arXiv subjects

J. Marzec

Publications and source records attributed to J. Marzec.

8 recordsLinked to original sources

arXiv2026

First Observation of an Exotic Reggeon

We present new \compass high-statistics measurements of the peripheral production of $\eta \pi^-$ and $\eta^\prime \pi^-$ pairs in the reactions $\pi^- p \to \eta^{(\prime)}\pi^- p$. For the first time, we perform an unbinned analysis of the high-mass region of the $\eta\pi^-$ and $\eta^\prime\pi^-$ systems, which allows us to disentangle the exchange mechanisms governing their production. We report the first observation in high-energy scattering of an exotic Reggeon with high significance exceeding $5\,\sigma$ for both channels, which is, most likely, related to the exotic $\pi_1(1600)$.8

hep-ex↗

arXiv2025

Spectroscopy of Strange Mesons and First Observation of a Strange Crypto-Exotic State with $J^P=0^-$

We measured the strange-meson spectrum in the scattering reaction $K^{-}+p \rightarrow K^{-}\pi^{-}\pi^{-}+p$ with the COMPASS spectrometer at CERN. Using the world's largest sample of this reaction, we performed a comprehensive partial-wave analysis of the mesonic final state. It substantially extends the strange-meson spectrum covering twelve states with masses up to 2.4 GeV/$c^2$. We observe the first candidate for a crypto-exotic strange meson with $J^{P}=0^{-}$ and find $K_3$ and $K_4$ states consistent with predictions for the ground states.

hep-ex↗

arXiv2025

Assembly, testing, and installation of mPMT photosensor for the Water Cherenkov Test Experiment

The multi-Photomultiplier Tube (mPMT) photosensors will be used in the Water Cherenkov Test Experiment (WCTE) to efficiently detect the photons produced in the whole detector. One of the aims behind the development of WCTE is to test the technology and implement it in future water Cherenkov experiments such as the Hyper-Kamiokande experiment and its Intermediate Water Cherenkov Detector. Each mPMT is built using nineteen 3-inch PMTs arranged on a semi-spherical support matrix. In this paper, we describe the design and manufacture of the mechanical components, the procedures for casting an optical gel between PMTs and acrylic cover, and the overall assembly procedure of the mPMTs. Details of the electronics used in the mPMT modules are not included in this paper and will be presented in a separate publication. We also report on the R&D performed on the selection of the optical gel ratio along with transmittance measurements and the reflectance measurements performed on the aluminium reflector. We also present the optical tests performed on the mPMT module using a 405 nm LED and the resulting increase in the effective photosensitive area by surrounding the PMTs with a reflector. A summary of the production and installation of the mPMTs for the WCTE is also presented in this paper.

physics.ins-det↗

arXiv2014

Letter of Intent to Construct a nuPRISM Detector in the J-PARC Neutrino Beamline

As long-baseline neutrino experiments enter the precision era, the difficulties associated with understanding neutrino interaction cross sections on atomic nuclei are expected to limit experimental sensitivities to oscillation parameters. In particular, the ability to relate experimental observables to neutrino energy in previous experiments has relied solely on theoretical models of neutrino-nucleus interactions, which currently suffer from very large theoretical uncertainties. By observing charged current $ν_μ$ interactions over a continuous range of off-axis angles from 1 to 4 degrees, the nuPRISM water Cherenkov detector can provide a direct measurement of the far detector lepton kinematics for any given set of oscillation parameters, which largely removes neutrino interaction modeling uncertainties from T2K oscillation measurements. This naturally provides a direct constraint on the relationship between lepton kinematics and neutrino energy. In addition, nuPRISM is a sensitive probe of sterile neutrino oscillations with multiple energy spectra, which provides unique constraints on possible background-related explanations of the MiniBooNE anomaly. Finally, high-precision measurements of neutrino cross sections on water are possible, including $ν_e$ measurements and the first ever measurements of neutral current interactions as a function of neutrino energy. The nuPRISM detector also benefits the proposed Hyper-Kamiokande project. A demonstration that neutrino interaction uncertainties can be controlled will be important to understanding the physics reach of Hyper-K. In addition, nuPRISM will provide an easily accessible prototype detector for many of the new hardware components currently under consideration for Hyper-K. The following document presents the configuration, physics impact, and preliminary cost estimates for a nuPRISM detector in the J-PARC neutrino beamline.

physics.ins-det↗

arXiv2012

The T2K Side Muon Range Detector

The T2K experiment is a long baseline neutrino oscillation experiment aiming to observe the appearance of ν e in a νμ beam. The νμ beam is produced at the Japan Proton Accelerator Research Complex (J-PARC), observed with the 295 km distant Super- Kamiokande Detector and monitored by a suite of near detectors at 280m from the proton target. The near detectors include a magnetized off-axis detector (ND280) which measures the un-oscillated neutrino flux and neutrino cross sections. The present paper describes the outermost component of ND280 which is a side muon range detector (SMRD) composed of scintillation counters with embedded wavelength shifting fibers and Multi-Pixel Photon Counter read-out. The components, performance and response of the SMRD are presented.

physics.ins-det↗

arXiv2011

Characterization and Simulation of the Response of Multi Pixel Photon Counters to Low Light Levels

The calorimeter, range detector and active target elements of the T2K near detectors rely on the Hamamatsu Photonics Multi-Pixel Photon Counters (MPPCs) to detect scintillation light produced by charged particles. Detailed measurements of the MPPC gain, afterpulsing, crosstalk, dark noise, and photon detection efficiency for low light levels are reported. In order to account for the impact of the MPPC behavior on T2K physics observables, a simulation program has been developed based on these measurements. The simulation is used to predict the energy resolution of the detector.

physics.ins-det↗

arXiv2010

Moessbauer and magnetic measurements of superconducting LiFeP

The LiFeP sample has been prepared by means of high-temperature solid state reaction. A transition temperature to the superconducting state was found as about 5.5 K by measurements of magnetization versus temperature. The second critical field was found above 1 kOe. Moessbauer spectra of the LiFeP phase are characterized by the quadrupole split doublet having splitting of about 0.10 mm/s at room temperature and 0.12 mm/s at 4.2 K. No magnetic order occurs down to 4.2 K.

cond-mat.supr-con↗

arXiv2009

Scintillator counters with WLS fiber/MPPC readout for the side muon range detector (SMRD)of the T2K experiment

The T2K neutrino experiment at J-PARC uses a set of near detectors to measure the properties of an unoscillated neutrino beam and neutrino interaction cross-sections. One of the sub-detectors of the near-detector complex, the side muon range detector (SMRD), is described in the paper. The detector is designed to help measure the neutrino energy spectrum, to identify background and to calibrate the other detectors. The active elements of the SMRD consist of 0.7 cm thick extruded scintillator slabs inserted into air gaps of the UA1 magnet yokes. The readout of each scintillator slab is provided through a single WLS fiber embedded into a serpentine shaped groove. Two Hamamatsu multi-pixel avalanche photodiodes (MPPC's) are coupled to both ends of the WLS fiber. This design allows us to achieve a high MIP detection efficiency of greater than 99%. A light yield of 25-50 p.e./MIP, a time resolution of about 1 ns and a spatial resolution along the slab better than 10 cm were obtained for the SMRD counters.

physics.ins-det↗