Eilidh L. Quinn | Searcharxiv

arXiv2026

Rapid Atmospheric Vapor Deposition of H:In2O3 Transparent Conducting Oxide Thin Films

Transparent conducting oxides (TCOs) are essential for the optoelectronics industry, but there is a critical gap in cost-effective methods to rapidly deposit low sheet resistance, high transmittance films without damaging delicate materials, including emerging soft semiconductors like metal-halide perovskites. In this work, atmospheric pressure chemical vapor deposition (AP-CVD) is used to synthesise H:In2O3 films with 7.20+/-0.01 Ohm/sq sheet resistance (0.50+/-0.06 mOhm.cm resistivity) and transmittance up to 89% in the near-infrared (NIR), surpassing commercial sputter-deposited indium tin oxide. The growth rate is 40x higher than atomic layer deposition (ALD), and the AP-CVD films are fully processed under atmospheric conditions at only 140 C. Comparison of secondary ion mass spectrometry and time-of-flight elastic recoil detection analysis with changes in carrier concentration indicate that H dopants are introduced from the water oxidant. There is an increase in mobility form 40+/-10 cm2/Vs to 160+/-30 cm2/Vs when changing from O2 to H2O as the oxidant, which is attributed to H dopants passivating oxygen vacancies that act as carrier scattering centers. This work establishes AP-CVD as a promising method for manufacturing high figure-of-merit TCOs in a rapid, scalable and cost-effective manner, using mild growth conditions compatible with thermally-sensitive materials.

cond-mat.mtrl-sci↗

arXiv2025

Enhanced Stability and Linearly Polarized Emission from CsPbI$_3$ Perovskite Nanoplatelets through A-site Cation Engineering

The anisotropy of perovskite nanoplatelets (PeNPLs) opens up many opportunities in optoelectronics, including enabling the emission of linearly polarized light. But the limited stability of PeNPLs is a pressing challenge, especially for red-emitting CsPbI$_3$. Herein, we address this limitation by alloying FA into the perovskite cuboctahedral site. Unlike Cs/FA alloying in bulk thin films or nonconfined nanocubes, FA incorporation in nanoplatelets requires meticulous control over the reaction conditions, given that nanoplatelets are obtained in kinetically-driven growth regimes instead of thermodynamically-driven conditions. Through in-situ photoluminescence (PL) measurements, we find that excess FA leads to uncontrolled growth, where phase-impurities and nanoplatelets of multiple thicknesses co-exist. Restricting the FA content to up to 25% Cs substitution enables monodisperse PeNPLs, and increases the PL quantum yield (from 53% to 61%), exciton lifetime (from 18 ns to 27 ns), and stability in ambient air (from ~2 days to >7 days) compared to CsPbI$_3$. This arises due to hydrogen bonding between FA and the oleate and oleylammonium ligands, anchoring them to the surface to improve optoelectronic properties and stability. The reduction in non-radiative recombination, improvement in the nanoplatelet aspect ratio, and higher ligand density lead to FA-containing PeNPLs more effectively forming edge-up superlattices, enhancing the PL degree of linear polarization from 5.1% (CsPbI$_3$) to 9.4% (Cs$_{0.75}$FA$_{0.25}$PbI$_3$). These fundamental insights show how the stability limitations of PeNPLs could be addressed, and these materials grown more precisely to improve their performance as polarized light emitters, critical for utilizing them in next-generation display, bioimaging and communications applications.

cond-mat.mtrl-sci↗