Searcharxiv⌕ Search

arXiv subjects

Giulietto Felici

Publications and source records attributed to Giulietto Felici.

7 recordsLinked to original sources

Design and simulation of a transmon qubit chip for Axion detection

Quantum Sensing is a rapidly expanding research field that finds one of its applications in Fundamental Physics, as the search for Dark Matter. Devices based on superconducting qubits have already been successfully applied in detecting few-GHz single photons via Quantum Non-Demolition measurement (QND). This technique allows us to perform repeatable measurements, bringing remarkable sensitivity improvements and dark count rate suppression in experiments based on high-precision microwave photon detection, such as for Axions and Dark Photons search. In this context, the INFN Qub-IT project goal is to realize an itinerant single-photon counter based on superconducting qubits that will exploit QND for enhancing Axion search experiments. In this study, we present Qub-IT's status towards the realization of its first superconducting qubit device, illustrating design and simulation procedures and the characterization of fabricated Coplanar Waveguide Resonators (CPWs) for readout. We match target qubit parameters and assess a few-percent level agreement between lumped and distributed element simulation models. We reach a maximum internal quality factor of 9.2x10^5 for -92 dBm on-chip readout power.

quant-ph↗

Implementation and performances of the IPbus protocol for the JUNO Large-PMT readout electronics

The Jiangmen Underground Neutrino Observatory (JUNO) is a large neutrino detector currently under construction in China. Thanks to the tight requirements on its optical and radio-purity properties, it will be able to perform leading measurements detecting terrestrial and astrophysical neutrinos in a wide energy range from tens of keV to hundreds of MeV. A key requirement for the success of the experiment is an unprecedented 3% energy resolution, guaranteed by its large active mass (20 kton) and the use of more than 20,000 20-inch photo-multiplier tubes (PMTs) acquired by high-speed, high-resolution sampling electronics located very close to the PMTs. As the Front-End and Read-Out electronics is expected to continuously run underwater for 30 years, a reliable readout acquisition system capable of handling the timestamped data stream coming from the Large-PMTs and permitting to simultaneously monitor and operate remotely the inaccessible electronics had to be developed. In this contribution, the firmware and hardware implementation of the IPbus based readout protocol will be presented, together with the performances measured on final modules during the mass production of the electronics.

physics.ins-det↗

Mass testing of the JUNO experiment 20-inch PMTs readout electronics

The Jiangmen Underground Neutrino Observatory (JUNO) is a multi-purpose, large size, liquid scintillator experiment under construction in China. JUNO will perform leading measurements detecting neutrinos from different sources (reactor, terrestrial and astrophysical neutrinos) covering a wide energy range (from 200 keV to several GeV). This paper focuses on the design and development of a test protocol for the 20-inch PMT underwater readout electronics, performed in parallel to the mass production line. In a time period of about ten months, a total number of 6950 electronic boards were tested with an acceptance yield of 99.1%.

physics.ins-det↗

Validation and integration tests of the JUNO 20-inch PMTs readout electronics

The Jiangmen Underground Neutrino Observatory (JUNO) is a large neutrino detector currently under construction in China. JUNO will be able to study the neutrino mass ordering and to perform leading measurements detecting terrestrial and astrophysical neutrinos in a wide energy range, spanning from 200 keV to several GeV. Given the ambitious physics goals of JUNO, the electronic system has to meet specific tight requirements, and a thorough characterization is required. The present paper describes the tests performed on the readout modules to measure their performances.

physics.ins-det↗

A possible simultaneous fit to the available $e^+e^- \rightarrow Λ^+_c \barΛ^-_c$ cross section data nearby $ψ(4660)$ by means of a strong correction to the Coulomb enhancement factor

There are two available set of data on the $e^+e^- \rightarrow Λ^+_c \barΛ_c^-$ cross section above threshold. The BELLE measurement, with ISR return, is compatible with the presence of a resonant state, called $ψ(4660)$ (formerly known as $Y(4660)$), observed also in other final states. The BESIII dataset has shown a different trend, with a flat cross section. We propose a new solution to fit both datasets by means of a strong correction to the Coulomb enhancement factor. Mass and width of the resonant state is extracted.

hep-ph↗

Status of the SIMP Project: Toward the Single Microwave Photon Detection

The Italian institute for nuclear physics (INFN) has financed the SIMP project (2019-2021) in order to strengthen its skills and technologies in the field of meV detectors with the ultimate aim of developing a single microwave photon detector. This goal will be pursued by improving the sensitivity and the dark count rate of two types of photodetectors: current biased Josephson Junction (JJ) for the frequency range 10-50 GHz and Transition Edge Sensor (TES) for the frequency range 30-100 GHz. Preliminary results on materials and devices characterization are presented.

physics.ins-det↗

Improved Particle Identification Using Cluster Counting in a Full-Length Drift Chamber Prototype

Single-cell prototype drift chambers were built at TRIUMF and tested with a $\sim\unit[210]{MeV/c}$ beam of positrons, muons, and pions. A cluster-counting technique is implemented which improves the ability to distinguish muons and pions when combined with a traditional truncated-mean charge measurement. Several cluster-counting algorithms and equipment variations are tested, all showing significant improvement when combined with the traditional method. The results show that cluster counting is a feasible option for any particle physics experiment using drift chambers for particle identification. The technique does not require electronics with an overly high sampling rate. Optimal results are found with a signal smoothing time of $\sim\unit[5]{ns}$ corresponding to a $\sim\unit[100]{MHz}$ Nyquist frequency.

physics.ins-det↗