Searcharxiv⌕ Search

arXiv subjects

Hanhee Paik

Publications and source records attributed to Hanhee Paik.

22 records · Page 2Linked to original sources

Decoherence in dc SQUID phase qubits

We report measurements of Rabi oscillations and spectroscopic coherence times in an Al/AlOx/Al and three Nb/AlOx/Nb dc SQUID phase qubits. One junction of the SQUID acts as a phase qubit and the other junction acts as a current-controlled nonlinear isolating inductor, allowing us to change the coupling to the current bias leads in situ by an order of magnitude. We found that for the Al qubit a spectroscopic coherence time T2* varied from 3 to 7 ns and the decay envelope of Rabi oscillations had a time constant T' = 25 ns on average at 80 mK. The three Nb devices also showed T2* in the range of 4 to 6 ns, but T' was 9 to 15 ns, just about 1/2 the value we found in the Al device. For all the devices, the time constants were roughly independent of the isolation from the bias lines, implying that noise and dissipation from the bias leads were not the principal sources of dephasing and inhomogeneous broadening.

cond-mat.supr-con↗

Comparison of coherence times in three dc SQUID phase qubits

We report measurements of spectroscopic linewidth and Rabi oscillations in three thin-film dc SQUID phase qubits. One device had a single-turn Al loop, the second had a 6-turn Nb loop, and the third was a first order gradiometer formed from 6-turn wound and counter-wound Nb coils to provide isolation from spatially uniform flux noise. In the 6 - 7.2 GHz range, the spectroscopic coherence times for the gradiometer varied from 4 ns to 8 ns, about the same as for the other devices (4 to 10 ns). The time constant for decay of Rabi oscillations was significantly longer in the single-turn Al device (20 to 30 ns) than either of the Nb devices (10 to 15 ns). These results imply that spatially uniform flux noise is not the main source of decoherence or inhomogenous broadening in these devices.

cond-mat.supr-con↗

Strong-field effects in the Rabi oscillations of the superconducting phase qubit

Rabi oscillations have been observed in many superconducting devices, and represent prototypical logic operations for quantum bits (qubits) in a quantum computer. We use a three-level multiphoton analysis to understand the behavior of the superconducting phase qubit (current-biased Josephson junction) at high microwave drive power. Analytical and numerical results for the ac Stark shift, single-photon Rabi frequency, and two-photon Rabi frequency are compared to measurements made on a dc SQUID phase qubit with Nb/AlOx/Nb tunnel junctions. Good agreement is found between theory and experiment.

cond-mat.supr-con↗

Fast High-Fidelity Measurements of the Ground and Excited States of a dc-SQUID Phase Qubit

We have investigated the fidelity and speed of single-shot current-pulse measurements of the three lowest energy states of the dc SQUID phase qubit. We apply a short (2ns) current pulse to one junction of a Nb/AlOx/Nb SQUID that is in the zero voltage state at 25 mK and measure if the system switches to the finite voltage state. By plotting the switching rate versus pulse size we can determine average occupancy of the levels down to 0.01%, quantify small levels of leakage, and find the optimum pulse condition for single-shot measurements. Our best error rate is 3% with a measurement fidelity of 94%. By monitoring the escape rate during the pulse, the pulse current in the junction can be found to better than 10 nA on a 0.1 ns time scale. Theoretical analysis of the system reveals switching curves that are in good agreement with the data, as well as predictions that the ultimate single-shot error rate for this technique can reach 0.4% and the fidelity 99.2%.

cond-mat.supr-con↗