arXiv subjects

Jean Le Graët

Publications and source records attributed to Jean Le Graët.

3 recordsLinked to original sources

arXiv2026

Characterization of IBEX LmAPD detectors at CEA for future low-noise NIR astronomy instruments

Future near-infrared (NIR) astronomy missions dedicated to photon-starved science cases, in particular an all-sky astrometric survey extending the legacy of Gaia into the NIR, as identified within the ESA Voyage~2050 programme, require large-format detectors combining sub-electron effective read noise with very low dark current. Linear-mode avalanche photodiodes (LmAPDs) based on HgCdTe meet this need by multiplying the photo-generated charge by an avalanche gain before the readout stage, thereby reducing the relative contribution of the read noise. We report the first electro-optical characterization of an IBEX detector, a $2048\times2048$, \SI{15}{\micro\meter}-pitch HgCdTe LmAPD array developed by Leonardo with the European Space Agency and operated at \SI{80}{\kelvin} on a dedicated bench at CEA-IRFU. We first discuss the central difficulty of characterizing an APD array, the degeneracy between avalanche gain, quantum efficiency (QE), and conversion gain in the measured response, and we then separate the measurements into two categories. Among the quantities that are directly measurable without assumptions, we report a signal-to-noise ratio for a CDS measurement that exceeds that of a Euclid-type H2RG above \SI{8}{\volt} pixel bias under identical low-flux conditions, a photo-response non-uniformity stable at the $\sim$10\% level, and a quantum efficiency-to-excess-noise ratio (QEFR) of \num{0.40} at \SI{10.5}{\volt}. Among the quantities derived under an explicit set of assumptions, we obtain a conversion gain corresponding to a sense-node capacitance of \SI{27}{\femto\farad}, a quantum efficiency of $46\pm12\%$ at \SI{2.5}{\volt}, and an excess noise factor $F=1.15\pm0.14$ at \SI{10.5}{\volt}. These results establish IBEX as a promising European large-format detector for future ultra-low-flux NIR instruments.

astro-ph.IM↗

arXiv2024

Toward a universal characterization methodology for conversion gain measurement of CMOS APS: application to Euclid and SVOM

With the expanding integration of infrared instruments in astronomical missions, accurate per-pixel flux estimation for near-infrared hybrid detectors has become critical to the success of these missions. Based on CPPM's involvement in both SVOM/Colibri and Euclid missions, this study introduces universally applicable methods and framework for characterizing IR hybrid detectors and decorrelating their intrinsic properties. The characterization framework, applied to the ALFA detector and \Euclid's H2RG, not only validates the proposed methods but also points out subtle behaviors inherent to each detector.

astro-ph.IM↗

arXiv2023

CAGIRE: a wide-field NIR imager for the COLIBRI 1.3 meter robotic telescope

The use of high energy transients such as Gamma Ray Bursts (GRBs) as probes of the distant universe relies on the close collaboration between space and ground facilities. In this context, the Sino-French mission SVOM has been designed to combine a space and a ground segment and to make the most of their synergy. On the ground, the 1.3 meter robotic telescope COLIBRI, jointly developed by France and Mexico, will quickly point the sources detected by the space hard X-ray imager ECLAIRs, in order to detect and localise their visible/NIR counterpart and alert large telescopes in minutes. COLIBRI is equipped with two visible cameras, called DDRAGO-blue and DDRAGO-red, and an infrared camera, called CAGIRE, designed for the study of high redshift GRBs candidates. Being a low-noise NIR camera mounted at the focus of an alt-azimutal robotic telescope imposes specific requirements on CAGIRE. We describe here the main characteristics of the camera: its optical, mechanical and electronics architecture, the ALFA detector, and the operation of the camera on the telescope. The instrument description is completed by three sections presenting the calibration strategy, an image simulator incorporating known detector effects, and the automatic reduction software for the ramps acquired by the detector. This paper aims at providing an overview of the instrument before its installation on the telescope.

astro-ph.IM↗