arXiv subjects

Fredrik Tufvesson

Publications and source records attributed to Fredrik Tufvesson.

96 records · Page 6Linked to original sources

arXiv2014

Simulation and Measurement Based Vehicle-to-Vehicle Channel Characterization: Accuracy and Constraint Analysis

In this paper, a deterministic channel model for vehicle-to-vehicle (V2V) communication, is compared against channel measurement data collected during a V2V channel measurement campaign using a channel sounder. Channel metrics such as channel gain, delay and Doppler spreads, eigenvalue decomposition and antenna correlations are derived from the ray tracing (RT) simulations as well as from the measurement data obtained from two different measurements in an urban four-way intersection scenario. The channel metrics are compared separately for line-of-sight (LOS) and non-LOS (NLOS) situation. Most power contributions arise from the LOS component (if present) as well as from multipaths with single bounce reflections. Measurement and simulation results show a very good agreement in the presence of LOS, as most of the received power is contributed from the LOS component. In NLOS, the difference is large because the ray tracer is unable to capture some of the multi bounced propagation paths that are present in the measurements. Despite the limitations of the ray-based propagation model identified in this work, the model is suitable to characterize the channel properties in a sufficient manner.

cs.NI↗

arXiv2014

Time- and Frequency-Varying $K$-Factor of Non-Stationary Vehicular Channels for Safety Relevant Scenarios

Vehicular communication channels are characterized by a non-stationary time- and frequency-selective fading process due to fast changes in the environment. We characterize the distribution of the envelope of the first delay bin in vehicle-to-vehicle channels by means of its Rician $K$-factor. We analyze the time-frequency variability of this channel parameter using vehicular channel measurements at 5.6 GHz with a bandwidth of 240 MHz for safety-relevant scenarios in intelligent transportation systems (ITS). This data enables a frequency-variability analysis from an IEEE 802.11p system point of view, which uses 10 MHz channels. We show that the small-scale fading of the envelope of the first delay bin is Ricean distributed with a varying $K$-factor. The later delay bins are Rayleigh distributed. We demonstrate that the $K$-factor cannot be assumed to be constant in time and frequency. The causes of these variations are the frequency-varying antenna radiation patterns as well as the time-varying number of active scatterers, and the effects of vegetation. We also present a simple but accurate bi-modal Gaussian mixture model, that allows to capture the $K$-factor variability in time for safety-relevant ITS scenarios.

cs.NI↗

arXiv2014

Massive MIMO for Next Generation Wireless Systems

Multi-user Multiple-Input Multiple-Output (MIMO) offers big advantages over conventional point-to-point MIMO: it works with cheap single-antenna terminals, a rich scattering environment is not required, and resource allocation is simplified because every active terminal utilizes all of the time-frequency bins. However, multi-user MIMO, as originally envisioned with roughly equal numbers of service-antennas and terminals and frequency division duplex operation, is not a scalable technology. Massive MIMO (also known as "Large-Scale Antenna Systems", "Very Large MIMO", "Hyper MIMO", "Full-Dimension MIMO" & "ARGOS") makes a clean break with current practice through the use of a large excess of service-antennas over active terminals and time division duplex operation. Extra antennas help by focusing energy into ever-smaller regions of space to bring huge improvements in throughput and radiated energy efficiency. Other benefits of massive MIMO include the extensive use of inexpensive low-power components, reduced latency, simplification of the media access control (MAC) layer, and robustness to intentional jamming. The anticipated throughput depend on the propagation environment providing asymptotically orthogonal channels to the terminals, but so far experiments have not disclosed any limitations in this regard. While massive MIMO renders many traditional research problems irrelevant, it uncovers entirely new problems that urgently need attention: the challenge of making many low-cost low-precision components that work effectively together, acquisition and synchronization for newly-joined terminals, the exploitation of extra degrees of freedom provided by the excess of service-antennas, reducing internal power consumption to achieve total energy efficiency reductions, and finding new deployment scenarios. This paper presents an overview of the massive MIMO concept and contemporary research.

cs.IT↗

arXiv2013

Line-of-Sight Obstruction Analysis for Vehicle-to-Vehicle Network Simulations in a Two-Lane Highway Scenario

In vehicular ad-hoc networks (VANETs) the impact of vehicles as obstacles has largely been neglected in the past. Recent studies have reported that the vehicles that obstruct the line-of-sight (LOS) path may introduce 10-20 dB additional loss, and as a result reduce the communication range. Most of the traffic mobility models (TMMs) today do not treat other vehicles as obstacles and thus can not model the impact of LOS obstruction in VANET simulations. In this paper the LOS obstruction caused by other vehicles is studied in a highway scenario. First a car-following model is used to characterize the motion of the vehicles driving in the same direction on a two-lane highway. Vehicles are allowed to change lanes when necessary. The position of each vehicle is updated by using the car-following rules together with the lane-changing rules for the forward motion. Based on the simulated traffic a simple TMM is proposed for VANET simulations, which is capable to identify the vehicles that are in the shadow region of other vehicles. The presented traffic mobility model together with the shadow fading path loss model can take in to account the impact of LOS obstruction on the total received power in the multiple-lane highway scenarios.

cs.NI↗

arXiv2013

Delay and Doppler Spreads of Non-Stationary Vehicular Channels for Safety Relevant Scenarios

Vehicular communication channels are characterized by a non-stationary time- and frequency-selective fading process due to rapid changes in the environment. The non-stationary fading process can be characterized by assuming local stationarity for a region with finite extent in time and frequency. For this finite region the wide-sense stationarity and uncorrelated-scattering (WSSUS) assumption holds approximately and we are able to calculate a time and frequency dependent local scattering function (LSF). In this paper, we estimate the LSF from a large set of measurements collected in the DRIVEWAY'09 measurement campaign, which focuses on scenarios for intelligent transportation systems. We then obtain the time-frequency-varying power delay profile (PDP) and the time-frequency-varying Doppler power spectral density (DSD) from the LSF. Based on the PDP and the DSD, we analyze the time-frequency-varying root mean square (RMS) delay spread and the RMS Doppler spread. We show that the distribution of these channel parameters follows a bi-modal Gaussian mixture distribution. High RMS delay spread values are observed in situations with rich scattering, while high RMS Doppler spreads are obtained in drive-by scenarios.

cs.NI↗

arXiv2012

Scaling up MIMO: Opportunities and Challenges with Very Large Arrays

This paper surveys recent advances in the area of very large MIMO systems. With very large MIMO, we think of systems that use antenna arrays with an order of magnitude more elements than in systems being built today, say a hundred antennas or more. Very large MIMO entails an unprecedented number of antennas simultaneously serving a much smaller number of terminals. The disparity in number emerges as a desirable operating condition and a practical one as well. The number of terminals that can be simultaneously served is limited, not by the number of antennas, but rather by our inability to acquire channel-state information for an unlimited number of terminals. Larger numbers of terminals can always be accommodated by combining very large MIMO technology with conventional time- and frequency-division multiplexing via OFDM. Very large MIMO arrays is a new research field both in communication theory, propagation, and electronics and represents a paradigm shift in the way of thinking both with regards to theory, systems and implementation. The ultimate vision of very large MIMO systems is that the antenna array would consist of small active antenna units, plugged into an (optical) fieldbus.

cs.IT↗