arXiv subjects

Karen M. Dowling

Publications and source records attributed to Karen M. Dowling.

5 recordsLinked to original sources

arXiv2024

Inverted Pyramid 3-axis Silicon Hall Effect Magnetic Sensor With Offset Cancellation

Microelectronic magnetic sensors are essential in diverse applications, including automotive, industrial, and consumer electronics. Hall-effect devices hold the largest share of the magnetic sensor market, and they are particularly valued for their reliability, low cost and CMOS compatibility. This paper introduces a novel 3-axis Hall-effect sensor element based on an inverted pyramid structure, realized by leveraging MEMS micromachining and CMOS processing. The devices are manufactured by etching the pyramid openings with TMAH and implanting the sloped walls with n-dopants to define the active area. Through the use of various bias-sense detection modes, the device is able to detect both in-plane and out-of-plane magnetic fields within a single compact structure. In addition, the offset can be significantly reduced by one to three orders of magnitude by employing the current-spinning method. The device presented in this work demonstrated high in-plane and out-of-plane current- and voltage-related sensitivities ranging between 64.1 to 198 V A$^{-1}$ T$^{-1}$ and 14.8 to 21.4 mV V$^{-1}$ T$^{-1}$, with crosstalk below 3.7 %. The sensor exhibits a thermal noise floor which corresponds to approximately 0.5 $μ$T/$\sqrt{Hz}$ at 1.31 V supply. This novel Hall-effect sensor represents a promising and simpler alternative to existing state-of-the-art 3-axis magnetic sensors, offering a viable solution for precise and reliable magnetic field sensing in various applications such as position feedback and power monitoring.

physics.ins-det↗

arXiv2019

Temperature Dependence of Sensitivity of 2DEG-Based Hall-Effect Sensors

The magnetic sensitivity of Hall-effect sensors made of InAlN/GaN and AlGaN/GaN heterostructures was measured between room temperature and 576°C. Both devices showed decreasing voltage-scaled magnetic sensitivity at high temperature, declining from 53 to 8.3 mV/V/T for the InAlN/GaN sample and from 89 to 8.5 mV/V/T for the AlGaN/GaN sample, corresponding to the decreasing electron mobility due to scattering effects at elevated temperatures. Alternatively, current-scaled sensitivities remained stable over the temperature range, only varying by 13.1% from the mean of 26.3 V/A/T and 10.5% from the mean of 60.2 V/A/T for the InAlN/GaN and AlGaN/GaN samples respectively. This is due to the minimal temperature dependence of the electron sheet density on the 2-dimensional electron gas (2DEG). Both devices showed consistency in their voltage- and current-scaled sensitivity over multiple temperature cycles as well as nearly full recovery when returned to room temperature after thermal cycling. Additionally, an AlGaN/GaN sample held at 576°C for 12 hours also showed nearly full recovery at room temperature, further suggesting that GaN-based Hall-effect sensors are a good candidate for use in high temperature applications.

physics.ins-det↗

arXiv2019

Significant Phonon Drag Enables High Power Factor in the AlGaN/GaN Two-Dimensional Electron Gas

In typical thermoelectric energy harvesters and sensors, the Seebeck effect is caused by diffusion of electrons or holes in a temperature gradient. However, the Seebeck effect can also have a phonon drag component, due to momentum exchange between charge carriers and lattice phonons, which is more difficult to quantify. Here, we present the first study of phonon drag in the AlGaN/GaN two-dimensional electron gas (2DEG). We find that phonon drag does not contribute significantly to the thermoelectric behavior of devices with ~100 nm GaN thickness, which suppress the phonon mean free path. However, when the thickness is increased to ~1.2 $μ$m, up to 32% (88%) of the Seebeck coefficient at 300 K (50 K) can be attributed to the drag component. In turn, the phonon drag enables state-of-the-art thermoelectric power factor in the thicker GaN film, up to ~40 mW m$^{-1}$ K$^{-2}$ at 50 K. By measuring the thermal conductivity of these AlGaN/GaN films, we show that the magnitude of the phonon drag can increase even when the thermal conductivity decreases. Decoupling of thermal conductivity and Seebeck coefficient could enable important advancements in thermoelectric power conversion with devices based on 2DEGs.

cond-mat.mtrl-sci↗

arXiv2018

Micro-Tesla Offset in Thermally Stable AlGaN/GaN 2DEG Hall-effect Plates using Current Spinning

This letter describes the characterization of a low-offset Hall-effect plate using the AlGaN/GaN two-dimensional electron gas(2DEG). Four-phase current spinning was used to reduce sensor offset voltage to values in the range of 20 nV, which corresponds to a low residual offset of 2.6 micro-Tesla when supplied with low voltages (0.04 to 0.5V). These offsets are 50x smaller than the values previously reported for GaN Hall-effect plates, and it is on par with state-of-the-art silicon Hall-effect plates. In addition, the offset does not exceed 10 micro-Tesla even at higher supply voltage of 2.34V. The sensor also shows stable current-scaled sensitivity over a wide temperature range of -100C to 200C, with temperature drift of -125 ppm/C. This value is 3x better than state-of-the-art Silicon Hall-effect plates. Additionally, the sensor's voltage sensitivity (57 mV/V/T) is also similar. Because of their low offset values, AlGaN/GaN Hall-effect plates are viable candidates for low-field and high temperature magnetic sensing in monolithic GaN systems used in extreme temperature environments such as power inverter, down-well, combustion, and space applications.

physics.app-ph↗

arXiv2018

Effect of Geometry on Sensitivity and Offset of AlGaN/GaN and InAlN/GaN Hall-effect Sensors

The current- and voltage-scaled sensitivities and signal-to-noise ratios (SNR) (with respect to thermal noise) of various octagonal AlGaN/GaN and InAlN/GaN Hall-effect sensors were examined in this work. The effect of metal contact lengths on sensitivity and sensor offset was evaluated. Calculations that take into account the shape of the device show that devices with point-like contacts have the highest current-scaled sensitivity (68.9 V/A/T), while devices with contacts of equal length to their non-contact sides have the highest voltage-scaled sensitivity (86.9 mV/V/T). The sensitivities of the two other devices follow the predicted trends closely. All the devices have offsets less than 20 $μ$T at low supply current operation (< 300 $μ$A) and most remain below 35 $μ$T at higher supply current (up to 1.2 mA). The consistent low offsets across the devices imply that the choice of Hall-effect sensor geometry should mainly depend on whether the device is current-biased or voltage-biased and the frequency at which it will operate. This work demonstrates that GaN Hall-effect sensor performance can be improved by adjusting the geometry of the Hall-effect plate specific to its function (e.g., power electronics, navigation, automotive applications).

physics.ins-det↗