SearcharxivSearch

arXiv subjects

L. Gurevich

Publications and source records attributed to L. Gurevich.

6 recordsLinked to original sources

Nanometer-spaced platinum electrodes with calibrated separation

We have fabricated pairs of platinum electrodes with separation between 20 and 3.5 nm. Our technique combines electron beam lithography and chemical electrodeposition. We show that the measurement of the conductance between the two electrodes through the electrolyte provides an accurate and reproducible way to control their separation. We have tested the robustness of the electrodes by applying large voltages across them and by using them to measure the transport properties of Au nano-clusters. Our results show that the technique reliably produces metallic electrodes with a separation that bridges the minimum scale accessible by electron beam lithography with the atomic scale.

cond-mat.mtrl-sci

Detection of quantum noise from mesoscopic devices with an SIS detector

Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90G Hz) using a superconductor-insulator-superconductor tunnel junction as an on-chip spectrum analyzer. By coupling this frequency-resolved noise detector to a quantum device we can measure the high-frequency, non-symmetrized noise as demonstrated for a Josephson junction. The same scheme has been used to detect the current fluctuations arising from coherent charge oscillations in a two-level system, a superconducting charge qubit. A narrow band peak was observed in the spectral noise density at the frequency of the coherent charge oscillations.

cond-mat.dis-nn

Detection of Quantum Noise from an Electrically-Driven Two-Level System

Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90 GHz) using a superconductor-insulator-superconductor tunnel junction as an on-chip spectrum analyser. By coupling this frequency-resolved noise detector to a quantum device we can measure the high-frequency, non-symmetrized noise as demonstrated for a Josephson junction. The same scheme is used to detect the current fluctuations arising from coherent charge oscillations in a two-level system, a superconducting charge qubit. A narrow band peak is observed in the spectral noise density at the frequency of the coherent charge oscillations.

cond-mat.mes-hall

Carbon Nanotubes as Nanoelectromechanical Systems

We theoretically study the interplay between electrical and mechanical properties of suspended, doubly clamped carbon nanotubes in which charging effects dominate. In this geometry, the capacitance between the nanotube and the gate(s) depends on the distance between them. This dependence modifies the usual Coulomb models and we show that it needs to be incorporated to capture the physics of the problem correctly. We find that the tube position changes in discrete steps every time an electron tunnels onto it. Edges of Coulomb diamonds acquire a (small) curvature. We also show that bistability in the tube position occurs and that tunneling of an electron onto the tube drastically modifies the quantized eigenmodes of the tube. Experimental verification of these predictions is possible in suspended tubes of sub-micron length.

cond-mat.mes-hall

Single-electron tunneling in InP nanowires

We report on the fabrication and electrical characterization of field-effect devices based on wire-shaped InP crystals grown from Au catalyst particles by a vapor-liquid-solid process. Our InP wires are n-type doped with diameters in the 40-55 nm range and lengths of several microns. After being deposited on an oxidized Si substrate, wires are contacted individually via e-beam fabricated Ti/Al electrodes. We obtain contact resistances as low as ~10 kOhm, with minor temperature dependence. The distance between the electrodes varies between 0.2 and 2 micron. The electron density in the wires is changed with a back gate. Low-temperature transport measurements show Coulomb-blockade behavior with single-electron charging energies of ~1 meV. We also demonstrate energy quantization resulting from the confinement in the wire.

cond-mat.mes-hall

Scanning Gate Spectroscopy on Nanoclusters

A gated probe for scanning tunnelling microscopy (STM) has been developed. The probe extends normal STM operations by means of an additional electrode fabricated next to the tunnelling tip. The extra electrode does not make contact with the sample and can be used as a gate. We report on the recipe used for fabricating the tunnelling tip and the gate electrode on a silicon nitride cantilever. We demonstrate the functioning of the scanning gate probes by performing single-electron tunnelling spectroscopy on 20-nm gold clusters for different gate voltages.

cond-mat.mes-hall