arXiv subjects

G. Vajente

Publications and source records attributed to G. Vajente.

6 recordsLinked to original sources

arXiv2026

Atomic Structure of Amorphous Optical Coatings of TiO$_2$-doped GeO$_2$ by Grazing-Incidence Total X-ray Scattering Measurements

Reducing coating thermal noise in future gravitational-wave detectors requires identifying the atomic motifs that control mechanical loss in amorphous optical coatings. We combine grazing-incidence X-ray pair distribution function measurements with atomic-structure modeling to study amorphous TiO$_2$-doped GeO$_2$ films over Ti cation concentrations from $\sim$11 % to $\sim$48 %, before and after annealing. The structural analysis reveals systematic composition- and annealing-dependent changes in short- and intermediate-range order. Increasing Ti content raises the average Ti coordination and promotes edge- and face-sharing polyhedral connections, while Ge remains predominantly fourfold coordinated. Annealing reduces these compact shared-polyhedron motifs and sharpens the first sharp diffraction peak, indicating a more relaxed intermediate-range network. Among the structural descriptors examined, the clearest correlation with the annealing-induced reduction in mechanical loss is the decrease in edge- and face-sharing polyhedra. These results connect composition, annealing, atomic structure, and mechanical dissipation in TiO$_2$-doped GeO$_2$, providing microscopic guidance for optimizing low-noise mirror coatings.

cond-mat.mtrl-sci↗

arXiv2025

Low thermal noise mirror coatings utilising titanium dioxide and germanium dioxide mixtures

Upgrades to ground-based gravitational-wave observatories will require mirror coatings with reduced thermal noise, enabling improved detector sensitivity and extended astrophysical reach. Recent studies have shown that optical coatings utilising amorphous materials that exhibit a larger fraction of corner-sharing between adjacent structural units of metal-centered polyhedra are a promising route for reducing mechanical dissipation and thus thermal noise at room temperature. We report on multilayer optical coatings that are fabricated using germanium dioxide mixed with titanium dioxide (TiO$_2$:GeO$_2$) for the high index layers, and silicon dioxide (SiO$_2$) for the low index material. Single layers of TiO$_2$:GeO$_2$ are characterised to optimise the mixture proportion and based on that highly reflective multilayer stacks were deposited. Exceptional optical absorption at 1064 nm below 1 part-per-million (ppm) is observed in the multilayer stacks after heat treatment. The annealing process also induces the formation of blisters which leads to increased optical scattering. However, there is indication that blisters can be suppressed by decreasing the water partial pressure in the deposition chamber. Direct thermal noise measurements provide experimental verification of a significant 25\% reduction of thermal noise over the mirrors currently employed, which combined with sub-ppm levels of optical absorption show the potential of TiO$_2$:GeO$_2$ to improve the sensitivity of gravitational-wave observatories.

physics.ins-det↗

arXiv2021

Approaching the motional ground state of a 10 kg object

The motion of a mechanical object -- even a human-sized object -- should be governed by the rules of quantum mechanics. Coaxing them into a quantum state is, however, difficult: the thermal environment masks any quantum signature of the object's motion. Indeed, the thermal environment also masks effects of proposed modifications of quantum mechanics at large mass scales. We prepare the center-of-mass motion of a 10 kg mechanical oscillator in a state with an average phonon occupation of 10.8. The reduction in temperature, from room temperature to 77 nK, is commensurate with an 11 orders-of-magnitude suppression of quantum back-action by feedback -- and a 13 orders-of-magnitude increase in the mass of an object prepared close to its motional ground state. This begets the possibility of probing gravity on massive quantum systems.

quant-ph↗

arXiv2021

Exploration of co-sputtered Ta$_2$O$_5$-ZrO$_2$ thin films for gravitational-wave detectors

We report on the development and extensive characterization of co-sputtered tantala-zirconia thin films, with the goal to decrease coating Brownian noise in present and future gravitational-wave detectors. We tested a variety of sputtering processes of different energies and deposition rates, and we considered the effect of different values of cation ratio $η=$ Zr/(Zr+Ta) and of post-deposition heat treatment temperature $T_a$ on the optical and mechanical properties of the films. Co-sputtered zirconia proved to be an efficient way to frustrate crystallization in tantala thin films, allowing for a substantial increase of the maximum annealing temperature and hence for a decrease of coating mechanical loss. The lowest average coating loss was observed for an ion-beam sputtered sample with $η= 0.485 \pm 0.004$ annealed at 800 $^{\circ}$C, yielding $\overlineφ = 1.8 \times 10^{-4}$. All coating samples showed cracks after annealing. Although in principle our measurements are sensitive to such defects, we found no evidence that our results were affected. The issue could be solved, at least for ion-beam sputtered coatings, by decreasing heating and cooling rates down to 7 $^{\circ}$C/h. While we observed as little optical absorption as in the coatings of current gravitational-wave interferometers (0.5 parts per million), further development will be needed to decrease light scattering and avoid the formation of defects upon annealing.

physics.ins-det↗

arXiv2016

Improving the Data Quality of Advanced LIGO Based on Early Engineering Run Results

The Advanced Laser Interferometer Gravitational-wave Observatory (LIGO) detectors have completed their initial upgrade phase and will enter the first observing run in late 2015, with detector sensitivity expected to improve in future runs. Through the combined efforts of on-site commissioners and the Detector Characterization group of the LIGO Scientific Collaboration, interferometer performance, in terms of data quality, at both LIGO observatories has vastly improved from the start of commissioning efforts to present. Advanced LIGO has already surpassed Enhanced LIGO in sensitivity, and the rate of noise transients, which would negatively impact astrophysical searches, has improved. Here we give details of some of the work which has taken place to better the quality of the LIGO data ahead of the first observing run.

gr-qc↗

arXiv2006

Displacement power spectrum measurement of a macroscopic optomechanical system at thermal equilibrium

The mirror relative motion of a suspended Fabry-Perot cavity is studied in the frequency range 3-10 Hz. The experimental measurements presented in this paper, have been performed at the Low Frequency Facility, a high finesse optical cavity 1 cm long suspended to a mechanical seismic isolation system identical to that one used in the VIRGO experiment. The measured relative displacement power spectrum is compatible with a system at thermal equilibrium within its environmental. In the frequency region above 3 Hz, where seismic noise contamination is negligible, the measurement distribution is stationary and Gaussian, as expected for a system at thermal equilibrium. Through a simple mechanical model it is shown that: applying the fluctuation dissipation theorem the measured power spectrum is reproduced below 90 Hz and noise induced by external sources are below the measurement.

gr-qc↗