SearcharxivSearch

arXiv subjects

J. Moser

Publications and source records attributed to J. Moser.

At least 19 recordsLinked to original sources

Resolving positive semi-definiteness in physics-informed kernels for scientific machine learning

Many modern machine learning models can be understood as kernel-based function-space models, including Gaussian processes and neural tangent kernels. In scientific machine learning, differential operators are increasingly used to encode physical structure directly into such models. However, it has remained unclear under which conditions these constructions are valid machine learning models, i.e. preserve positive semi-definiteness, and whether observed instabilities arise from ill-posed modeling or numerical effects. Here, we establish a simple and sufficient condition for positive semi-definiteness: for linear differential operators of order m, the base kernel must be m-times continuously differentiable. Crucially, this guarantee holds for operators with non-constant and even discontinuous coefficients. Examples are ubiquitous in physical systems, including diffusion, material elasticity, wave propagation in inhomogeneous media, and quantum systems. We conclude that remaining instabilities are attributable to numerical issues, providing a unifying validity foundation for operator-informed kernel methods.

physics.comp-ph

Switching off energy decay channels in nanomechanical resonators

Energy decay plays a central role in a wide range of phenomena, such as optical emission, nuclear fission, and dissipation in quantum systems. Energy decay is usually described as a system leaking energy irreversibly into an environmental bath. Here, we report on energy decay measurements in nanomechanical systems based on multi-layer graphene that cannot be explained by the paradigm of a system directly coupled to a bath. As the energy of a vibrational mode freely decays, the rate of energy decay switches abruptly to a lower value. This finding can be explained by a model where the measured mode hybridizes with other modes of the resonator at high energy. Below a threshold energy, modes are decoupled, resulting in comparatively low decay rates and giant quality factors exceeding 1 million. Our work opens up new possibilities to manipulate vibrational states, engineer hybrid states with mechanical modes at completely different frequencies, and to study the collective motion of this highly tunable system.

cond-mat.mes-hall

Interplay of driving and frequency noise in the spectra of vibrational systems

We study the spectral effect of the fluctuations of the vibration frequency. Such fluctuations play a major role in nanomechanical and other mesoscopic vibrational systems. We find that, for periodically driven systems, the interplay of the driving and frequency fluctuations results in specific spectral features. We present measurements on a carbon nanotube resonator and show that our theory allows not only the characterization of the frequency fluctuations but also the quantification of the decay rate without ring-down measurements. The results bear on identifying the decoherence of mesoscopic oscillators and on the general problem of resonance fluorescence and light scattering by oscillators.

cond-mat.mes-hall

Symmetry breaking in a mechanical resonator made from a carbon nanotube

Nanotubes behave as semi-flexible polymers in that they can bend by a sizeable amount. When integrating a nanotube in a mechanical resonator, the bending is expected to break the symmetry of the restoring potential. Here we report on a new detection method that allows us to demonstrate such symmetry breaking. The method probes the motion of the nanotube resonator at nearly zero-frequency; this motion is the low-frequency counterpart of the second overtone of resonantly excited vibrations. We find that symmetry breaking leads to the spectral broadening of mechanical resonances, and to an apparent quality factor that drops below 100 at room temperature. The low quality factor at room temperature is a striking feature of nanotube resonators whose origin has remained elusive for many years. Our results shed light on the role played by symmetry breaking in the mechanics of nanotube resonators.

cond-mat.mes-hall

Controlled assembly of graphene sheets and nanotubes: fabrication of suspended multi-element all-carbon vibrational structures

We report on the fabrication and operation of a multi-element vibrational structure consisting of two graphene mechanical resonators coupled by a nanotube beam. The whole structure is suspended. Each graphene resonator is clamped by two metal electrodes. The structure is fabricated using a combination of electron-beam lithography and atomic-force microscopy nano-manipulation. This layout allows us to detect the mechanical vibrations electrically. The measured eigenmodes are localized in either one of the graphene resonators. The coupling due to the nanotube is studied by measuring the shift of the resonance frequency of one graphene resonator as a function of the vibration amplitude of the other resonator. Coupled graphene resonators hold promise for the study of nonlinear dynamics, the manipulation of mechanical states, and quantum non-demolition measurements.

cond-mat.mes-hall

Ultrasensitive force detection with a nanotube mechanical resonator

Since the advent of atomic force microscopy, mechanical resonators have been used to study a wide variety of phenomena, such as the dynamics of individual electron spins, persistent currents in normal metal rings, and the Casimir force. Key to these experiments is the ability to measure weak forces. Here, we report on force sensing experiments with a sensitivity of 12 zN Hz^(-1/2) at a temperature of 1.2 K using a resonator made of a carbon nanotube. An ultra-sensitive method based on cross-correlated electrical noise measurements, in combination with parametric downconversion, is used to detect the low-amplitude vibrations of the nanotube induced by weak forces. The force sensitivity is quantified by applying a known capacitive force. This detection method also allows us to measure the Brownian vibrations of the nanotube down to cryogenic temperatures. Force sensing with nanotube resonators offers new opportunities for detecting and manipulating individual nuclear spins as well as for magnetometry measurements.

cond-mat.mes-hall

High-frequency nanotube mechanical resonators

We report on a simple method to fabricate high-frequency nanotube mechanical resonators reproducibly. We measure resonance frequencies as high as 4.2 GHz for the fundamental eigenmode and 11 GHz for higher order eigenmodes. The high-frequency resonances are achieved using short suspended nanotubes and by introducing tensile stress in the nanotube. These devices allow us to determine the coefficient of the thermal expansion of an individual nanotube, which is negative and is about -0.7E-5 1/K at room temperature. High-frequency resonators made of nanotubes hold promise for mass sensing and experiments in the quantum limit.

cond-mat.mes-hall

Image Analysis for Cosmology: Shape Measurement Challenge Review & Results from the Mapping Dark Matter Challenge

In this paper we present results from the Mapping Dark Matter competition that expressed the weak lensing shape measurement task in its simplest form and as a result attracted over 700 submissions in 2 months and a factor of 3 improvement in shape measurement accuracy on high signal to noise galaxies, over previously published results, and a factor 10 improvement over methods tested on constant shear blind simulations. We also review weak lensing shape measurement challenges, including the Shear TEsting Programmes (STEP1 and STEP2) and the GRavitational lEnsing Accuracy Testing competitions (GREAT08 and GREAT10).

astro-ph.CO

A Mechanical Mass Sensor with Yoctogram Resolution

Nanoelectromechanical systems (NEMS) have generated considerable interest as inertial mass sensors. NEMS resonators have been used to weigh cells, biomolecules, and gas molecules, creating many new possibilities for biological and chemical analysis [1-4]. Recently, NEMS-based mass sensors have been employed as a new tool in surface science in order to study e.g. the phase transitions or the diffusion of adsorbed atoms on nanoscale objects [5-7]. A key point in all these experiments is the ability to resolve small masses. Here we report on mass sensing experiments with a resolution of 1.7 yg (1 yg = 10^-24 g), which corresponds to the mass of one proton, or one hydrogen atom. The resonator is made of a ~150 nm long carbon nanotube resonator vibrating at nearly 2 GHz. The unprecedented level of sensitivity allows us to detect adsorption events of naphthalene molecules (C10H8) and to measure the binding energy of a Xe atom on the nanotube surface (131 meV). These ultrasensitive nanotube resonators offer new opportunities for mass spectrometry, magnetometry, and adsorption experiments.

cond-mat.mes-hall

Dissipative and conservative nonlinearity in carbon nanotube and graphene mechanical resonators

Graphene and carbon nanotubes represent the ultimate size limit of one and two-dimensional nanoelectromechanical resonators. Because of their reduced dimensionality, graphene and carbon nanotubes display unusual mechanical behavior; in particular, their dynamics is highly nonlinear. Here, we review several types of nonlinear behavior in resonators made from nanotubes and graphene. We first discuss an unprecedented scenario where damping is described by a nonlinear force. This scenario is supported by several experimental facts: (i) the quality factor varies with the amplitude of the motion as a power law whose exponent coincides with the value predicted by the nonlinear damping model, (ii) hysteretic behavior (of the motional amplitude as a function of driving frequency) is absent in some of our resonators even for large driving forces, as expected when nonlinear damping forces are large, and (iii) when we quantify the linear damping force (by performing parametric excitation measurements) we find that it is significantly smaller than the nonlinear damping force. We then review parametric excitation measurements, an alternative actuation method which is based on nonlinear dynamics. Finally, we discuss experiments where the mechanical motion is coupled to electron transport through a nanotube. The coupling can be made so strong that the associated force acting on the nanotube becomes highly nonlinear with displacement and velocity. Overall, graphene and nanotube resonators hold promise for future studies on classical and quantum nonlinear dynamics.

cond-mat.mes-hall

Nonlinear damping in mechanical resonators based on graphene and carbon nanotubes

Carbon nanotubes and graphene allow fabricating outstanding nanomechanical resonators. They hold promise for various scientific and technological applications, including sensing of mass, force, and charge, as well as the study of quantum phenomena at the mesoscopic scale. Here, we have discovered that the dynamics of nanotube and graphene resonators is in fact highly exotic. We propose an unprecedented scenario where mechanical dissipation is entirely determined by nonlinear damping. As a striking consequence, the quality factor Q strongly depends on the amplitude of the motion. This scenario is radically different from that of other resonators, whose dissipation is dominated by a linear damping term. We believe that the difference stems from the reduced dimensionality of carbon nanotubes and graphene. Besides, we exploit the nonlinear nature of the damping to improve the figure of merit of nanotube/graphene resonators.

cond-mat.mes-hall

Probing the electron-phonon coupling in ozone-doped graphene by Raman spectroscopy

We have investigated the effects of ozone treatment on graphene by Raman scattering. Sequential ozone short-exposure cycles resulted in increasing the $p$ doping levels as inferred from the blue shift of the 2$D$ and $G$ peak frequencies, without introducing significant disorder. The two-phonon 2$D$ and 2$D'$ Raman peak intensities show a significant decrease, while, on the contrary, the one-phonon G Raman peak intensity remains constant for the whole exposure process. The former reflects the dynamics of the photoexcited electrons (holes) and, specifically, the increase of the electron-electron scattering rate with doping. From the ratio of 2$D$ to 2$D$ intensities, which remains constant with doping, we could extract the ratio of electron-phonon coupling parameters. This ratio is found independent on the number of layers up to ten layers. Moreover, the rate of decrease of 2$D$ and 2$D'$ intensities with doping was found to slowdown inversely proportional to the number of graphene layers, revealing the increase of the electron-electron collision probability.

cond-mat.mes-hall

Magneto-transport in Disordered Graphene: from Weak Localization to Strong Localization

We present a magneto-transport study of graphene samples into which a mild disorder was introduced by exposure to ozone. Unlike the conductivity of pristine graphene, the conductivity of graphene samples exposed to ozone becomes very sensitive to temperature: it decreases by more than 3 orders of magnitude between 100K and 1K. By varying either an external gate voltage or temperature, we continuously tune the transport properties from the weak to the strong localization regime. We show that the transition occurs as the phase coherence length becomes comparable to the localization length. We also highlight the important role of disorder-enhanced electron-electron interaction on the resistivity.

cond-mat.mes-hall

Interaction mediated asymmetries of the quantized Hall effect

Experimental and theoretical investigations on the integer quantized Hall effect in gate defined narrow Hall bars are presented. At low electron mobility the classical (high temperature) Hall resistance line RH(B) cuts through the center of all Hall plateaus. In contrast, for our high mobility samples the intersection point, at even filling factors ν= 2; 4 ..., is clearly shifted towards larger magnetic fields B. This asymmetry is in good agreement with predictions of the screening theory, i. e. taking Coulomb interaction into account. The observed effect is directly related to the formation of incompressible strips in the Hall bar. The spin-split plateau at ν= 1 is found to be almost symmetric regardless of the mobility. We explain this within the so-called effective g-model.

cond-mat.mes-hall

Tunneling anisotropic magnetoresistance in Fe/GaAs/Au junctions: orbital effects

We report experiments on epitaxially grown Fe/GaAs/Au tunnel junctions demonstrating that the tunneling anisotropic magnetoresistance (TAMR) effect can be controlled by a magnetic field. Theoretical modelling shows that the interplay of the orbital effects of a magnetic field and the Dresselhaus spin-orbit coupling in the GaAs barrier leads to an independent contribution to the TAMR effect with uniaxial symmetry, whereas the Bychkov-Rashba spin-orbit coupling does not play a role. The effect is intrinsic to barriers with bulk inversion asymmetry.

cond-mat.mes-hall

The environment of graphene probed by electrostatic force microscopy

We employ electrostatic force microscopy to study the electrostatic environment of graphene sheets prepared with the micro-mechanical exfoliation technique. We detect the electric dipole of residues left from the adhesive tape during graphene preparation, as well as the dipole of water molecules adsorbed on top of graphene. Water molecules form a dipole layer that can generate an electric field as large as 10^9 V/m. We expect that water molecules can significantly modify the electrical properties of graphene devices.

cond-mat.other

Investigations on unconventional aspects in the quantum Hall regime of narrow gate defined channels

We report on theoretical and experimental investigations of the integer quantized Hall effect in narrow channels at various mobilities. The Hall bars are defined electrostatically in two-dimensional electron systems by biasing metal gates on the surfaces of GaAs/AlGaAs heterostructures. In the low mobility regime the classical Hall resistance line is proportional to the magnetic field as measured in the high temperature limit and cuts through the center of each Hall plateau. For high mobility samples we observe in linear response measurements, that this symmetry is broken and the classical Hall line cuts the plateaus not at the center but at higher magnetic fields near the edges of the plateaus. These experimental results confirm the unconventional predictions of a model for the quantum Hall effect taking into account mutual screening of charge carriers within the Hall bar. The theory is based on solving the Poisson and Schrödinger equations in a self-consistent manner.

cond-mat.mes-hall

Donor binding energy and thermally activated persistent photoconductivity in high mobility (001) AlAs quantum wells

A doping series of AlAs (001) quantum wells with Si delta-modulation doping on both sides reveals different dark and post-illumination saturation densities, as well as temperature dependent photoconductivity. The lower dark two-dimensional electron density saturation is explained assuming deep binding energy of Delta_DK = 65.2 meV for Si-donors in the dark. Persistent photoconductivity (PPC) is observed upon illumination, with higher saturation density indicating shallow post-illumination donor binding energy. The photoconductivity is thermally activated, with 4 K illumination requiring post-illumination annealing to T = 30 K to saturate the PPC. Dark and post-illumination doping efficiencies are reported.

cond-mat.mes-hall