arXiv subjects

Md Ahsanul Abeed

Publications and source records attributed to Md Ahsanul Abeed.

13 recordsLinked to original sources

arXiv2021

Surface Acoustic Wave induced modulation of tunneling magnetoresistance in magnetic tunnel junctions

We show that a surface acoustic wave (SAW) applied across the terminals of a magnetic tunnel junction (MTJ) decreases both the (time-averaged) parallel and antiparallel resistances of the MTJ, with the latter decreasing much more than the former. This results in a decrease of the tunneling magnetoresistance (TMR) ratio. The coercivities of the free and fixed layer of the MTJ, however, are not affected significantly, suggesting that the SAW does not cause large-angle magnetization rotation in the magnetic layers through the inverse magnetostriction (Villari) effect at the power levels used. This study sheds light on the dynamical behavior of an MTJ under periodic compressive and tensile strain.

cond-mat.mes-hall↗

arXiv2020

Experimental Demonstration of an Extreme Sub-Wavelength Nanomagnetic Acoustic Antenna Actuated by Spin-Orbit Torque from a Heavy Metal Nanostrip

A novel on-chip extreme sub-wavelength "acoustic antenna" whose radiation efficiency is ~50 times larger than the theoretical limit for a resonantly driven antenna is demonstrated. The antenna is composed of magnetostrictive nanomagnets deposited on a piezoelectric substrate. The nanomagnets are partially in contact with a heavy metal (Pt) nanostrip. Passage of alternating current through the nanostrip exerts alternating spin-orbit torque on the nanomagnets and periodically rotates their magnetizations. During the rotation, the magnetostrictive nanomagnets expand and contract, thereby setting up alternating tensile and compressive strain in the piezoelectric substrate underneath. This leads to the generation of a surface acoustic wave in the substrate and makes the nanomagnet assembly act as an acoustic antenna. The measured radiation efficiency of this acoustic antenna at the detected frequency is ~1%, while the wavelength to antenna dimension ratio is ~ 67:1. For a standard antenna driven at acoustic resonance, the efficiency would have been limited to ~ (1/67)^2 = 0.02%. It was possible to beat that limit (by ~50 times) via actuating the antenna not by acoustic resonance, but by using a completely different mechanism involving spin-orbit torque originating from the giant spin Hall effect in Pt.

physics.app-ph↗

arXiv2020

The effect of material defects on resonant spin wave modes in a nanomagnet

We have theoretically studied how resonant spin wave modes in an elliptical nanomagnet are affected by fabrication defects, such as small local thickness variations. Our results indicate that defects of this nature, which can easily result from the fabrication process, or are sometimes deliberately introduced during the fabrication process, will significantly alter the frequencies, magnetic field dependence of the frequencies, and the power and phase profiles of the resonant spin wave modes. They can also spawn new resonant modes and quench existing ones. All this has important ramifications for multi-device circuits based on spin waves, such as phase locked oscillators for neuromorphic computing, where the device-to-device variability caused by defects can be inhibitory.

cond-mat.mes-hall↗

arXiv2019

Error Probability in Magneto-elastic Switching of Non-ideal Nanomagnets with Defects: A Case Study for the Viability of Straintronic Logic and Memory

Magneto-elastic (straintronic) switching of bistable magnetostrictive nanomagnets is an extremely energy-efficient switching methodology for (magnetic) binary switches that has recently attracted widespread attention because of its potential application in ultra-low-power digital computing hardware. Unfortunately, this modality of switching is also error very prone at room temperature. Theoretical studies of switching error probability of magneto-elastic switches have predicted probabilities ranging from 10E-8-10E-3 at room temperature for ideal, defect-free nanomagnets, but experiments with real nanomagnets show a much higher probability that exceeds 0.1 in some cases. The obvious spoilers that can cause this large difference are defects and non-idealities. Here, we have theoretically studied the effect of common defects (that occur during fabrication) on magneto-elastic switching probability in the presence of room-temperature thermal noise. Surprisingly, we found that even small defects increase the switching error probabilities by orders of magnitude. There is usually a critical stress that leads to the lowest error probability and its value increases enormously in the presence of defects. All this could limit or preclude the application of magneto-elastic (straintronic) binary switches in either Boolean logic or memory, despite their excellent energy-efficiency, and restrict them to non-Boolean (e.g. neuromorphic, stochastic) computing applications. We also studied the difference between magneto-elastic switching with a stress pulse of constant amplitude and sinusoidal time-varying amplitude (e.g. due to a surface acoustic wave) and found that the latter method is more reliable and generates lower switching error probabilities in most cases, provided the time variation is reasonably slow.

cond-mat.mes-hall↗

arXiv2019

Simulated annealing with time-varying strain in a dipole-coupled array of magnetostrictive nanomagnets

In a two-dimensional arrangement of closely spaced elliptical nanomagnets with in-plane magnetic anisotropy, whose major axes are aligned along columns and minor axes along rows, dipole coupling will make the magnetic ordering "ferromagnetic" along the columns and "anti-ferromagnetic" along the rows. Noise and other perturbations can drive the system out of this ground state configuration and pin it in a metastable state where the magnetization orientations will not follow this pattern. Internal energy barriers, sufficiently larger than the thermal energy kT, will prevent the system from leaving the metastable state and decaying spontaneously to the ground state. These barriers can be temporarily eroded by globally straining the nanomagnets with time-varying strain if the nanomagnets are magnetostrictive, which will allow the system to return to ground state after strain is removed. This is a hardware emulation of simulated annealing in an interacting many body system. Here, we demonstrate this function experimentally.

cond-mat.mes-hall↗

arXiv2019

A Nanomagnetic Voltage-Tunable Correlation Generator between Two Random Bit Streams for Stochastic Computing

Graphical probabilistic circuit models of stochastic computing are more powerful than the predominant deep learning models, but also have more demanding requirements. For example, they require "programmable stochasticity", e.g. generating two random binary bit streams with tunable amount of correlation between the corresponding bits in the two streams. Electronic implementation of such a system would call for several components leaving a large footprint on a chip and dissipating excessive amount of energy. Here, we show an elegant implementation with just two dipole-coupled magneto-tunneling junctions (MTJ), with magnetostrictive soft layers, fabricated on a piezoelectric film. The resistance states of the two MTJs (high or low) encode the bits in the two streams. The first MTJ is driven to a random resistance state via a current or voltage generating spin transfer torque and/or voltage controlled magnetic anisotropy, while the second MTJ's resistance state is determined solely by dipole coupling with the first. The effect of dipole coupling can be varied with local strain applied to the second MTJ with a local voltage (~0.2 V) and that varies the correlation between the resistance states of the two MTJs and hence between the bits in the two streams (from 0% to 100%). This paradigm can be extended to arbitrary number of bit streams.

cond-mat.mes-hall↗

arXiv2019

A Microwave Oscillator Based on a Single Straintronic Magneto-tunneling Junction

There is growing interest in exploring nanomagnetic devices as potential replacements for electronic devices (e.g. transistors) in digital switching circuits and systems. A special class of nanomagnetic devices are switched with electrically generated mechanical strain leading to electrical control of magnetism. Straintronic magneto-tunneling junctions (s-MTJ) belong to this category. Their soft layers are composed of two-phase multiferroics comprising a magnetostrictive layer elastically coupled to a piezoelectric layer. Here, we show that a single straintronic magneto-tunneling junction with a passive resistor can act as a microwave oscillator whose traditional implementation would have required microwave operational amplifiers, capacitors and resistors. This reduces device footprint and cost, while improving device reliability. This is an analog application of magnetic devices where magnetic interactions (interaction between the shape anisotropy, strain anisotropy, dipolar coupling field and spin transfer torque in the soft layer of the s-MTJ) are exploited to implement an oscillator with reduced footprint.

cond-mat.mes-hall↗

arXiv2019

Low Barrier Nanomagnet Design for Binary Stochastic Neurons: Design Challenges for Real Nanomagnets with Fabrication Defects

Much attention has been focused on the design of low barrier nanomagnets (LBM), whose magnetizations vary randomly in time owing to thermal noise, for use in binary stochastic neurons (BSN) which are hardware accelerators for machine learning. The performance of BSNs depend on two important parameters: the correlation time associated with the random magnetization dynamics in a LBM, and the spin-polarized pinning current which stabilizes the magnetization of a LBM in a chosen direction within a chosen time. Here, we show that common fabrication defects in LBMs make these two parameters unpredictable since they are strongly sensitive to the defects. That makes the design of BSNs with real LBMs very challenging. Unless the LBMs are fabricated with extremely tight control, the BSNs which use them could be unreliable or suffer from poor yield.

cond-mat.mes-hall↗

arXiv2019

Sensitivity of the Power Spectra of Magnetization Fluctuations in Low Barrier Nanomagnets to Barrier Height Modulation and Defects

Nanomagnets with small shape anisotropy energy barriers on the order of the thermal energy have unstable magnetization that fluctuates randomly in time. They have recently emerged as promising hardware platforms for stochastic computing and machine learning because the random magnetization states can be harnessed for probabilistic bits. Here, we have studied how the statistics of the magnetization fluctuations (e.g. the power spectral density) is affected by (i) moderate variations in the barrier height of the nanomagnet and (ii) the presence of structural defects, in order to assess how robust the computing platform is. We found that the power spectral density is relatively insensitive to moderate barrier height change and also relatively insensitive to the presence of small localized defects. However, extended (delocalized) defects, such as thickness variations over a significant fraction of the nanomagnet, affect the power spectral density very noticeably. As a result, small variations in the shape (causing small variations in the barrier height), or small localized defects, are relatively innocuous and tolerable, but significant variation of the nanomagnet thickness is not. Consequently, tight control over the nanomagnet thickness must be maintained for stochastic computing applications.

cond-mat.mes-hall↗

arXiv2018

Hybrid magneto-dynamical modes in a single magnetostrictive nanomagnet on a piezoelectric substrate arising from magneto-elastic modulation of precessional dynamics

Magneto-elastic (or "straintronic") switching has emerged as an extremely energy-efficient mechanism for switching the magnetization of magnetostrictive nanomagnets in magnetic memory, logic and non-Boolean circuits. Here, we investigate the ultrafast magneto-dynamics associated with straintronic switching in a single quasi-elliptical magnetostrictive Co nanomagnet deposited on a piezoelectric PMN-PT substrate using time-resolved magneto-optical Kerr effect (TR-MOKE) measurements. The pulsed laser pump beam in the TR-MOKE plays a dual role: it causes precession of the nanomagnet's magnetization about an applied bias magnetic field and it also generates surface acoustic waves (SAWs) in the piezoelectric substrate that produce periodic strains in the magnetostrictive nanomagnet and modulate the precessional dynamics. This modulation gives rise to intriguing hybrid magneto-dynamical modes in the nanomagnet, with rich spin wave texture. The characteristic frequencies of these modes are 5-15 GHz, indicating that strain can affect magnetization in a magnetostrictive nanomagnet in time scales much smaller than 1 ns (~100 ps). This can enable ~10 GHz-range magneto-elastic nano-oscillators that are actuated by strain instead of a spin-polarized current, as well as ultrafast magneto-electric generation of spin waves for magnonic logic circuits, holograms, etc.

cond-mat.mes-hall↗

arXiv2018

Energy-efficient switching of nanomagnets for computing: Straintronics and other methodologies

The need for increasingly powerful computing hardware has spawned many ideas stipulating, primarily, the replacement of traditional transistors with alternate "switches" that dissipate miniscule amounts of energy when they switch and provide additional functionality that are beneficial for information processing. An interesting idea that has emerged recently is the notion of using two-phase (piezoelectric/magnetostrictive) multiferroic nanomagnets with bistable (or multi-stable) magnetization states to encode digital information (bits), and switching the magnetization between these states with small voltages (that strain the nanomagnets) to carry out digital information processing. The switching delay is ~1 ns and the energy dissipated in the switching operation can be few to tens of aJ, which is comparable to, or smaller than, the energy dissipated in switching a modern-day transistor. Unlike a transistor, a nanomagnet is "non-volatile", so a nanomagnetic processing unit can store the result of a computation locally without refresh cycles, thereby allowing it to double as both logic and memory. These dual-role elements promise new, robust, energy-efficient, high-speed computing and signal processing architectures (usually non-Boolean and often non-von-Neumann) that can be more powerful, architecturally superior (fewer circuit elements needed to implement a given function) and sometimes faster than their traditional transistor-based counterparts. This topical review covers the important advances in computing and information processing with nanomagnets with emphasis on strain-switched multiferroic nanomagnets acting as non-volatile and energy-efficient switches - a field known as "straintronics". It also outlines key challenges in straintronics.

cond-mat.mes-hall↗

arXiv2017

Hybrid straintronics and voltage-controlled-magnetic-anisotropy: Precessional switching of a perpendicular anisotropy magneto-tunneling junction without a magnetic field

We propose an all-electric implementation of a precessionally switched perpendicular magnetic anisotropy magneto-tunneling-junction (p-MTJ) based toggle memory cell where data is written with voltage-controlled-magnetic-anisotropy (VCMA) without requiring an in-plane magnetic field. The soft layer of the MTJ is a two-phase (magnetostrictive/piezoelectric) multiferroic which is electrically stressed to produce an effective in-plane magnetic field around which the magnetization precesses to complete a flip when the VCMA voltage pulse duration and the stress duration are independently adjusted to obtain a high switching probability. A two-terminal energy-efficient cell, that is compatible with crossbar architecture and high cell density, is designed.

cond-mat.mes-hall↗

arXiv2016

Image Processing with Dipole-Coupled Nanomagnets: Noise Suppression and Edge Enhancement Detection

Hardware based image processing offers speed and convenience not found in software-centric approaches. Here, we show theoretically that a two-dimensional periodic array of dipole-coupled elliptical nanomagnets, delineated on a piezoelectric substrate, can act as a dynamical system for specific image processing functions. Each nanomagnet has two stable magnetization states that encode pixel color (black or white). An image containing black and white pixels is first converted to voltage states and then mapped into the magnetization states of a nanomagnet array with magneto-tunneling junctions (MTJs). The same MTJs are employed to read out the processed pixel colors later. Dipole interaction between the nanomagnets implements specific image processing tasks such as noise reduction and edge enhancement detection. These functions are triggered by applying a global strain to the nanomagnets with a voltage dropped across the piezoelectric substrate. An image containing an arbitrary number of black and white pixels can be processed in few nanoseconds with very low energy cost.

cond-mat.dis-nn↗