Edoardo Charbon — Page 5

arXiv2014

Avalanche photodiodes based on MoS2/Si heterojunctions

Avalanche photodiodes (APDs) are the semiconducting analogue of photomultiplier tubes offering very high internal current gain and fast response. APDs are interesting for a wide range of applications in communications1, laser ranging2, biological imaging3, and medical imaging4 where they offer speed and sensitivity superior to those of classical p-n junction-based photodetectors. The APD principle of operation is based on photocurrent multiplication through impact ionization in reverse-biased p-n junctions. APDs can either operate in proportional mode, where the bias voltage is below breakdown, or in Geiger mode, where the bias voltage is above breakdown. In proportional mode, the multiplication gain is finite, thus allowing for photon energy discrimination, while in Geiger mode of operation the multiplication gain is virtually infinite and a self-sustaining avalanche may be triggered, thus allowing detection of single photons5. Here, we demonstrate APDs based on vertically stacked monolayer MoS2 and p-Si, forming an abrupt p-n heterojunction. With this device, we demonstrate carrier multiplication exceeding 1000. Even though such multiplication factors in APDs are commonly accompanied by high noise, our devices show extremely low noise levels comparable with those in regular photodiodes. These heterostructures allow the realization of simple and inexpensive high-performance and low-noise photon counters based on transition metal dichalcogenides.

cond-mat.mes-hall↗

arXiv2011

FPGA implementation of a 32x32 autocorrelator array for analysis of fast image series

With the evolving technology in CMOS integration, new classes of 2D-imaging detectors have recently become available. In particular, single photon avalanche diode (SPAD) arrays allow detection of single photons at high acquisition rates (\geq 100 kfps), which is about two orders of magnitude higher than with currently available cameras. Here we demonstrate the use of a SPAD array for imaging fluorescence correlation spectroscopy (imFCS), a tool to create 2D maps of the dynamics of fluorescent molecules inside living cells. Time-dependent fluorescence fluctuations, due to fluorophores entering and leaving the observed pixels, are evaluated by means of autocorrelation analysis. The multi-τ correlation algorithm is an appropriate choice, as it does not rely on the full data set to be held in memory. Thus, this algorithm can be efficiently implemented in custom logic. We describe a new implementation for massively parallel multi-τ correlation hardware. Our current implementation can calculate 1024 correlation functions at a resolution of 10μs in real-time and therefore correlate real-time image streams from high speed single photon cameras with thousands of pixels.

physics.optics↗