arXiv subjects

Kan Nakatsuji

Publications and source records attributed to Kan Nakatsuji.

6 recordsLinked to original sources

arXiv2020

Twisted bilayer graphene fabricated by direct bonding in a high vacuum

Twisted bilayer graphene (TBG), in which two monolayer graphene are stacked with an in-plane rotation angle, has recently become a hot topic due to unique electronic structures. TBG is normally produced in air by the tear-and-stack method of mechanical exfoliation and transferring graphene flakes, by which a sizable, millimeter-order area, and importantly clean interface between layers are hard to obtain. In this study, we resolved these problems by directly transferring the easy-to-exfoliate CVD-grown graphene on SiC substrate to graphene in a high vacuum without using any transfer assisting medium and observed electronic band modulations due to the strong interlayer coupling.

cond-mat.mtrl-sci↗

arXiv2014

Atomic scale variation of electron tunneling into a Luttinger liquid ? : High resolution scanning tunneling spectroscopy study on Au/Ge(001)

Au-induced atomic wires on the Ge(001) surface were recently claimed to be an ideal 1D metal and their tunneling spectra were analyzed as the manifestation of a Tomonaga-Luttinger liquid (TLL) state. We reinvestigate this system for atomically well-ordered areas of the surface with high resolution scanning tunneling microscopy and spectroscopy (STS). The local density-of-states maps do not provide any evidence of a metallic 1D electron channel along the wires. Moreover, the atomically resolved tunneling spectra near the Fermi energy are dominated by local density-of-states features, deviating qualitatively from the power-law behavior. On the other hand, the defects strongly affect the tunneling spectra near the Fermi level. These results do not support the possibility of a TLL state for this system. An 1D metallic system with well-defined 1D bands and without defects are required for the STS study of a TLL state.

cond-mat.str-el↗

arXiv2012

Graphene nanoribbons on vicinal SiC surfaces by molecular beam epitaxy

We present a new method of producing a densely ordered array of epitaxial graphene nanoribbons (GNRs) using vicinal SiC surfaces as a template, which consist of ordered pairs of (0001) terraces and nanofacets. Controlled selective growth of graphene on approximately 10 nm wide of (0001) terraces with 10 nm spatial intervals allows GNR formation. By selecting the vicinal direction of SiC substrate, [1-100], well-ordered GNRs with predominantly armchair edges are obtained. These structures, the high density GNRs, enable us to observe the electronic structure at K-points by angle-resolved photoemission spectroscopy, showing clear band-gap opening of at least 0.14 eV.

cond-mat.mtrl-sci↗

arXiv2009

Direct mapping of the spin-filtered surface bands of a three-dimensional quantum spin Hall insulator

Spin-polarized band structure of the three-dimensional quantum spin Hall insulator $\rm Bi_{1-x}Sb_{x}$ (x=0.12-0.13) was fully elucidated by spin-polarized angle-resolved photoemission spectroscopy using a high-yield spin polarimeter equipped with a high-resolution electron spectrometer. Between the two time-reversal-invariant points, $\bar{\varGamma}$ and $\bar{M}$, of the (111) surface Brillouin zone, a spin-up band ($Σ_3$ band) was found to cross the Fermi energy only once, providing unambiguous evidence for the strong topological insulator phase. The observed spin-polarized band dispersions determine the "mirror chirality" to be -1, which agrees with the theoretical prediction based on first-principles calculations.

cond-mat.mtrl-sci↗

arXiv2005

Nonlocal Manipulation of Dimer Motion at Ge(001) Clean Surface via Hot Carriers in the Surface States

Nonlocal one-dimensional motions of a topological defect are induced by electron tunneling through the dangling-bond states on the clean Ge(001) surface using scanning tunneling microscopy below 80 K. The direction of the motion depends both on the energy of the carriers in the surface state and on the distance between the defect and the tunneling point. The results are interpreted using an electronic excitation model by hot carriers injected to the surface states. The critical distance of the motion is anisotropic and consistent with the band structure of the surface states.

cond-mat.mtrl-sci↗

arXiv2003

Local and Reversible Change of the Reconstruction on Ge(001) Surface between c(4x2) and p(2x2) by Scanning Tunneling Microscopy

The reconstruction on Ge(001) surface is locally and reversibly changed between c(4x2) and p(2x2) by controlling the bias voltage of a scanning tunneling microscope (STM) at 80K. It is c(4x2) with the sample bias voltage V_b =< -0.7V. This structure can be kept with V_b =< 0.6V. When V_b is higher than 0.8V during the scanning, the structure changes to p(2x2). This structure is then maintained with V_b >= - 0.6V. The observed local change of the reconstruction with hysteresis is ascribed to inelastic scattering during the electron tunneling in the electric field under the STM-tip.

cond-mat.mtrl-sci↗