arXiv subjects

Mustafa Bal

Publications and source records attributed to Mustafa Bal.

23 records · Page 2Linked to original sources

arXiv2018

Kinetic Inductance Traveling Wave Amplifiers For Multiplexed Qubit Readout

We describe a kinetic inductance traveling-wave (KIT) amplifier suitable for superconducting quantum information measurements and characterize its wideband scattering and noise properties. We use mechanical microwave switches to calibrate the four amplifier scattering parameters up to the device input and output connectors at the dilution refrigerator base temperature and a tunable temperature load to characterize the amplifier noise. Finally, we demonstrate the high fidelity simultaneous dispersive readout of two superconducting transmon qubits. The KIT amplifier provides low-noise amplification of both readout tones with readout fidelities of 83% and 89% and negligible effect on qubit lifetime and coherence.

quant-ph↗

arXiv2018

Enhanced Superconducting Transition Temperature in Electroplated Rhenium

We show that electroplated Re films in multilayers with noble metals such as Cu, Au, and Pd have an enhanced superconducting critical temperature relative to previous methods of preparing Re. The dc resistance and magnetic susceptibility indicate a critical temperature of approximately 6 K. Magnetic response as a function of field at 1.8 K demonstrates type-II superconductivity, with an upper critical field on the order of 2.5 T. Critical current densities greater than 10^7 A/m^2 were measured above liquid-helium temperature. Low-loss at radio frequency was obtained below the critical temperature for multilayers deposited onto resonators made with Cu traces on commercial circuit boards. These electroplated superconducting films can be integrated into a wide range of standard components for low-temperature electronics.

cond-mat.supr-con↗

arXiv2018

Electromagnetically induced transparency in circuit QED with nested polariton states

Electromagnetically induced transparency (EIT) is a signature of quantum interference in an atomic three-level system. By driving the dressed cavity-qubit states of a two-dimensional circuit QED system, we generate a set of polariton states in the nesting regime. The lowest three energy levels are utilized to form the $Λ$-type system. EIT is observed and verified by Akaike's information criterion based testing. Negative group velocities up to $-0.52\pm0.09$ km/s are obtained based on the dispersion relation in the EIT transmission spectrum.

quant-ph↗

arXiv2015

Suspended graphene devices with local gate control on an insulating substrate

We present a fabrication process for graphene-based devices where a graphene monolayer is suspended above a local metallic gate placed in a trench. As an example we detail the fabrication steps of a graphene field-effect transistor. The devices are built on a bare high-resistivity silicon substrate. At temperatures of 77~K and below, we observe the field-effect modulation of the graphene resistivity by a voltage applied to the gate. This fabrication approach enables new experiments involving graphene-based superconducting qubits and nano-electromechanical resonators. The method is applicable to other two-dimensional materials.

cond-mat.mes-hall↗

arXiv2013

Ultrasensitive magnetic field detection using a single artificial atom

Efficient detection of magnetic fields is central to many areas of research and has important practical applications ranging from materials science to geomagnetism. High sensitivity detectors are commonly built using direct current-superconducting quantum interference devices (DC-SQUIDs) or atomic systems. Here we use a single artificial atom to implement an ultrahigh sensitivity magnetometer with a size in the micron range. The artificial atom is a superconducting two-level system at low temperatures, operated in a way similar to atomic magnetometry. The high sensitivity results from quantum coherence combined with strong coupling to magnetic field. By employing projective measurements, we obtain a sensitivity of $2.7\, \t{pT}/\sqrt{\t{Hz}}$ at 10 MHz. We discuss feasible improvements that will increase the sensitivity by over one order of magnitude. The intrinsic sensitivity of this method to AC fields in the 100 kHz - 10 MHz range compares favourably with DC-SQUIDs and atomic magnetometers of equivalent spatial resolution. This result illustrates the potential of artificial quantum systems for sensitive detection and related applications.

cond-mat.mes-hall↗