arXiv subjects

Felix Lüpke

Publications and source records attributed to Felix Lüpke.

24 records · Page 2Linked to original sources

arXiv2020

Flatbands and Mechanical Deformation Effects in the Moiré Superlattice of MoS$_2$-WSe$_2$ Heterobilayers

It has recently been shown that quantum-confined states can appear in epitaxially grown van der Waals material heterobilayers without a rotational misalignment ($θ=0^\circ$), associated with flat bands in the Brillouin zone of the moiré pattern formed due to the lattice mismatch of the two layers. Peaks in the local density of states and confinement in a MoS$_2$/WSe$_2$ system was qualitatively described only considering local stacking arrangements, which cause band edge energies to vary spatially. In this work, we report the presence of large in-plane strain variation across the moiré unit cell of a $θ=0^\circ$ MoS$_2$/WSe$_2$ heterobilayer, and show that inclusion of strain variation and out-of-plane displacement in density functional theory calculations greatly improves their agreement with the experimental data. We further explore the role of twist-angle by showing experimental data for a twisted MoS$_2$/WSe$_2$ heterobilayer structure with twist angle of $θ=15^\circ$, that exhibits a moiré pattern but no confinement.

cond-mat.mtrl-sci↗

arXiv2020

Parasitic conduction channels in topological insulator thin films

Thin films of topological insulators (TI) usually exhibit multiple parallel conduction channels for the transport of electrical current. Beside the topologically protected surface states (TSS), parallel channels may exist, namely the interior of the not-ideally insulating TI film, the interface layer to the substrate, and the substrate itself. To be able to take advantage of the auspicious transport properties of the TSS, the influence of the parasitic parallel channels on the total current transport has to be minimized. Because the conductivity of the interior (bulk) of the thin TI film is difficult to access by measurements, we propose here an approach for calculating the mobile charge carrier concentration in the TI film. To this end, we calculate the near-surface band bending using parameters obtained experimentally from surface-sensitive measurements, namely (gate-dependent) four-point resistance measurements and angle-resolved photoelectron spectroscopy (ARPES). While in most cases another parameter in the calculations, i.e. the concentration of unintentional dopants inside the thin TI film, is unknown, it turns out that in the thin-film limit the band bending is largely independent of the dopant concentration in the film. Thus, a well-founded estimate of the total mobile charge carrier concentration and the conductivity of the interior of the thin TI film proves possible. Since the interface and substrate conductivities can be measured by a four-probe conductance measurement prior to the deposition of the TI film, the total contribution of all parasitic channels, and therefore also the contribution of the vitally important TSS, can be determined reliably.

cond-mat.mes-hall↗

arXiv2020

Realizing gapped surface states in magnetic topological insulator MnBi$_{2-x}$Sb$_{x}$Te$_{4}$

The interplay between magnetism and non-trivial topology in magnetic topological insulators (MTI) is expected to give rise to a variety of exotic topological quantum phenomena, such as the quantum anomalous Hall (QAH) effect and the topological axion states. A key to assessing these novel properties is to tune the Fermi level in the exchange gap of the Dirac surface band. MnBi$_2$Te$_4$ possesses non-trivial band topology with intrinsic antiferromagnetic (AFM) state that can enable all of these quantum states, however, highly electron-doped nature of the MnBi$_2$Te$_4$ crystals obstructs the exhibition of the gapped topological surface states. Here, we tailor the material through Sb-substitution to reveal the gapped surface states in MnBi$_{2-x}$Sb$_{x}$Te$_{4}$ (MBST). By shifting the Fermi level into the bulk band gap of MBST, we access the surface states and show a band gap of 50 meV at the Dirac point from quasi-particle interference (QPI) measured by scanning tunneling microscopy/spectroscopy (STM/STS). Surface-dominant conduction is confirmed below the Néel temperature through transport spectroscopy measured by multiprobe STM. The surface band gap is robust against out-of-plane magnetic field despite the promotion of field-induced ferromagnetism. The realization of bulk-insulating MTI with the large exchange gap offers a promising platform for exploring emergent topological phenomena.

cond-mat.mtrl-sci↗

arXiv2019

Proximity-induced superconducting gap in the quantum spin Hall edge state of monolayer WTe$_2$

The quantum spin Hall (QSH) state was recently demonstrated in monolayers of the transition metal dichalcogenide 1T'-WTe$_2$ and is characterized by a band gap in the two-dimensional (2D) interior and helical one-dimensional (1D) edge states. Inducing superconductivity in the helical edge states would result in a 1D topological superconductor, a highly sought-after state of matter. In the present study, we use a novel dry-transfer flip technique to place atomically-thin layers of WTe$_2$ on a van der Waals superconductor, NbSe$_2$. Using scanning tunneling microscopy and spectroscopy (STM/STS), we demonstrate atomically clean surfaces and interfaces and the presence of a proximity-induced superconducting gap in the WTe$_2$ for thicknesses from a monolayer up to 7 crystalline layers. At the edge of the WTe$_2$ monolayer, we show that the superconducting gap coexists with the characteristic spectroscopic signature of the QSH edge state. Taken together, these observations provide conclusive evidence for proximity-induced superconductivity in the QSH edge state in WTe$_2$, a crucial step towards realizing 1D topological superconductivity and Majorana bound states in this van der Waals material platform.

cond-mat.mes-hall↗

arXiv2018

Surface structures of tellurium on Si(111)-(7x7) studied by low-energy electron diffraction and scanning tunneling microscopy

The Te-covered Si(111) surface has received recent interest as a template for the epitaxy of van der Waals (vdW) materials, e.g. Bi$_2$Te$_3$. Here, we report the formation of a Te buffer layer on Si(111)$-$(7$\times$7) by low-energy electron diffraction (LEED) and scanning tunneling microscopy (STM). While deposition of several monolayer (ML) of Te on the Si(111)$-$(7$\times$7) surface at room temperature results in an amorphous Te layer, increasing the substrate temperature to $770\rm\,K$ results in a weak (7$\times$7) electron diffraction pattern. Scanning tunneling microscopy of this surface shows remaining corner holes from the Si(111)$-$(7$\times$7) surface reconstruction and clusters in the faulted and unfaulted halves of the (7$\times$7) unit cells. Increasing the substrate temperature further to $920\rm\,K$ leads to a Te/Si(111)$-(2\sqrt3\times2\sqrt{3})\rm R30^{\circ}$ surface reconstruction. We find that this surface configuration has an atomically flat structure with threefold symmetry.

cond-mat.mes-hall↗

arXiv2017

Electrical resistance of individual defects at a topological insulator surface

Three-dimensional topological insulators host surface states with linear dispersion, which manifest as a Dirac cone. Nanoscale transport measurements provide direct access to the transport properties of the Dirac cone in real space and allow the detailed investigation of charge carrier scattering. Here, we use scanning tunnelling potentiometry to analyse the resistance of different kinds of defects at the surface of a (Bi0.53Sb0.47)2Te3 topological insulator thin film. The largest localized voltage drop we find to be located at domain boundaries in the topological insulator film, with a resistivity about four times higher than that of a step edge. Furthermore, we resolve resistivity dipoles located around nanoscale voids in the sample surface. The influence of such defects on the resistance of the topological surface state is analysed by means of a resistor network model. The effect resulting from the voids is found to be small compared to the other defects.

cond-mat.mes-hall↗