arXiv subjects

Leonida Antonio Gizzi

Publications and source records attributed to Leonida Antonio Gizzi.

3 recordsLinked to original sources

arXiv2026

Ultrashort Pulse Train Generation on a 100TW Laser Beamline Using a Delay Mask After the Final Focusing Optics

Experimental results aimed at demonstrating the feasibility of a two-section delay mask for the generation of ultrashort pulse trains are reported. Based on the initial simulation results, a 500 um thick circular fused silica plate featuring a central aperture was designed to enable two distinct transverse portions of the incident laser pulse to be focused, ideally, with equal intensity. This fulfills one of the requirements of the resonant multipulse ionization injection (ReMPI) scheme for laser wakefield acceleration. The experiment was carried out at the CNR-INO Intense Laser Irradiation Laboratory using a 240 TW laser system operated at 120 TW, as part of the ongoing preparation for the first experimental demonstration of ReMPI.

physics.plasm-ph↗

arXiv2025

Radionuclide Production for Dose Verification in VHEE FLASH Radiotherapy

This study explores the production of radionuclides in a PMMA (Polymethylmethacrylate) phantom irradiated with Very High Energy Electrons (VHEE) beams as a novel method for dose verification. In this work, Monte Carlo simulation studies using the Geant4 toolkit and experimental measurements with a VHEE beam produced by a laser-plasma accelerator were conducted. Specifically, the photonuclear production of 11C, 15O and 13N is examined, with a detailed analysis of their spatial distribution, production yields and decay time

physics.med-ph↗

arXiv2016

Rise time of proton cut-off energy in 2D and 3D PIC simulations

The Target Normal Sheath Acceleration (TNSA) regime for proton acceleration by laser pulses is experimentally consolidated and fairly well understood. However, uncertainties remain in the analysis of particle-in-cell (PIC) simulation results. The energy spectrum is exponential with a cut-off, but the maximum energy depends on the simulation time, following different laws in two and three dimensional (2D, 3D) PIC simulations, so that the determination of an asymptotic value has some arbitrariness. We propose two empirical laws for rise time of the cut-off energy in 2D and 3D PIC simulations, suggested by a model in which the proton acceleration is due to a surface charge distribution on the target rear side. The kinetic energy of the protons that we obtain follows two distinct laws, which appear to be nicely satisfied by PIC simulations. The laws depend on two parameters: the scaling time, at which the energy starts to rise, and the asymptotic cut-off energy. The values of the cut-off energy, obtained by fitting the 2D and 3D simulations for the same target and laser pulse, are comparable. This suggests that parametric scans can be performed with 2D simulations, since 3D ones are computationally very expensive. In this paper, the simulations are carried out for $a_0=3$ with the PIC code ALaDyn by changing the target thickness $L$ and the incidence angle $α$. A monotonic dependence, on $L$ for normal incidence and on $α$ for fixed $L$, is found, as in the experimental results for high temporal contrast pulses.

physics.plasm-ph↗