arXiv subjects

Ilya Charaev

Publications and source records attributed to Ilya Charaev.

23 records · Page 2Linked to original sources

arXiv2018

Magnetic-field enhancement of performance of superconducting nanowire single-photon detector

We present SNSPDs from NbN nanowires shaped after square-spiral that allows an increase not only in critical currents but also an extension of spectral detection efficiencies by just applying an external magnetic field. Using negative electron-beam lithography with the positive resist for shaping nanowires, made it possible to reduce the inner bend radius. Consequently, the effect of critical-current enhancement in the magnetic field becomes stronger than it was demonstrated earlier. Here we achieved a 13% increase of the critical current in the magnetic field. We measured spectra of the single-photon detection efficiency in the wavelength range from 400 to 1100 nm in the magnetic field. At zero field, the square spiral has the spectrum similar to that of a meander. At the field providing the maximum of the critical current, the detection efficiency and the cut-off wavelength in the spectrum increase by 20% and by 54%, correspondingly. The magnetic-field dependence of dark count rate is well described by proposed analytical model.

cond-mat.supr-con↗

arXiv2018

Terahertz Transition-Edge Sensor with Kinetic-Inductance Amplifier at 4.2 K

Different terrestrial terahertz applications would benefit from large-format arrays, operating in compact and inexpensive cryocoolers at liquid helium temperature with sensitivity, limited by the 300-K background radiation only. A voltage-biased Transition-Edge Sensor (TES) as a THz detector can have sufficient sensitivity and has a number of advantages important for real applications as linearity of response, high dynamic range and a simple calibration, however it requires a low-noise current readout. Usually, a current amplifier based on Superconducting Quantum-Interference Device (SQUID) is used for readout, but the scalability of this approach is limited due to complexity of the operation and fabrication. Recently, it has been shown that instead of SQUID it is possible to use a current sensor, which is based on the nonlinearity of the kinetic inductance of a current-carrying superconducting stripe. Embedding the stripe into a microwave high-Q superconducting resonator allows for reaching sufficient current sensitivity. More important, it is possible with the resonator approach to scale up to large arrays using Frequency-Division Multiplexing (FDM) in GHz range. Here, we demonstrate the operation of a voltage-biased TES with a microwave kinetic-inductance current amplifier at 4.2 K. We measured the expected intrinsic Noise-Equivalent Power NEP ~$5\times 10^{-14} \; \rm W/Hz^{1/2}$ and confirmed that a sufficient sensitivity of the readout can be reached in conjunction with a real TES operation. The construction of an array with the improved sensitivity ~ $10^{-15}\; \rm W/Hz^{1/2}$ at 4.2 K could be realized using a combination of the new current amplifier and already existing TES detectors with improved thermal isolation.

physics.ins-det↗

arXiv2017

Physical mechanisms of timing jitter in photon detection by current carrying superconducting nanowires

We studied timing jitter in the appearance of photon counts in meandering nanowires with different fractional amount of bends. Timing jitter, which is the probability density of the random time delay between photon absorption in current-carrying superconducting nanowire and appearance of the normal domain, reveals two different underlying physical scenarios. In the deterministic regime, which is realized at large currents and photon energies, jitter is controlled by position dependent detection threshold in straight parts of meanders and decreases with the current. At small photon energies, jitter increases and its current dependence disappears. In this probabilistic regime jitter is controlled by Poisson process in that magnetic vortices jump randomly across the wire in areas adjacent to the bends.

cond-mat.supr-con↗

arXiv2017

Frequency-Multiplexed bias and readout of a 16-pixel Superconducting Nanowire Single-Photon Detector Array

We demonstrate a 16-pixel array of radio-frequency superconducting nanowire single-photon detectors with an integrated and scalable frequency-division multiplexing architecture, reducing the required bias and readout lines to a single microwave feed line. The electrical behavior of the photon-sensitive nanowires, embedded in a resonant circuit, as well as the optical performance and timing jitter of the single detectors is discussed. Besides the single pixel measurements we also demonstrate the operation of the 16-pixel array with a temporal, spatial and photon-number resolution.

physics.ins-det↗

arXiv2016

Operation of Multi-Pixel Radio-Frequency Superconducting Nanowire Single-Photon Detector Arrays

The concept of the radio-frequency superconducting nanowire single-photon detector (RF-SNSPD) allows frequency-division multiplexing (FDM) of the bias and readout lines of several SNSPDs. Using this method, a multi-pixel array can be operated by only one feed line. Consequently, the system complexity as well as the heat load is significantly reduced. To allocate many pixels into a small bandwidth the quality factor of each device is crucial. In this paper, we present an improved RF-SNSPD design. This new design enables a simple tuning of the quality factor as well as the resonant frequency. With a two-pixel device we have demonstrated the operation without crosstalk between the detectors and showed the time, spatial and photon number resolution. Thereby a single pixel requires only a bandwidth of 14 MHz.

physics.ins-det↗