Searcharxiv⌕ Search

arXiv subjects

Lingjia Liu

Publications and source records attributed to Lingjia Liu.

75 records · Page 5Linked to original sources

Improving the Coverage and Spectral Efficiency of Millimeter-Wave Cellular Networks using Device-to-Device Relays

The susceptibility of millimeter waveform propagation to blockages limits the coverage of millimeter-wave (mmWave) signals. To overcome blockages, we propose to leverage two-hop device-to-device (D2D) relaying. Using stochastic geometry, we derive expressions for the downlink coverage probability of relay-assisted mmWave cellular networks when the D2D links are implemented in either uplink mmWave or uplink microwave bands. We further investigate the spectral efficiency (SE) improvement in the cellular downlink, and the effect of D2D transmissions on the cellular uplink. For mmWave links, we derive the coverage probability using dominant interferer analysis while accounting for both blockages and beamforming gains. For microwave D2D links, we derive the coverage probability considering both line-of-sight (LOS) and non-line-of-sight (NLOS) propagation. Numerical results show that downlink coverage and SE can be improved using two-hop D2D relaying. Specifically, microwave D2D relays achieve better coverage because D2D connections can be established under NLOS conditions. However, mmWave D2D relays achieve better coverage when the density of interferers is large because blockages eliminate interference from NLOS interferers. The SE on the downlink depends on the relay mode selection strategy, and mmWave D2D relays use a significantly smaller fraction of uplink resources than microwave D2D relays.

cs.ET↗

To Relay or Not to Relay: Learning Device-to-Device Relaying Strategies in Cellular Networks

We consider a cellular network where mobile transceiver devices that are owned by self-interested users are incentivized to cooperate with each other using tokens, which they exchange electronically to "buy" and "sell" downlink relay services, thereby increasing the network's capacity compared to a network that only supports base station-to-device (B2D) communications. We investigate how an individual device in the network can learn its optimal cooperation policy online, which it uses to decide whether or not to provide downlink relay services for other devices in exchange for tokens. We propose a supervised learning algorithm that devices can deploy to learn their optimal cooperation strategies online given their experienced network environment. We then systematically evaluate the learning algorithm in various deployment scenarios. Our simulation results suggest that devices have the greatest incentive to cooperate when the network contains (i) many devices with high energy budgets for relaying, (ii) many highly mobile users (e.g., users in motor vehicles), and (iii) neither too few nor too many tokens. Additionally, within the token system, self-interested devices can effectively learn to cooperate online, and achieve over 20% higher throughput on average than with B2D communications alone, all while selfishly maximizing their own utilities.

cs.GT↗

Cooperative Routing for Wireless Networks using Mutual-Information Accumulation

Cooperation between the nodes of wireless multihop networks can increase communication reliability, reduce energy consumption, and decrease latency. The possible improvements are even greater when nodes perform mutual information accumulation using rateless codes. In this paper, we investigate routing problems in such networks. Given a network, a source, and a destination, our objective is to minimize end-to-end transmission delay under energy and bandwidth constraints. We provide an algorithm that determines which nodes should participate in forwarding the message and what resources (time, energy, bandwidth) should be allocated to each. Our approach factors into two sub-problems, each of which can be solved efficiently. For any transmission order we show that solving for the optimum resource allocation can be formulated as a linear programming problem. We then show that the transmission order can be improved systematically by swapping nodes based on the solution of the linear program. Solving a sequence of linear programs leads to a locally optimal solution in a very efficient manner. In comparison to the proposed cooperative routing solution, it is observed that conventional shortest path multihop routing typically incurs additional delays and energy expenditures on the order of 70%. Our first algorithm is centralized, assuming that routing computations can be done at a central processor with full access to channel state information for the entire system. We also design two distributed routing algorithms that require only local channel state information. We provide simulations showing that for the same networks the distributed algorithms find routes that are only about two to five percent less efficient than the centralized algorithm.

cs.IT↗