arXiv subjects

Martin V. Gustafsson

Publications and source records attributed to Martin V. Gustafsson.

13 recordsLinked to original sources

arXiv2026

Measuring Reactive-Load Impedance with Transmission-Line Resonators Beyond the Perturbative Limit

We develop an analytic framework to extract circuit parameters and loss tangent from superconducting transmission-line resonators terminated by reactive loads, extending analysis beyond the perturbative regime. The formulation yields closed-form relations between resonant frequency, participation ratio, and internal quality factor, removing the need for full-wave simulations. We validate the framework through circuit simulations, finite-element modeling, and experimental measurements of van der Waals parallel-plate capacitors, using it to extract the dielectric constant and loss tangent of hexagonal boron nitride. Statistical analysis across multiple reference resonators, together with multimode self-calibration, demonstrates consistent and reproducible extraction of both capacitance and loss tangent in close agreement with literature values. In addition to parameter extraction, the analytic relations provide practical design guidelines for maximizing energy participation ratio in the load and improving the precision of resonator-based material metrology.

quant-ph↗

arXiv2025

Coherent and compact van der Waals transmon qubits

State-of-the-art superconducting qubits rely on a limited set of thin-film materials. Expanding their materials palette can improve performance, extend operating regimes, and introduce new functionalities, but conventional thin-film fabrication hinders systematic exploration of new material combinations. Van der Waals (vdW) materials offer a highly modular crystalline platform that facilitates such exploration while enabling gate-tunability, higher-temperature operation, and compact qubit geometries. Yet it remains unknown whether a fully vdW superconducting qubit can support quantum coherence and what mechanisms dominate loss at both low and elevated temperatures in such a device. Here we demonstrate quantum-coherent merged-element transmons made entirely from vdW Josephson junctions. These first-generation, fully crystalline qubits achieve microsecond lifetimes in an ultra-compact footprint without external shunt capacitors. Energy relaxation measurements, together with microwave characterization of vdW capacitors, point to dielectric loss as the dominant relaxation channel up to hundreds of millikelvin. These results establish vdW materials as a viable platform for compact superconducting quantum devices.

quant-ph↗

arXiv2025

Crystalline superconductor-semiconductor Josephson junctions for compact superconducting qubits

The narrow bandgap of semiconductors allows for thick, uniform Josephson junction barriers, potentially enabling reproducible, stable, and compact superconducting qubits. We study vertically stacked van der Waals Josephson junctions with semiconducting weak links, whose crystalline structures and clean interfaces offer a promising platform for quantum devices. We observe robust Josephson coupling across 2--12 nm (3--18 atomic layers) of semiconducting WSe$_2$ and, notably, a crossover from proximity- to tunneling-type behavior with increasing weak link thickness. Building on these results, we fabricate a prototype all-crystalline merged-element transmon qubit with transmon frequency and anharmonicity closely matching design parameters. We demonstrate dispersive coupling between this transmon and a microwave resonator, highlighting the potential of crystalline superconductor-semiconductor structures for compact, tailored superconducting quantum devices.

cond-mat.mes-hall↗

arXiv2022

Ultralow voltage, High-speed, and Energy-efficient Cryogenic Electro-Optic Modulator

Photonic integrated circuits (PICs) at cryogenic temperatures enable a wide range of applications in scalable classical and quantum systems for computing and sensing. A promising application of cryogenic PICs is to provide optical interconnects by up-converting signals from electrical to optical domain, allowing massive data-transfer from 4 K superconducting (SC) electronics to room temperature environment. Such a solution is central to overcome the major bottleneck in the scalability of cryogenic systems, which currently rely on bulky copper cables that suffer from limited bandwidth, large heat load, and do not show any scalability path. A key element for realizing a cryogenic-to-room temperature optical interconnect is a high-speed electro-optic (EO) modulator operating at 4 K with operation voltage at mV scale, compatible with SC electronics. Although several cryogenic EO modulators have been demonstrated, their driving voltages are significantly large compared to the mV scale voltage required for SC circuits. Here, we demonstrate a cryogenic modulator with ~10 mV peak-to-peak driving voltage and gigabits/sec data rate, with ultra-low electric and optical energy consumptions of ~10.4 atto-joules/bit and ~213 femto-joules/bit, respectively. We achieve this record performance by designing a compact optical ring resonator modulator in a heterogeneous InP-on-Silicon platform, where we optimize a multi-quantum well layer of InAIGaAs to achieve a strong EO effect at 4 K. Unlike other semiconductors such as silicon, our platform benefits from the high-carrier mobility and minimal free carrier freezing of III-V compounds at low temperatures, with moderate doping level and low loss (intrinsic resonator Q~272,000). These modulators can pave the path for complex cryogenic photonic functionalities and massive data transmission between cryogenic and room-temperature electronics.

physics.optics↗

arXiv2022

Miniaturizing transmon qubits using van der Waals materials

Quantum computers can potentially achieve an exponential speedup versus classical computers on certain computational tasks, as recently demonstrated in systems of superconducting qubits. However, these qubits have large footprints due to their large capacitor electrodes needed to suppress losses by avoiding dielectric materials. This tactic hinders scaling by increasing parasitic coupling among circuit components, degrading individual qubit addressability, and limiting the spatial density of qubits. Here, we take advantage of the unique properties of the van der Waals (vdW) materials to reduce the qubit area by a factor of $>1000$ while preserving the required capacitance without increasing substantial loss. Our qubits combine conventional aluminum-based Josephson junctions with parallel-plate capacitors composed of crystalline layers of superconducting niobium diselenide (NbSe$_2$) and insulating hexagonal-boron nitride (hBN). We measure a vdW transmon $T_1$ relaxation time of 1.06 $μ$s, which demonstrates a path to achieve high-qubit-density quantum processors with long coherence times, and illustrates the broad utility of layered heterostructures in low-loss, high-coherence quantum devices.

quant-ph↗

arXiv2021

Making high-quality quantum microwave devices with van der Waals superconductors

Ultra low-loss microwave materials are crucial for enhancing quantum coherence and scalability of superconducting qubits. Van der Waals (vdW) heterostructure is an attractive platform for quantum devices due to the single-crystal structure of the constituent two-dimensional (2D) layered materials and the lack of dangling bonds at their atomically sharp interfaces. However, new fabrication and characterization techniques are required to determine whether these structures can achieve low loss in the microwave regime. Here we report the fabrication of superconducting microwave resonators using NbSe$_2$ that achieve a quality factor $Q > 10^5$. This value sets an upper bound that corresponds to a resistance of $\leq 192 μΩ$ when considering the additional loss introduced by integrating NbSe$_2$ into a standard transmon circuit. This work demonstrates the compatibility of 2D layered materials with high-quality microwave quantum devices.

cond-mat.supr-con↗

arXiv2021

A low-power integrated magneto-optic modulator on silicon for cryogenic applications

A fundamental challenge of the quantum revolution is to efficiently interface the quantum computing systems operating at cryogenic temperatures with room temperature electronics and media for high data-rate communication. Current approaches to control and readout of such cryogenic computing systems use electrical cables, which prevent scalability due to their large size, heat conduction, and limited bandwidth1. A more viable approach is to use optical fibers which allow high-capacity transmission and thermal isolation. A key component in implementing photonic datalinks is a cryogenic optical modulator for converting data from the electrical to the optical domain at high speed and with low power consumption, while operating at temperatures of 4 K or lower. Cryogenic modulators based on the electro-optic effect have been demonstrated in a variety of material platforms, however they are voltage driven components while superconducting circuits are current based, resulting in a large impedance mismatch. Here, we present the first demonstration of an integrated current-driven modulator based on the magneto-optic effect operating over a wide temperature range that extends down to less than 4 K. The modulator works at data rates up to 2 Gbps with energy consumption below 4 pJ/bit, and we show that this figure can be reduced to less than 40 fJ/bit with optimized design and fabrication. This modulator is a hybrid device, where a current-driven magneto-optically active crystal (cerium substituted yttrium iron garnet, or Ce:YIG) is bonded to a high-quality silicon microring resonator. Because of its potential for extremely low power consumption under cryogenic conditions, the class of magneto-optical modulators demonstrated here has the potential to enable efficient data links in large-scale systems for quantum information processing.

physics.optics↗

arXiv2020

Odd- and even-denominator fractional quantum Hall states in monolayer WSe$_2$

Monolayer (ML) semiconducting transition-metal dichalcogenides (TMDs) represent a unique class of two-dimensional (2D) electron systems. Their atomically thin structure -- just like graphene -- facilitates gate-tunability, while the sizable band gap and strong spin-orbit coupling hold promise for properties beyond graphene. Measurements under large magnetic fields have revealed an unusual LL structure, distinct from other 2D electron systems. However, owing to limited sample quality and poor electrical contact, probing the lowest Landau levels (LLs) has been challenging, and observation of electron correlations within the fractionally filled LLs regime has not been possible. Here, through bulk electronic compressibility measurements, we investigate the LL structure of ML WSe$_2$ in the extreme quantum limit, and observe fractional quantum Hall (FQH) states in the lowest three LLs. The odd-denominator FQH sequences demonstrate a systematic evolution with the LL orbital index, which has not been observed in any other system but is consistent with generic theoretical expectations. In addition, we observe an even-denominator state in the second LL that is expected to host non-Abelian statistics. Our results suggest that the 2D semiconductors can provide an experimental platform that closely resembles idealized theoretical models in the quantum Hall regime.

cond-mat.mes-hall↗

arXiv2020

Development of Quantum InterConnects for Next-Generation Information Technologies

Just as classical information technology rests on a foundation built of interconnected information-processing systems, quantum information technology (QIT) must do the same. A critical component of such systems is the interconnect, a device or process that allows transfer of information between disparate physical media, for example, semiconductor electronics, individual atoms, light pulses in optical fiber, or microwave fields. While interconnects have been well engineered for decades in the realm of classical information technology, quantum interconnects (QuICs) present special challenges, as they must allow the transfer of fragile quantum states between different physical parts or degrees of freedom of the system. The diversity of QIT platforms (superconducting, atomic, solid-state color center, optical, etc.) that will form a quantum internet poses additional challenges. As quantum systems scale to larger size, the quantum interconnect bottleneck is imminent, and is emerging as a grand challenge for QIT. For these reasons, it is the position of the community represented by participants of the NSF workshop on Quantum Interconnects that accelerating QuIC research is crucial for sustained development of a national quantum science and technology program. Given the diversity of QIT platforms, materials used, applications, and infrastructure required, a convergent research program including partnership between academia, industry and national laboratories is required. This document is a summary from a U.S. National Science Foundation supported workshop held on 31 October - 1 November 2019 in Alexandria, VA. Attendees were charged to identify the scientific and community needs, opportunities, and significant challenges for quantum interconnects over the next 2-5 years.

quant-ph↗

arXiv2017

Ambipolar Landau levels and strong band-selective carrier interactions in monolayer WSe$_2$

Monolayers (MLs) of transition metal dichalcogenides (TMDs) exhibit unusual electrical behavior under magnetic fields due to their intrinsic spin-orbit coupling and lack of inversion symmetry. While recent experiments have also identified the critical role of carrier interactions within these materials, a complete mapping of the ambipolar Landau level (LL) sequence has remained elusive. Here, we use single-electron transistors to perform LL spectroscopy in ML WSe$_2$, for the first time providing a comprehensive picture of the electronic structure of a ML TMD for both electrons and holes. We find that the LLs differ notably between the two bands, and follow a unique sequence in the valence band (VB) that is dominated by strong Zeeman effects. The Zeeman splitting in the VB is several times higher than the cyclotron energy, far exceeding the predictions of a single-particle model, and moreover tunes significantly with doping. This implies exceptionally strong many-body interactions, and suggests that ML WSe$_2$ can serve as a host for new correlated-electron phenomena.

cond-mat.mes-hall↗

arXiv2015

Quantum Acoustics with Surface Acoustic Waves

It has recently been demonstrated that surface acoustic waves (SAWs) can interact with superconducting qubits at the quantum level. SAW resonators in the GHz frequency range have also been found to have low loss at temperatures compatible with superconducting quantum circuits. These advances open up new possibilities to use the phonon degree of freedom to carry quantum information. In this paper, we give a description of the basic SAW components needed to develop quantum circuits, where propagating or localized SAW-phonons are used both to study basic physics and to manipulate quantum information. Using phonons instead of photons offers new possibilities which make these quantum acoustic circuits very interesting. We discuss general considerations for SAW experiments at the quantum level and describe experiments both with SAW resonators and with interaction between SAWs and a qubit. We also discuss several potential future developments.

cond-mat.mes-hall↗

arXiv2014

Propagating phonons coupled to an artificial atom

Quantum information can be stored in micromechanical resonators, encoded as quanta of vibration known as phonons. The vibrational motion is then restricted to the stationary eigenmodes of the resonator, which thus serves as local storage for phonons. In contrast, we couple propagating phonons to an artificial atom in the quantum regime, and reproduce findings from quantum optics with sound taking over the role of light. Our results highlight the similarities between phonons and photons, but also point to new opportunities arising from the unique features of quantum mechanical sound. The low propagation speed of phonons should enable new dynamic schemes for processing quantum information, and the short wavelength allows regimes of atomic physics to be explored which cannot be reached in photonic systems.

cond-mat.mes-hall↗

arXiv2013

Thermal properties of charge noise sources

Measurements of the temperature and bias dependence of Single Electron Transistors (SETs) in a dilution refrigerator show that charge noise increases linearly with refrigerator temperature above a voltage-dependent threshold temperature, and that its low temperature saturation is due to SET self-heating. We show further that the two-level fluctuators responsible for charge noise are in strong thermal contact with the electrons in the SET, which can be at a much higher temperature than the substrate. We suggest that the noise is caused by electrons tunneling between the SET metal and nearby potential wells.

cond-mat.mes-hall↗