arXiv subjects

E. Tatulli

Publications and source records attributed to E. Tatulli.

30 records · Page 2Linked to original sources

arXiv2008

Milli-arcsecond astrophysics with VSI, the VLTI spectro-imager in the ELT era

Nowadays, compact sources like surfaces of nearby stars, circumstellar environments of stars from early stages to the most evolved ones and surroundings of active galactic nuclei can be investigated at milli-arcsecond scales only with the VLT in its interferometric mode. We propose a spectro-imager, named VSI (VLTI spectro-imager), which is capable to probe these sources both over spatial and spectral scales in the near-infrared domain. This instrument will provide information complementary to what is obtained at the same time with ALMA at different wavelengths and the extreme large telescopes.

astro-ph↗

arXiv2007

De-biasing interferometric visibilities in VLTI-AMBER data of low SNR observations

AIMS: We have found that the interferometric visibilities of VLTI-AMBER observations, extracted via the standard reduction package, are significantly biased when faint targets are concerned. The visibility biases derive from a time variable fringing effect (correlated noise) appearing on the detector. METHODS: We have developed a method to correct this bias that consists in a subtraction of the extra power due to such correlated noise, so that the real power spectrum at the spatial frequencies of the fringing artifact can be restored. RESULTS: This pre-processing procedure is implemented in a software, called AMDC and available to the community, to be run before the standard reduction package. Results obtained on simulated and real observations are presented and discussed.

astro-ph↗

arXiv2006

VLTI/AMBER interferometric observations of the recurrent Nova RS Oph 5.5 days after outburst

We report on interferometric AMBER/VLTI observations of the recurrent nova RS Oph five days after its outburst on 2006 Feb 12. Using three baselines from 44 to 86m, and a spectral resolution of 1500, we measured the extension of the emission in the K band continuum and in the BrG and HeI2.06 micron lines. The continuum visibilities were interpreted by fitting simple geometric models consisting of uniform and Gaussian ellipses, ring and binary models. The visibilities and differential phases in the BrG line were interpreted using skewed ring models aiming to perform a limited parametric reconstruction of the extension and kinematics of the line forming region. The limited uv coverage does not allow discrimination between filled models and rings. Binary models are discarded because the measured closure phase in the continuum is close to zero. The visibilities in the lines are at a low level compared to their nearby continuum, consistent with a more extended line forming region for HeI2.06 than BrG. The ellipse models for the continuum and for the lines are highly flattened and share the same position angle. Two radial velocity fields are apparent in the BrG line: a 'slow' expanding ring-like structure (v~1800km/s), and a 'fast' structure extended in the E-W direction (v~2500-3000km/s). These results confirm the basic fireball model, contrary to the conclusions of other interferometric observations conducted by Monnier et al. (2006).

astro-ph↗

arXiv2006

Direct constraint on the distance of y2 Velorum from AMBER/VLTI observations

In this work, we present the first AMBER observations, of the Wolf-Rayet and O (WR+O) star binary system y2 Velorum. The AMBER instrument was used with the telescopes UT2, UT3, and UT4 on baselines ranging from 46m to 85m. It delivered spectrally dispersed visibilities, as well as differential and closure phases, with a resolution R = 1500 in the spectral band 1.95-2.17 micron. We interpret these data in the context of a binary system with unresolved components, neglecting in a first approximation the wind-wind collision zone flux contribution. We show that the AMBER observables result primarily from the contribution of the individual components of the WR+O binary system. We discuss several interpretations of the residuals, and speculate on the detection of an additional continuum component, originating from the free-free emission associated with the wind-wind collision zone (WWCZ), and contributing at most to the observed K-band flux at the 5% level. The expected absolute separation and position angle at the time of observations were 5.1±0.9mas and 66±15° respectively. However, we infer a separation of 3.62+0.11-0.30 mas and a position angle of 73+9-11°. Our analysis thus implies that the binary system lies at a distance of 368+38-13 pc, in agreement with recent spectrophotometric estimates, but significantly larger than the Hipparcos value of 258+41-31 pc.

astro-ph↗

arXiv2006

Constraining the wind launching region in Herbig Ae stars: AMBER/VLTI spectroscopy of HD104237

We investigate the origin of the $\mathrm{Br}γ$ emission of the Herbig Ae star HD104237 on Astronomical Unit (AU) scales. Using AMBER/VLTI at a spectral resolution R=1500 spatially resolve the emission in both the BrGamma line and the adjacent continuum. The visibility does not vary between the continuum and the BrGamma line, even though the line is strongly detected in the spectrum, with a peak intensity 35% above the continuum. This demonstrates that the line and continuum emission have similar size scales. We assume that the K-band continuum excess originates in a ``puffed-up'' inner rim of the circumstellar disk, and discuss the likely origin of BrGamma. We conclude that this emission most likely arises from a compact disk wind, launched from a region 0.2-0.5 AU from the star, with a spatial extent similar to that of the near infrared continuum emission region, i.e, very close to the inner rim location.

astro-ph↗

arXiv2006

Interferometric data reduction with AMBER/VLTI.Principle,estimators and illustration

We present in this paper an innovative data reduction method for single-mode interferometry. It has been specifically developed for the AMBER instrument, the three-beam combiner of the Very Large Telescope Interferometer, but can be derived for any single-mode interferometer. The algorithm is based on a direct modelling of the fringes in the detector plane. As such, it requires a preliminary calibration of the instrument in order to obtain the calibration matrix which builds the linear relationship between the interferogram and the interferometric observable, that is the complex visibility. Once the calibration procedure has been performed, the signal processing appears to be a classical least square determination of a linear inverse problem. From the estimated complex visibility, we derive the squared visibility, the closure phase and the spectral differential phase. The data reduction procedures are gathered into the so-called amdlib software, now available for the community, and presented in this paper. Furthermore, each step of this original algorithm is illustrated and discussed from various on-sky observations conducted with the VLTI, with a focus on the control of the data quality and the effective execution of the data reduction procedures. We point out the present limited performances of the instrument due to VLTI instrumental vibrations, difficult to calibrate.

astro-ph↗

arXiv2006

Comparison of Fourier and model-based estimators in single mode multiaxial interferometry

There are several solutions to code the signal arising from optical long baseline multi-aperture interferometers. In this paper,we focus on the {\bf non homothetic spatial coding scheme} (multiaxial) with the fringe pattern coded along one dimension on one detector(all-in-one). After describing the physical principles governing single mode interferometers using that sort of recombination scheme, we analyze two different existing methods that measure the source visibility. The first technique, so-called Fourier estimator, consists in integrating the high frequency peak of the power spectral density of the interferogram. The second method, so-called model-based estimator, has been specifically developed for the AMBER instrument of the VLTI and deals with directly modelling the interferogram recorded on the detector. Performances of both estimators are computed in terms of Signal to Noise Ratio (SNR) of the visibility, assuming that the interferograms are perturbed by photon and detector noises. Theoretical expressions of the visibility SNR are provided, validated through numerical computations and then compared. We show that the model-based estimator offers up to 5 times better performances than the Fourier one.

astro-ph↗

arXiv2005

Disk and wind interaction in the young stellar object MWC 297 spatially resolved with VLTI/AMBER

The young stellar object MWC 297 has been observed with the VLT interferometer equipped with the AMBER instrument. MWC 297 has been spatially resolved in the continuum with a visibility of 0.50 as well as in the Br gamma emission line where the visibility decrease to a lower value of 0.33. This change in the visibility with the wavelength can be interpreted by the presence of an optically thick disk responsible for the visibility in the continuum and of a stellar wind traced by Br gamma and whose apparent size is 40% larger. We validate this interpretation by building a model of the stellar environment that combines a geometrically thin, optically thick accretion disk model consisting of gas and dust, and a latitude-dependent stellar wind outflowing above the disk surface. The continuum emission and visibilities obtained from this model are fully consistent with the interferometric AMBER data. They agree also with existing optical, near-infrared spectra and other broad-band near-infrared interferometric visibilities. A picture emerges in which MWC 297 is surrounded by an equatorial flat disk that is possibly still accreting and an outflowing wind which has a much higher velocity in the polar region than at the equator. [abridged]

astro-ph↗

arXiv2005

First AMBER/VLTI observations of hot massive stars

AMBER is the first near infrared focal instrument of the VLTI. It combines three telescopes and produces spectrally resolved interferometric measures. This paper discusses some preliminary results of the first scientific observations of AMBER with three Unit Telescopes at medium (1500) and high (12000) spectral resolution. We derive a first set of constraints on the structure of the circumstellar material around the Wolf Rayet Gamma2 Velorum and the LBV Eta Carinae.

astro-ph↗

arXiv2005

Fiber optic interferometry: Statistics of visibility and closure phase

Interferometric observations with three telescopes or more provide two observables: closure phase information together with visibilities measurements. When using single-mode interferometers, both observables have to be redefined in the light of the coupling phenomenon betwe en the incoming wavefront and the fiber. We introduce in this paper the estimator of both so-called modal visibility and modal closure phase. Then, we compute the statistics of the two observables in presence of partial correction by Adaptive Optics. From this theoretical analysis, data reduction process using classical least square minimization is investigated. In the framework of the AMBER instrument, the three beams recombiner of the VLTI, we simulate the observation of a single Gaussian source and we study the performances of the interferometer in terms of diameter measurements. We show that the observation is optimized, i.e. that the Signal to Noise Ratio (SNR) of the diameter is maximal, when the full width half maximum (FWHM) of the source is roughly 1/2 of the mean resolution of the interferometer. We finally point out that in the case of an observation with 3 telescopes, neglecting the correlation between the measurements leads to overestimate the SNR by a factor of $\sqrt{2}$. We infer that in any cases, this value is an upper limit.

astro-ph↗

arXiv2005

Disentangling the wind and the disk in the close surrounding of the young stellar object MWC297 with AMBER/VLTI

The young stellar object MWC297 is a B1.5Ve star exhibiting strong hydrogen emission lines. This object has been observed by the AMBER/VLTI instrument in 2-telescope mode in a sub-region of the K spectral band centered around the Br gamma line at 2.1656 microns. The object has not only been resolved in the continuum with a visibility of 0.50+/-0.10, but also in the Br gamma line, where the flux is about twice larger, with a visibility about twice smaller (0.33+/-0.06). The continuum emission is consistent with the expectation of an optically thick thermal emission from dust in a circumstellar disk. The hydrogen emission can be understood by the emission of a halo above the disk surface. It can be modelled as a latitudinal-dependant wind model and it explains the width, the strength and the visibibility through the emission lines. The AMBER data associated with a high resolution ISAAC spectrum constrains the apparent size of the wind but also its kinematics.

astro-ph↗

arXiv2004

Single-Mode versus multimode interferometry: a performance study

We compare performances of ground-based single-mode and multimode (speckle) interferometers in the presence of partial Adaptive Optics correction of atmospheric turbulence. It is first shown that for compact sources (i.e. sources smaller than the Airy disk of a single telescope) not entirely resolved by the interferometer, the remarkable property of spatial filtering of single-mode waveguides coupled with AO correction significantly reduces the speckle noise which arises from residual wavefront corrugations. Focusing on those sources, and in the light of the AMBER experiment (the near infrared instrument of the VLTI), we show that single-mode interferometry produces a better Signal-to-Noise Ratio on the visibility than speckle interferometry. This is true for bright sources (K < 5), and in any case as soon as Strehl ratio of 0.2 is achieved. Finally, the fiber estimator is much more robust -- by two orders of magnitude -- than the speckle estimator with respect to Strehl ratio variations during the calibration procedure. The present analysis theoretically explains why interferometry with fibers can produce visibility measurements with a very high precision, 1% or less

astro-ph↗