arXiv subjects

H. S. J. van der Zant

Publications and source records attributed to H. S. J. van der Zant.

At least 37 records · Page 2Linked to original sources

arXiv2015

Pick-up and drop transfer of diamond nanosheets

Nanocrystalline diamond (NCD) is a promising material for electronic and mechanical micro- and nanodevices. Here we introduce a versatile pick-up and drop technique that makes it possible to investigate the electrical, optical and mechanical properties of as-grown NCD films. Using this technique, NCD nanosheets, as thin as 55 nm, can be picked-up from a growth substrate and positioned on another substrate. As a proof of concept, electronic devices and mechanical resonators are fabricated and their properties are characterized. In addition, the versatility of the method is further explored by transferring NCD nanosheets onto an optical fibre, which allows measuring its optical absorption. Finally, we show that NCD nanosheets can also be transferred onto 2D crystals, such as MoS2, to fabricate heterostructures. Pick-up and drop transfer enables the fabrication of a variety of NCD-based devices without requiring lithography or wet processing.

cond-mat.mtrl-sci↗

arXiv2014

Time-domain response of atomically thin $\mathrm{MoS_2}$ nanomechanical resonators

We measure the energy relaxation rate of single- and few-layer molybdenum disulphide ($\mathrm{MoS_2}$) nanomechanical resonators by detecting the resonator ring-down. Recent experiments on these devices show a remarkably low quality (Q)-factor when taking spectrum measurements at room temperature. The origin of the low spectral Q-factor is an open question, and it has been proposed that besides dissipative processes, frequency fluctuations contribute significantly to the resonance line-width. The spectral measurements performed thus far however, do not allow one to distinguish these two processes. Here, we use time-domain measurements to quantify the dissipation. We compare the Q-factor obtained from the ring-down measurements to those obtained from the thermal noise spectrum and from the frequency response of the driven device. In few-layer and single-layer $\mathrm{MoS_2}$ resonators the two are in close agreement, which demonstrates that the spectral line-width in $\mathrm{MoS_2}$ membranes at room temperature is limited by dissipation, and that excess spectral broadening plays a negligible role.

cond-mat.mes-hall↗

arXiv2014

Large tunable image-charge effects in single-molecule junctions

The characteristics of molecular electronic devices are critically determined by metal-organic interfaces, which influence the arrangement of the orbital levels that participate in charge transport. Studies on self-assembled monolayers (SAMs) show (molecule-dependent) level shifts as well as transport-gap renormalization, suggesting that polarization effects in the metal substrate play a key role in the level alignment with respect to the metal's Fermi energy. Here, we provide direct evidence for an electrode-induced gap renormalization in single-molecule junctions. We study charge transport in single porphyrin-type molecules using electrically gateable break junctions. In this set-up, the position of the occupied and unoccupied levels can be followed in situ and with simultaneous mechanical control. When increasing the electrode separation, we observe a substantial increase in the transport gap with level shifts as high as several hundreds of meV for displacements of a few ångstroms. Analysis of this large and tunable gap renormalization with image-charge calculations based on atomic charges obtained from density functional theory confirms and clarifies the dominant role of image-charge effects in single-molecule junctions.

cond-mat.mes-hall↗

arXiv2013

Submicrosecond-timescale readout of carbon nanotube mechanical motion

We report fast readout of the motion of a carbon nanotube mechanical resonator. A close-proximity high electron mobility transistor amplifier is used to increase the bandwidth of the measurement of nanotube displacements from the kHz to the MHz regime. Using an electrical detection scheme with the nanotube acting as a mixer, we detect the amplitude of its mechanical motion at room temperature with an intermediate frequency of 6 MHz and a timeconstant of 780 ns, both up to five orders of magnitude faster than achieved before. The transient response of the mechanical motion indicates a ring-down time faster than our enhanced time resolution, placing an upper bound on the contribution of energy relaxation processes to the room temperature mechanical quality factor.

cond-mat.mes-hall↗

arXiv2013

Strongly coupled modes in a weakly driven micromechanical resonator

We demonstrate strong coupling between the flexural vibration modes of a clamped-clamped micromechanical resonator vibrating at low amplitudes. This coupling enables the direct measurement of the frequency response via amplitude- and phase modulation schemes using the fundamental mode as a mechanical detector. In the linear regime, a frequency shift of $\mathrm{0.8\,Hz}$ is observed for a mode with a line width of $\mathrm{5.8\,Hz}$ in vacuum. The measured response is well-described by the analytical model based on the Euler-Bernoulli beam including tension. Calculations predict an upper limit for the room-temperature Q-factor of $\mathrm{4.5\times10^5}$ for our top-down fabricated micromechanical beam resonators.

cond-mat.mes-hall↗

arXiv2012

Manipulation of organic polyradicals in a single-molecule transistor

Inspired by cotunneling spectroscopy of spin-states in a single OPE5-based molecule, we investigate the prospects for electric control of magnetism in purely organic molecules contacted in a three-terminal geometry. Using the gate electrode, the molecule is reversibly switched between three different redox states, with magnetic spectra revealing both ferromagnetic and antiferromagnetic exchange couplings on the molecule. These observations are shown to be captured by an effective low-energy Heisenberg model, which we substantiate microscopically by a simple valence bond description of the molecule. These preliminary findings suggest an interesting route towards functionalized all-organic molecular magnetism.

cond-mat.mes-hall↗

arXiv2012

Current-induced nanogap formation and graphitization in boron-doped diamond films

A high-current annealing technique is used to fabricate nanogaps and hybrid diamond/graphite structures in boron-doped nanocrystalline diamond films. Nanometer-sized gaps down to 1 nm are produced using a feedback-controlled current annealing procedure. The nanogaps are characterized using scanning electron microscopy and electronic transport measurements. The structural changes produced by the elevated temperature, achieved by Joule heating during current annealing, are characterized using Raman spectroscopy. The formation of hybridized diamond/graphite structure is observed at the point of maximum heat accumulation.

cond-mat.mes-hall↗

arXiv2012

Coupling carbon nanotube mechanics to a superconducting circuit

The quantum behaviour of mechanical resonators is a new and emerging field driven by recent experiments reaching the quantum ground state. The high frequency, small mass, and large quality-factor of carbon nanotube resonators make them attractive for quantum nanomechanical applications. A common element in experiments achieving the resonator ground state is a second quantum system, such as coherent photons or superconducting device, coupled to the resonators motion. For nanotubes, however, this is a challenge due to their small size. Here, we couple a carbon nanoelectromechanical (NEMS) device to a superconducting circuit. Suspended carbon nanotubes act as both superconducting junctions and moving elements in a Superconducting Quantum Interference Device (SQUID). We observe a strong modulation of the flux through the SQUID from displacements of the nanotube. Incorporating this SQUID into superconducting resonators and qubits should enable the detection and manipulation of nanotube mechanical quantum states at the single-phonon level.

cond-mat.mes-hall↗

arXiv2012

Modal interactions of flexural and torsional vibrations in a microcantilever

The nonlinear interactions between flexural and torsional modes of a microcantilever are experimentally studied. The coupling is demonstrated by measuring the frequency response of one mode, which is sensitive to the motion of another resonance mode. The flexural-flexural, torsional-torsional and flexural-torsional modes are coupled due to nonlinearities, which affect the dynamics at high vibration amplitudes and cause the resonance frequency of one mode to depend on the amplitude of the other modes. We also investigate the nonlinear dynamics of torsional modes, which cause a frequency stiffening of the response. By simultaneously driving another torsional mode in the nonlinear regime, the nonlinear response is tuned from stiffening to weakening. By balancing the positive and negative cubic nonlinearities a linear response is obtained for the strongly driven system. The nonlinear modal interactions play an important role in the dynamics of multi-mode scanning probe microscopes

cond-mat.mes-hall↗

arXiv2011

Q-factor control of a microcantilever by mechanical sideband excitation

We demonstrate the coupling between the fundamental and second flexural mode of a microcantilever. A mechanical analogue of cavity-optomechanics is then employed, where the mechanical cavity is formed by the second vibrational mode of the same cantilever, coupled to the fundamental mode via the geometric nonlinearity. By exciting the cantilever at the sum and difference frequencies between fundamental and second flexural mode, the motion of the fundamental mode of the cantilever is amplified and damped. This concept makes it possible to enhance or suppress the Q-factor over a wide range.

cond-mat.mes-hall↗

arXiv2011

Interactions between directly and parametrically driven vibration modes in a micromechanical resonator

The interactions between parametrically and directly driven vibration modes of a clamped-clamped beam resonator are studied. An integrated piezoelectric transducer is used for direct and parametric excitation. First, the parametric amplification and oscillation of a single mode are analyzed by the power and phase dependence below and above the threshold for parametric oscillation. Then, the motion of a parametrically driven mode is detected by the induced change in resonance frequency in another mode of the same resonator. The resonance frequency shift is the result of the nonlinear coupling between the modes by the displacement-induced tension in the beam. These nonlinear modal interactions result in the quadratic relation between the resonance frequency of one mode and the amplitude of another mode. The amplitude of a parametrically oscillating mode depends on the square root of the pump frequency. Combining these dependencies yields a linear relation between the resonance frequency of the directly driven mode and the frequency of the parametrically oscillating mode.

cond-mat.mes-hall↗

arXiv2011

Discrete-time quadrature feedback cooling of a radio-frequency mechanical resonator

We have employed a feedback cooling scheme, which combines high-frequency mixing with digital signal processing. The frequency and damping rate of a 2 MHz micromechanical resonator embedded in a dc SQUID are adjusted with the feedback, and active cooling to a temperature of 14.3 mK is demonstrated. This technique can be applied to GHz resonators and allows for flexible control strategies.

cond-mat.mes-hall↗

arXiv2010

Tunable backaction of a dc SQUID on an integrated micromechanical resonator

We have measured the backaction of a dc superconducting quantum interference device (SQUID) position detector on an integrated 1 MHz flexural resonator. The frequency and quality factor of the micromechanical resonator can be tuned with bias current and applied magnetic flux. The backaction is caused by the Lorentz force due to the change in circulating current when the resonator displaces. The experimental features are reproduced by numerical calculations using the resistively and capacitively shunted junction (RCSJ) model.

cond-mat.mes-hall↗

arXiv2010

Nonlinear modal interactions in clamped-clamped mechanical resonators

A theoretical and experimental investigation is presented on the intermodal coupling between the flexural vibration modes of a single clamped-clamped beam. Nonlinear coupling allows an arbitrary flexural mode to be used as a self-detector for the amplitude of another mode, presenting a method to measure the energy stored in a specific resonance mode. Experimentally observed complex nonlinear dynamics of the coupled modes are quantitatively captured by a model which couples the modes via the beam extension; the same mechanism is responsible for the well-known Duffing nonlinearity in clamped-clamped beams.

cond-mat.mes-hall↗

arXiv2010

Single electron tunneling through high-Q single-wall carbon nanotube NEMS resonators

By first lithographically fabricating contact electrodes and then as last step growing carbon nanotubes with chemical vapour deposition across the ready-made chip, many potential contamination mechanisms for nanotube devices can be avoided. Combining this with pre-defined trenches on the chip, such that the nanotubes are freely suspended above the substrate, enables the formation of highly regular electronic systems. We show that, in addition, such suspended ultra-clean nanotubes provide excellent high-frequency and low-dissipation mechanical resonators. The motion detection mechanism of our experiment is discussed, and we measure the effect of Coulomb blockade and the back-action of single electron tunneling on the mechanical motion. In addition data on the mechanical higher modes is presented.

cond-mat.mes-hall↗

arXiv2010

Spin-coupled double-quantum-dot behavior inside a single-molecule transistor

We report on the observation of Kondo and split Kondo peaks in single-molecule transistors containing a single spin transition molecule with a Fe2+ ion. Coulomb blockade characteristics reveal a double quantum dot behavior in a parallel configuration, making our system a molecular equivalent to a semiconducting double-quantum-dot system. As the gate voltage is increased the charging of the second dot by an additional electron induces a splitting of the Kondo peak. We discuss possible origins of this effect including a spin transition into a high-spin state.

cond-mat.mes-hall↗

arXiv2010

Strong coupling between single-electron tunneling and nano-mechanical motion

Nanoscale resonators that oscillate at high frequencies are useful in many measurement applications. We studied a high-quality mechanical resonator made from a suspended carbon nanotube driven into motion by applying a periodic radio frequency potential using a nearby antenna. Single-electron charge fluctuations created periodic modulations of the mechanical resonance frequency. A quality factor exceeding 10^5 allows the detection of a shift in resonance frequency caused by the addition of a single-electron charge on the nanotube. Additional evidence for the strong coupling of mechanical motion and electron tunneling is provided by an energy transfer to the electrons causing mechanical damping and unusual nonlinear behavior. We also discovered that a direct current through the nanotube spontaneously drives the mechanical resonator, exerting a force that is coherent with the high-frequency resonant mechanical motion.

cond-mat.mes-hall↗

arXiv2010

Magnetomotive drive and detection of clamped-clamped mechanical resonators in water

We demonstrate magnetomotive drive and detection of doubly clamped string resonators in water. A compact 1.9 T permanent magnet is used to detect the fundamental and higher flexural modes of $\mathrm{200 μm}$ long resonators. Good agreement is found between the magnetomotive measurements and optical measurements performed on the same resonator. The magnetomotive detection scheme can be used to simultaneously drive and detect multiple sensors or scanning probes in viscous fluids without alignment of detector beams.

physics.ins-det↗