Searcharxiv⌕ Search

arXiv subjects

Ivan Kasik

Publications and source records attributed to Ivan Kasik.

5 recordsLinked to original sources

Thulium- and Holmium-Doped Silica Fibres for 2 μm High-Power and Highly-Efficient Lasers

Silica optical fibres, originally developed as a low-loss transmission medium for telecommunications, have evolved into a versatile platform for compact and efficient high-power lasers. This review discusses recent progress in thulium- and holmium-doped active fibres emitting within the 2 μm spectral band, with an emphasis on material and waveguide approaches that address power scaling through thermal-load mitigation and enhanced laser efficiency. In particular, the temperature dependence of absorption and emission cross-sections are reviewed, and their implications for spectral gain, amplified spontaneous emission and high-power laser operation are discussed. Structured-core thulium fibres are then considered as a route to combining the high local Tm3+ concentration required for efficient two for- one cross-relaxation with a reduced average dopant concentration, lower longitudinal heat load, and a pedestal-free waveguide design. Finally, recent results on holmium-doped silica fibres prepared by nanoparticle-assisted modified chemical vapour deposition are summarised. Crucially, the Al/Ho ratio is identified as a key compositional parameter governing laser efficiency, while a high absolute alumina content supports a long fluorescence lifetime and enables high Ho3+ concentrations without excessive clustering. These advances have enabled core-pumped holmium fibre lasers with slope efficiencies reaching 84% and output powers approaching 100W. Collectively, these development illustrate how control of spectroscopy, composition, and transverse dopant distribution can extend the performance of silica fibre lasers across the 1.7-2.2 μm spectral region.

physics.optics↗

Structured Ytterbium and Erbium -doped Silica Fiber for Dual Wavelength Laser Operation

We report on a novel type of dual-wavelength fiber laser with a structured-core design inside silica glass, forming a spatial separation of the several core areas doped with ytterbium and erbium ions. We have optimised the key parameters of the fiber core, such as the concentration of rare earth elements, and the optimal length of active fiber to operate simultaneously at two different wavelengths. Using the Modified Chemical Vapor Deposition method to obtain initial optical fiber preforms, and using the stack and draw technique, we have fabricated two types of active fibers, one with 7 and one with 19 rare-earth-doped rods (elements) forming the fiber core. We characterized the drawn fibers by investigating their structure by scanning electron microscopy, confirming the spatial separation of the elements within the core. Measuring absorption shows that concentration ratios Nt Yb: Nt Er were approximately 52: 48 for 7 core fibers and 56:44 for 19 core fibers. Lifetimes for both active fibers were 0.84 ms for Yb3+ ion and 10.30 ms for Er3+ ion. The performance of fiber lasers was determined, proving that fibers are capable of laser emission simultaneously at 1042 nm and 1550 nm. We have shown experimentally that the output power ratio between both lasing wavelengths can be controlled by the length of the fiber.

physics.optics↗

Thulium-doped silica fibers with enhanced 3H4 level lifetime: modelling the devices for 800-820 nm band

Silica-based thulium-doped fiber devices operating around 810 nm would extend the spectral range covered by high- power fiber devices. Using a comprehensive numerical model of the fiber we have shown that efficient lasing at 810 nm can be achieved for specific ranges of the laser cavity parameters in silica-based thulium-doped fibers with enhanced 3H4 lifetime up to 58 \mus as measured in our highly alumina-codoped fibers. We present optimization of the thulium-doped fiber and laser cavity parameters and also potential applications of the developed host material in amplifiers and broadband sources.

physics.optics↗

Preparation and characterization of highly thulium- and alumina-doped optical fibers for single-frequency fiber lasers

Thulium-doped fibers suitable for core-pumped single-frequency lasers were fabricated by the modified chemical vapor deposition (MCVD) method. Refractive index profile, doping profile and spectral absorption was measured. High doping concentration of thulium ions should be achieved to allow for high absorption of light at a pump wavelength while the thulium ions clustering should be avoided to prevent the cooperative upconversion and quenching processes. The fabricated fibers featured pump absorption up to 70dB/m at a pump wavelength of 1611nm. The single-frequency master oscillator with a resonator composed of a pair of fiber Bragg gratings and a thulium-doped fiber was demonstrated with predominantly single ended operation. We achieved a slope efficiency of 22% and a threshold of 22mW at a lasing wavelength of 1944nm.

physics.optics↗

Preparation and Properties of Er-Doped ZrO2 Nanocrystalline Phase-Separated Preforms of Optical Fibers by MCVD Process

The fabrication of Er-doped ZrO2-based nanocrystalline phase-separated silica optical preforms by the MCVD and solution doping techniques is presented. Fabricated preform cores are nearly transparent and contain phase-separated rare-earth doped nanocrystalline particles with diameters mainly in a range from 20 to 80 nm. High concentrations of erbium and aluminium in preform cores of about 0.3 and 14 mol%, respectively have been achieved without defects on the core-cladding interface. Spectral losses in a range 800-1600 nm and fluorescence spectra of erbium ions around 1550 nm measured on a fibre drawn from the preform are reported.

cond-mat.mtrl-sci↗