arXiv subjects

Korkut Kaan Tokgöz

Publications and source records attributed to Korkut Kaan Tokgöz.

5 recordsLinked to original sources

arXiv2026

A 188-260 GHz Distributed Frequency Multiplier Achieving 4 dBm Saturated Output Power in 65 nm CMOS

Sub-terahertz (sub-THz) low-phase-noise signal sources commonly employ frequency multiplier chains to extend the operating frequency of lower-frequency oscillators. This paper presents the design and simulations of a wideband, high-output-power frequency multiplier implemented in TSMC 65 nm CMOS technology. The proposed design is based on a distributed frequency multiplier with a quarter-wave transmission line termination at the drain side, where the reflected and forward-traveling waves are constructively combined to enhance the output power. The proposed frequency doubler achieves a minimum conversion loss of 12 dB at an input frequency of 115 GHz with an input power of 12 dBm, resulting in an output power of 0 dBm and 12.6 dB fundamental suppression. For the same input power, the output power remains within 3 dB of its peak value over the 188-260 GHz output frequency range. At 230 GHz, the proposed design achieves a saturated output power of 4 dBm while occupying an area of 0.149 mm^2.

eess.SP↗

arXiv2026

Channel-Aware Behavioral Power Modeling of CMOS OOK Transceivers for Wireless Network-on-Chip Systems

Wireless Network-on-Chip (WNoC) systems enable low-latency communication in many-core platforms through short-range wireless links. However, the power consumption of integrated transceivers (TRXs), dominated by that of the RF front-end circuitry, remains a major challenge. Moreover, the optimal operating frequency is still unclear, as bandwidth, energy efficiency, and technology maturity must be balanced. This work presents a channel-aware behavioral modeling framework to estimate power consumption and identify energy-efficient operating points in non-coherent On-Off Keying (OOK) TRXs over a wide frequency range. The approach leverages survey data from CMOS implementations to derive frequency-dependent power models for key TRX sub-blocks, including the power amplifier (PA), oscillator, mixer, low noise amplifier (LNA), and envelope detector (ED). By incorporating the frequency-dependent channel loss into the TRX power budget, the model captures system-level power trade-offs across operating regimes. The analysis reveals a frequency-dependent shift in power dominance between the transmitter and receiver: oscillator- and ED-dominated regimes at lower frequencies transition to PA- and LNA-dominated behavior at higher frequencies. Furthermore, the energy-per-bit landscape exhibits sweet spots and a model-based global minimum, indicating that optimal operation cannot be achieved by optimizing transmitter or receiver independently. Overall, the proposed framework enables rapid and physically grounded exploration of power scaling with frequency and channel conditions, providing practical guidelines for energy-efficient design of high-frequency wireless links for WNoC systems and beyond.

eess.SP↗

arXiv2026

Homodyne vs. Heterodyne Architectures in Sub-THz Transceivers: A Phase Noise Perspective

This letter examines the impact of oscillator phase noise on sub-terahertz OFDM transceiver architectures, with a focus on the comparison between homodyne and heterodyne designs. Using a Hexa-X compliant phase noise model, we analytically show that heterodyne architectures reduce the total accumulated phase noise variance by distributing frequency translation across lower-frequency oscillators under realistic phase-noise scaling laws, thereby shifting the dominant impairment from inter-carrier interference to common phase error. OFDM simulations at 70 GHz and 140 GHz demonstrate that while homodyne architectures remain competitive at mmWave frequencies, heterodyne designs provide improved robustness to phase noise at higher sub-THz carriers. These results highlight transceiver architecture as a key design lever for relaxing oscillator and phase-locked loop constraints in future sub-THz wireless systems.

eess.SP↗

arXiv2025

On the Performance of ISAC over the D-Band in a Phase-Noise Aware OFDM Systems

Phase noise (PN) is a critical impairment at D-band frequencies (110 to 170 GHz), which are widely investigated as promising candidates for beyond 5G/6G ISAC systems. This paper evaluates OFDM based ISAC sensing performance under realistic oscillator impairments using a hardware-tuned 3GPP PN model at 130 GHz and FFT based radar processing. With a numerology of 480 kHz, results show that PN introduces range RMSE floors of 0.04 to 0.05 m and velocity RMSE floors of 0.12 to 0.18 m/s. Doppler sidelobe metrics also saturate, with PSLR around minus 6 dB and ISLR around minus 4 dB. These findings confirm that range accuracy remains bandwidth limited, while velocity estimation and sidelobe suppression are strongly PN-sensitive. The study highlights the importance of PN-aware waveform and numerology design for sub-THz ISAC and provides insights for future multi-band transceivers. Communication metrics and PN mitigation strategies such as PTRS and CPE tracking are left for future work.

eess.SP↗

arXiv2025

Frequency-Dependent Power Consumption Modeling of CMOS Transmitters for WNoC Architectures

Wireless Network-on-Chip (WNoC) systems, which wirelessly interconnect the chips of a computing system, have been proposed as a complement to existing chip-to-chip wired links. However, their feasibility depends on the availability of custom-designed high-speed, tiny, ultra-efficient transceivers. This represents a challenge due to the tradeoffs between bandwidth, area, and energy efficiency that are found as frequency increases, which suggests that there is an optimal frequency region. To aid in the search for such an optimal design point, this paper presents a behavioral model that quantifies the expected power consumption of oscillators, mixers, and power amplifiers as a function of frequency. The model is built on extensive surveys of the respective sub-blocks, all based on experimental data. By putting together the models of the three sub-blocks, a comprehensive power model is obtained, which will aid in selecting the optimal operating frequency for WNoC systems.

eess.SY↗