{12}$C $\to$ 3$\alpha$ dissociation is 10-15\%.

nucl-ex↗

arXiv2017

Study of tau-neutrino production at the CERN SPS

The DsTau project proposes to study tau-neutrino production in high-energy proton interactions. The outcome of this experiment are prerequisite for measuring the $\nu_\tau$ charged-current cross section that has never been well measured. Precisely measuring the cross section would enable testing of lepton universality in $\nu_\tau$ scattering and it also has practical implications for neutrino oscillation experiments and high-energy astrophysical $\nu_\tau$ observations. $D_s$ mesons, the source of tau neutrinos, following high-energy proton interactions will be studied by a novel approach to detect the double-kink topology of the decays $D_s \rightarrow \tau\nu_\tau$ and $\tau\rightarrow\nu_\tau X$. Directly measuring $D_s\rightarrow \tau$ decays will provide an inclusive measurement of the $D_s$ production rate and decay branching ratio to $\tau$. The momentum reconstruction of $D_s$ will be performed by combining topological variables. This project aims to detect 1,000 $D_s \rightarrow \tau$ decays in $2.3 \times 10^8$ proton interactions in tungsten target to study the differential production cross section of $D_s$ mesons. To achieve this, state-of-the-art emulsion detectors with a nanometric-precision readout will be used. The data generated by this project will enable the $\nu_\tau$ cross section from DONUT to be re-evaluated, and this should significantly reduce the total systematic uncertainty. Furthermore, these results will provide essential data for future $\nu_\tau$ experiments such as the $\nu_\tau$ program in the SHiP project at CERN. In addition, the analysis of $2.3 \times 10^8$ proton interactions, combined with the expected high yield of $10^5$ charmed decays as by-products, will enable the extraction of additional physical quantities.

hep-ex↗

arXiv2017

Measurement of shower development and its Moli\`ere radius with a four-plane LumiCal test set-up

A prototype of a luminometer, designed for a future e+e- collider detector, and consisting at present of a four-plane module, was tested in the CERN PS accelerator T9 beam. The objective of this beam test was to demonstrate a multi-plane tungsten/silicon operation, to study the development of the electromagnetic shower and to compare it with MC simulations. The Moli\`ere radius has been determined to be 24.0 +/- 0.6 (stat.) +/- 1.5 (syst.) mm using a parametrization of the shower shape. Very good agreement was found between data and a detailed Geant4 simulation.

physics.ins-det↗

arXiv2016

Higgs Physics at the CLIC Electron-Positron Linear Collider

The Compact Linear Collider (CLIC) is an option for a future e+e- collider operating at centre-of-mass energies up to 3 TeV, providing sensitivity to a wide range of new physics phenomena and precision physics measurements at the energy frontier. This paper is the first comprehensive presentation of the Higgs physics reach of CLIC operating at three energy stages: sqrt(s) = 350 GeV, 1.4 TeV and 3 TeV. The initial stage of operation allows the study of Higgs boson production in Higgsstrahlung (e+e- -> ZH) and WW-fusion (e+e- -> Hnunu), resulting in precise measurements of the production cross sections, the Higgs total decay width Gamma_H, and model-independent determinations of the Higgs couplings. Operation at sqrt(s) > 1 TeV provides high-statistics samples of Higgs bosons produced through WW-fusion, enabling tight constraints on the Higgs boson couplings. Studies of the rarer processes e+e- -> ttH and e+e- -> HHnunu allow measurements of the top Yukawa coupling and the Higgs boson self-coupling. This paper presents detailed studies of the precision achievable with Higgs measurements at CLIC and describes the interpretation of these measurements in a global fit.

hep-ex↗

arXiv2014

ECFA Detector R&D Panel, Review Report

Two special calorimeters are foreseen for the instrumentation of the very forward region of an ILC or CLIC detector; a luminometer (LumiCal) designed to measure the rate of low angle Bhabha scattering events with a precision better than 10$^{-3}$ at the ILC and 10$^{-2}$ at CLIC, and a low polar-angle calorimeter (BeamCal). The latter will be hit by a large amount of beamstrahlung remnants. The intensity and the spatial shape of these depositions will provide a fast luminosity estimate, as well as determination of beam parameters. The sensors of this calorimeter must be radiation-hard. Both devices will improve the e.m. hermeticity of the detector in the search for new particles. Finely segmented and very compact electromagnetic calorimeters will match these requirements. Due to the high occupancy, fast front-end electronics will be needed. Monte Carlo studies were performed to investigate the impact of beam-beam interactions and physics background processes on the luminosity measurement, and of beamstrahlung on the performance of BeamCal, as well as to optimise the design of both calorimeters. Dedicated sensors, front-end and ADC ASICs have been designed for the ILC and prototypes are available. Prototypes of sensor planes fully assembled with readout electronics have been studied in electron beams.

physics.ins-det↗

arXiv2014

Performance of fully instrumented detector planes of the forward calorimeter of a Linear Collider detector

Detector-plane prototypes of the very forward calorimetry of a future detector at an e+e- collider have been built and their performance was measured in an electron beam. The detector plane comprises silicon or GaAs pad sensors, dedicated front-end and ADC ASICs, and an FPGA for data concentration. Measurements of the signal-to-noise ratio and the response as a function of the position of the sensor are presented. A deconvolution method is successfully applied, and a comparison of the measured shower shape as a function of the absorber depth with a Monte-Carlo simulation is given.

physics.ins-det↗

arXiv2010

Study of Peripheral Collisions of 56fe at 1 a Gev/c in Nuclear Emulsion

We have investigated the interactions of 1 A GeV 56Fe in nuclear emulsion. We measured the charge and the angular distributions of single and multiple charged relativistic particles emitted from peripheral interactions. We investigate a possible new method of separating interactions of electromagnetic origin. We provide the values of several parameters evaluated in a sample selected using the classical method, and the method proposed in this paper.

nucl-ex↗