arXiv subjects

I. V. Trofimov

Publications and source records attributed to I. V. Trofimov.

7 recordsLinked to original sources

arXiv2025

Multiterminal Ballistic Josephson Effect in Monocrystalline Gold

We report on the realization of a planar, quasi-ballistic Josephson junction array using a Au micron-sized single-crystal. The system exhibits a nonlocal, multiterminal Josephson effect, where the supercurrent between any two superconducting leads is governed by the phase coherence across the entire crystal. Key evidence includes a non-monotonic dependence of the critical current on junction length and magnetic interference patterns with periods corresponding to the shared normal-metal area. Nonlocal transport measurements further confirm that the supercurrent between two electrodes depends on the phase configuration of all the others. Our results, supported by a developed theoretical model, establish a platform for exploring complex superconducting phenomena in multiterminal ballistic systems.

cond-mat.supr-con↗

arXiv2025

Practical way to increase nonlinearity of kinetic inductance of superconductor

This work demonstrates that depositing a thin layer of Mo (5-15 nm) onto a 10 nm thick NbN strip leads to a significant increase in the nonlinearity of the kinetic inductance $L_k$. Specifically, the change in $L_k$ with increasing current reached 70% in the NbN/Mo bilayer at liquid helium temperature, whereas in the NbN strip, $L_k$ changed by only 10% in the superconducting state. In addition to altering the nonlinear properties, the Mo layer caused a significant increase in the critical current at low temperatures (up to 2 times in the case of a 5 nm thick Mo layer). The increased nonlinearity of $L_k$ can be explained by two factors: i) a reduction of the critical supervelocity at which the superconducting state becomes unstable with respect to vortex formation when a Mo layer is deposited on NbN, and ii) a higher sensitivity of the induced superconductivity in Mo to supervelocity/supercurrent. Considering the results on the transport properties of SN bilayers with a high ratio of layer resistivities $ρ_S/ρ_N >> 1$, it can be concluded that depositing a thin layer of a relatively low-resistivity metal onto a superconductor with high $ρ$ is a practical method for achieving a large nonlinearity of the superconductor's kinetic inductance.

cond-mat.supr-con↗

arXiv2024

Response of a Cold-Electron Bolometer in a coplanar antenna system

Cold electron bolometers have shown their suitability for use in modern fundamental physical experiments. Fabrication and measurements of the samples with cold-electron bolometers integrated into coplanar antennas are performed in this study. The bolometric layer was made using combined aluminum-hafnium technology to improve quality of aluminum oxide layer and decrease the leakage current. The samples of two types were measured in a dilution cryostat at various temperatures from 20 to 300 mK. The first sample with Ti/Au/Pd antenna shows response in the two frequency bands, at 7--9 GHz with bandwidth of about 20%, and also at 14 GHz with 10% bandwidth. The NEP below 10 aW/Hz^1/2 is reached at 300 mK for 7.7 GHz signal. The second sample with aluminum made antenna shows response in the frequency range 0.5--3 GHz due to the effect of kinetic inductance of superconducting aluminum.

cond-mat.supr-con↗

arXiv2024

Effect of Etching Methods on Dielectric Losses in Transmons

Superconducting qubits are considered as a promising platform for implementing a fault tolerant quantum computing. However, surface defects of superconductors and the substrate leading to qubit state decoherence and fluctuations in qubit parameters constitute a significant problem. The amount and type of defects depend both on the chip materials and fabrication procedure. In this work, transmons produced by two different methods of aluminum etching: wet etching in a solution of weak acids and dry etching using a chlorine-based plasma are experimentally studied. The relaxation and coherence times for dry-etched qubits are more than twice as long as those for wet-etched ones. Additionally, the analysis of time fluctuations of qubit frequencies and relaxation times, which is an effective method to identify the dominant dielectric loss mechanisms, indicates a significantly lower impact of two-level systems in the dry-etched qubits compared to the wet-etched ones.

quant-ph↗

arXiv2024

Technology of fabrication superconducting free-standing structures (FSS)

In this study, a method for fabrication of superconducting microstructures that are partially or completely isolated from the substrate has been proposed. Two configurations of suspended microbridges have been suggested, i. e., the first structure that features a T-shaped etching of the substrate and the second structure which is completely separated from the substrate through periodically positioned supports. The creation of suspended structures is based on the principle of gas-phase etching of amorphous silicon oxide in a mixture of hydrogen fluoride (HF) and ethanol gases. In the course of the experiments, it has been discovered that suspending micro-structures in the configuration of a micro-bridge results in a slight reduction in superconducting characteristics, ranging from 10 to 15% of the initial parameters. It has also been demonstrated that the thermal coupling between the film and the substrate significantly affects the dissipation of thermal energy. The power dissipated into the substrate at room temperature can vary by up to 250 times based on the value of the micro-bridge undercutting.

cond-mat.supr-con↗

arXiv2024

Influence ScN protective thin layer on the superconducting properties of ultrathin NbN films

The present study delves into exploring the impact of a thin protective layer of scandium nitride (ScN) on the superconductive properties of thin films of niobium nitride (NbN) generated through reactive magnetron deposition. This is the first time such an investigation has been carried out. The article offers a comprehensive investigation of the morphological, microstructural, and electrophysical features of thin films that have undergone high-temperature annealing in an oxygen-rich environment. The dependence of the critical transition temperature of the NbN thin film on the annealing temperature of the samples in an oxygen medium, with and without ScN coating, was determined. According to X-ray reflectometry studies, it has been observed that the ScN film serves as a protective layer, even when exposed to annealing temperatures of approximately 450°C, without significantly affecting the NbN layer density or thickness. It has been shown that adding a ScN coating to a thin NbN film increases its resistance to corrosive media compared to a film without the coating.

cond-mat.supr-con↗

arXiv2021

Investigation of superconducting properties of NbN films deposited by DC magnetron sputtering on high-k dielectric HfO2 buffer layer

The influence of the buffer layer of hafnia dielectric on superconducting properties of niobium nitride films, produced by the technique of the reactive magnetron depositing has been investigated for the first time. This study presents a comprehensive analysis of morphological, microstructural, and electrophysical parameters of thin NbN films.

cond-mat.supr-con↗